Coleman RANGEVIEW 5 User Manual

0 (0)
Coleman RANGEVIEW 5 User Manual
Fig. 1
Fig. 2
Fig. 6

STITCH LINE

RANGEVIEWTM 5 MODEL 9230-110

Before you begin

Read all instructions before set up.

Select a level campsite clear of rocks, branches, and other hard or sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

Do not set up your tent under trees.

For best results in windy conditions, position end of tent into the wind.

Enlist the help of at least one other person to assist you when it is time to assemble the tent.

Parts and Components

Description

Part Number

Main Poles, Black (2)

9230-1151

Side Poles, Gray (2)

9230-1161

Long, Side-to-Side Pole, Black (1)

9230-1171

Rainfly Pole, Black with Plastic Tips (1)

9230-1181

Rainfly

9230-1191

 

 

To Set Up Tent

1.Unfold tent and spread out on a clean, level surface with the door facing the desired direction. Unzip door.

2. Stretch six corners of tent until floor is taut then hammer stakes through loops to secure. (Fig.1)

3. Assemble all interlocking shockcorded, black and gray tent poles, separate by size and set aside.

4. Insert black & gray poles through sleeves in top of tent as shown. (Fig. 2)

Black Main Poles

(diagonally)

Long, Side-to-Side,

Black Pole

Front Door of tent

Gray Side Poles (front to back)

5. Insert one end of each diagonal

 

black pole into pins in rear corners

 

of tent. (Fig. 3)

 

6. Go to opposite end of each pole

 

and gradually apply pressure to the

Fig. 3

pole forming an arch. Insert the pin

 

into the pole

 

 

 

 

end at the tent

 

 

corners. Repeat

 

 

with remaining

 

 

Gray Side Poles

 

 

and long, Side-

 

 

to-Side Black

 

 

Pole. (Fig. 4)

 

 

 

Fig. 4

 

 

 

 

To Set Up Tent (continued)

7.Attach frame clips along edges of tent to all gray and black frame poles (Fig. 5)

Fig. 5

To Attach Rainfly

1.Open rainfly and lay out flat with seams and small pockets facing up.

2.Insert plastic tip of black rainfly pole into first pocket on rainfly.

(Fig. 6)

3.Insert other plastic tipped end

of rainfly pole into pocket on opposite side of rainfly.

4.Turn rainfly over and drape over tent making sure rainfly pole is centered over the door. (Fig. 7)

NOTE: When positioned properly, seams on rainfly will always align with

poles on tent.

Fig. 7

5.Secure rainfly to tent poles with hook & loop fasteners located on underside of rainfly. (Fig. 8)

Fig. 8

6.Hook clips on elastic loops of rainfly onto rings on all corners of the tent.

(Fig. 9 & 10)

Fig. 9

Fig. 10

(continued on other side)

Loading...
+ 1 hidden pages