CONTENTS
A. BEFORE USING .......................................................................................2
B. SETTING THE TIME .................................................................................3
C. FUNCTIONS OF SOLAR POWERED WATCH ........................................4
Insufficient Charge Warning Function........................................................6
Time Setting Warning Function .................................................................7
D. CARE AND HANDLING DURING CHARGING ........................................8
E: ABOUT THE ENERGY STORAGE CELL .................................................9
F. TIME REQUIRED FOR CHARGING ......................................................10
G. PRECAUTIONS ......................................................................................12
H. SPECIFICATIONS ...................................................................................18
1
English
A. BEFORE USING
This watch is not powered by a conventional battery, but is powered by
converting light to electrical energy.
Before using, be sure to fully charge your watch by exposing it to light.
(See “F. TIME REQUIRED FOR CHARGING”, for charge time reference)
Since it takes time to recharge the watch until it starts running again
once it has stopped, try to make sure the watch is charged everyday.
When the watch has stopped, the watch hands will begin to move when
the watch is charged for about 5 hours in the case of the two-hand model
or about 1 hour in the case of the three-hand model at 3000Lux (under a
fluorescent light at a distance of about 20 cm(8 inch)).
Once fully charged, the watch will continue to run for approximately 5 months in
the case of the three-hand model, and for approximately 2 months in the case of
the two-hand model, without additional charging.
Your watch features an Overcharge Prevention Function so there is no need to
worry about overcharging your watch.
A special energy storage cell is used to store electrical energy. This special cell
does not require replacement and is a clean energy unit that does not contain
any toxic substances.
B. SETTING THE TIME
[Two-Hand Model] [Three-Hand Model]
WSetting the time
1. Pull the crown out to the time setting position (the second hand will stop when
the crown is pulled out in the case of the three-hand model).
2. Turn the crown to set the time.
3. After setting the time, firmly push the crown back in to the normal position.
2 3
Solar cell
Time setting
position
Normal
position
Crown
Normal
position
Time setting
position
Crown
If the charge becomes insufficient, a warning function will be activated that
causes the display to change as shown below.
Refer to the explanations of each function on the following
page for further details.
4
C. FUNCTIONS OF SOLAR POWERED WATCH
5
If insufficiently
charged and
time is set
If insufficient charge continues
Stop
Recharge by exposing to light
Time setting
warning display
If insufficiently
charged
If sufficiently charged and time is set
Normal time
display
Insufficient charge
warning display
If charged
Three-Hand Model
(One second interval
movement)
: Second hand moves
once every second.
Two-Hand Model
(20 second interval
movement)
: Minute hand moves
once every 20 seconds.
Three-Hand Model
(Two second interval
movement)
: Second hand moves
once every two seconds.
Two-Hand Model
(One minute interval
movement)
: Minute hand moves
regularly in three steps
once every minute.
Three-Hand Model
(Irregular two second
interval movement)
: Second hand moves
irregularly once every
two seconds.
Two-Hand Model
(Irregular one minute
interval movement)
: Minute hand moves
irregularly in three steps
once every minute.
WInsufficient Charge Warning Function
In the case of the two-hand model, the minute hand moves by one minute
interval movement, and in the case of the three-hand model, the second hand
moves by two second interval movement to indicate insufficient charging.
Although the watch keeps the correct time when this happens, the watch will
stop after about 5 days in the case of the two-hand model or after about 1 day in
the case of the three-hand model, after the start of one minute interval
movement or two second interval movement.
Recharge the watch by exposing to light. The watch will then begin to run
normally again.
[One minute interval movement] [Two second interval movement]
6 7
1 min.
1 min.
Minute hand
2 sec.
2 sec.
Second hand
WTime Setting Warning Function
Although the watch hands will begin to move when the watch is fully charged
after a complete discharge, the hands will move in an irregular pattern until the
time is set. It is very important to set the time after a recharge.
Irregular Interval Identification
FOR TWO HAND MODELS: the minute hand will move in three steps when the
minute changes, rather than the normal operation.
FOR THREE HAND MODELS: The second hand will move in two second in
increments, rather than the regular one-second increments.
WOvercharge Prevention Function
You can recharge your watch without worry.
Once the special energy storage cell is fully charged, the overcharge prevention
function comes into operation and prevents over-charging of the energy storage
cell.
2 sec.
2 sec.
Second hand
[Irregular one minute interval movement] [Irregular two second interval movement]
1 min.
1 min.
Minute hand
D. CARE AND HANDLING DURING CHARGING
WNotes on use
To maintain optimal performance, be sure to expose your watch to light
regularly.
Please note that if you wear long sleeves, your watch may be hidden from
light and may result in insufficient charging. As such, additional exposure to
light may be necessary. When you take your watch off, be sure to place it in
as bright an area as possible.
WNotes on recharging
Avoid recharging your watch in areas of high temperatures (over about
60°C/140°F), otherwise the sensitive components of the watch may become
damaged.
(e.g.) Incandescent lights generate heat sufficient to damage your watch. Be
sure to keep the watch at least 50cm (20inches) away from the bulb so no
damage occurs. We do not recommend the use of Halogen bulbs for
recharging.
Never place your watch on the dashboard or rear deck of a vehicle as the heat
generated in these areas can damage your watch.
E. ABOUT THE ENERGY STORAGE CELL
Unlike ordinary watches, the special energy storage cell used in your watch
does not
need regular replacement. This is a clean energy cell that will last
the life of the watch.
Caution:
The energy cell should last the life of the watch. Never allow anyone other than
an Authorized Service Center to replace this cell. The movement is designed to
operate with only the original energy storage cell. If an alternate cell is installed,
such as a conventional battery, the battery may become overcharged resulting
in damage to the movement and/or bursting of the cell, which could cause injury
to the user.
8 9
Full recharging time ... Time required to fully charge when the watch has
completely stopped
One-Day Usage ..........Time required to charge the watch sufficient for one-day
use with one-second interval movement or 20 saconds
interval movement..
F. TIME REQUIRED FOR CHARGING
Time required for recharging may vary according to the design of the watch
(color of the dial, etc) and operating environment. The following table will serve
as an approximate reference : (Table of recharging)
10 11
Illuminance
(lux)
500
1000
3000
10000
100000
Environment
inside an ordinary
office
Time required
52 hours
26 hours
8 hours
30 minutes
2 hours
30 minutes
35 minutes
One day
usage
1 hour
10 minutes
40 minutes
12 minutes
4 minutes
2 minutes
Empty to full
360 hours
180 hours
57 hours
20 hours
7 hours
60-70cm (24-28in.) under
a fluorescent light (30W)
20cm (8in.) under a
fluorescent light (30W)
Exterior, cloudy
Exterior, summer,
sunny
From the stop state
to the 20 seconds
movement
Two-hand model
Time required
12 hours
5 hours
30 minutes
2 hours
30 minutes
8 minutes
One day
usage
2 hours
1 hour
20 minutes
7 minutes
3 minutes
Empty to full
160 hours
75 hours
24 hours
9 hours
3 hours
30 minutes
From the stop state
to the one second
movement
Three-hand model
* The recharging time is the
time the watch is
continuously exposed to
direct light.
<Note>
In the case of charging the
watch after it has stopped
completely, charge with the
crown pulled out to the time
setting position. After
charging, push in the crown
to the normal position after
setting the time.
For correct use within the design limits of the watch, confirm the level of waterresistance of your watch, as indicated on the dial and case, and consult the table.
13
G. PRECAUTIONS
CAUTION: Water-resistance performance
There are several types of water-resistant watches, as
shown in the following table.
12
Minor exposure to water
(washing face, rain, etc.)
Indication
No indication
Dial
Case
(case back)
Specifications
The unit "bar" is roughly equal to 1 atmosphere.
Examples of use
WATER RESIST
5 bar
or no indication
WATER RESIST
10/ 20 bar
or no indication
WATER
RESIST(ANT)
WATER
RESIST(ANT)
5 bar
WATER
RESIST(ANT)
10/ 20 bar
Water-resistant to 3
atmospheres
Water-resistant to 5
atmospheres
Water-resistant to
10/ 20 atmospheres
OK
OK
OK
OK
OK
NO
Moderate exposure to
water (washing, kitchen
work, swimming, etc.)
OK
NO
NO
Marine sports (skin
diving)
NO
NO
NO
Scuba diving (with air
tank)
NO
NO
NO
Operation of the crown
with moisture visible
• Water-resistance for daily use (to 3 atmospheres): This type of watch is
water-resistant to minor exposure to water. For example, you may wear the
watch while washing your face; however, it is not designed for use
underwater.
• Upgraded water-resistance for daily use (to 5 atmospheres): This type of
watch is water-resistant to moderate exposure to water. You may wear the
watch while swimming; however, it is not designed for use while skin diving.
• Upgraded water-resistance for daily use (to 10/20 atmospheres): This type of
watch may be used for skin diving; however, it is not designed for scuba or
saturated diving using helium gas.
CAUTION
• Be sure to use the watch with the crown pressed in (normal position). If your
watch has a screw-type crown, be sure to tighten the crown completely.
• Do NOT operate the crown with wet fingers or when the watch is wet. Water
may enter the watch and compromise water-resistance.
• If the watch is used in seawater, rinse with fresh water afterward and wipe
with a dry cloth.
• If moisture has entered the watch, or if the inside of the crystal is fogged up
and does not become clear within a day, immediately take the watch to your
dealer or Citizen Service Center for repair. Leaving the watch in such a state
will allow corrosion to form inside.
• If seawater enters the watch, place the watch in a box or plastic bag and
immediately take it in for repair. Otherwise, pressure inside the watch will
increase, and parts (crystal, crown, buttons, etc.) may come off.
CAUTION: Keep your watch clean.
• Leaving dust and dirt deposited between the case and crown may result in
difficulty in pulling the crown out. Rotate the crown while in its normal
position, from time to time, to loosen dust and dirt and then brush it off.
• Dust and dirt tend to be deposited in gaps in the back of the case or band.
Deposited dust and dirt may cause corrosion and soil your clothing. Clean the
watch occasionally.
Cleaning the Watch
• Use a soft cloth to wipe off dirt, perspiration and water from the case and
crystal .
• Use a soft, dry cloth to wipe off perspiration and dirt from the leather band.
• To clean a metal, plastic, or rubber watchband, wash away dirt with mild soap
and water. Use a soft brush to remove dust and dirt jammed in the gaps in
the metal band. If your watch is not water-resistant, take it to your dealer.
NOTE: Avoid using solvents (thinner, benzine, etc.), as they may mar the finish.
14 15
CAUTION: Operating environment
• Use the watch within the operating-temperature range specified in the
instruction manual.
Using the watch where temperatures are outside the specified range, may
result in deterioration of functions or even stoppage of the watch.
• Do NOT use the watch in places where it is exposed to high temperature,
such as in a sauna.
Doing so may result in a skin burn.
• Do NOT Ieave the watch in a place where it is exposed to high temperature,
such as the glove compartment or dash-board of a car.
Doing so may result in deterioration of the watch, such as deformation of
plastic parts.
• Do NOT place the watch close to a magnet.
Timekeeping will become inaccurate if you place the watch close to magnetic
health equipment such as a magnetic necklace or a magnetic latch of a
refrigerator door or handbag clasp or the earphone of a mobile phone. If this
has occurred, move the watch away from the magnet and reset the time.
• Do NOT place the watch close to household appliances that generate static
electricity.
Timekeeping may become inaccurate if the watch is exposed to strong static
electricity, such as is emitted from a TV screen.
• Do NOT subject the watch to a strong shock such as dropping it onto a hard
floor.
• Avoid using the watch in an environment where it may be exposed to
chemicals or corrosive gases.
If solvents, such as thinner and benzine, or substances containing such
solvents come in contact with the watch, discoloration, melting, cracking, etc.
may result. If the watch comes in contact with mercury used in thermometers,
the case, band or other parts may become discolored.
16 17
H. SPECIFICATIONS
1. Type: Analog Quartz watch
2. Caliber No.: B02S(Two-hand model)/
B03S(Three-hand model)
3. Accuracy: Within ±15sec/month (within a normal
temperature range of +5°C/41°F to
+35°C/ 95°F)
4. Quartz oscillator frequency: 32,768Hz
5. IC: C/ MOS-LSI (1 pc.)
6. Operating temperature range:-10°C/14°F to +60°C/140°F
7. Display features: Time: hour, minute (two-hand model)/hour, minute,
second (three-hand model)
8. Additional features: Insufficient charge warning function
Time setting warning function
9. Continuous operating time: From fully charged to stop:
Approx. 5 months (two-hand model)
Approx. 2 months (three-hand model)
From insufficient charge warning display to stop:
Approx. 5 days (two-hand model)
Approx. 1 day (three-hand model)
10. Power Source: Light converted to electrical energy stored in a
special energy storage cell. (Not user replaceable)
*Specifications are subject to change without prior notice.
18
Loading...