Quick Start Guide
Cisco SPA100 Series Analog Telephone Adapters
SPA112 Two Port Phone Adapter SPA122 ATA with Router
Package Contents
•Analog Telephone Adapter
•Ethernet Cable
•Power Adapter
•Quick Start Guide
•Product CD-ROM
Welcome
Thank you for choosing a Cisco SPA100 Series Analog Telephone Adapter. This product family includes the following models:
•SPA112 Two-Port Phone Adapter: 2 FXS ports and 1 10/100 WAN port.
•SPA122 ATA with Router: 2 FXS ports, 1 10/100 WAN port, 1 10/100 LAN port, and built-in router.
This guide describes how to physically install the equipment and how to get started with the configuration.
1 Before You Begin
Before you begin the installation, make sure that you have the following equipment and services:
•An active Internet account and Voice over IP account
•Ethernet cable to connect to your broadband network device
•Phone to connect to your SPA112/122
•Phone cable to connect your phone
•Optional: Uninterruptible Power Supply (UPS) to provide backup power
2 Product Features
Top Panel
2 |
Cisco SPA100 Series Analog Telephone Adapters |
Feature |
Description |
|
|
|
|
|
|
Steady green—On hook. |
|
|
Slow flashing green—Off hook. |
Phone 1 |
Off—Port not ready. |
|
|
||
Phone 2 |
|
|
|
|
|
|
|
Flashing green—Transmitting or receiving data through |
|
|
the WAN port. |
Internet |
Off—No link. |
|
|
||
|
|
|
|
|
Steady green—System ready, IP address acquired. |
|
|
Slow flashing green—Acquiring IP address. (By default, |
|
|
|
System |
uses DHCP.) |
|
Fast flashing green—Upgrading firmware. |
||
|
|
Off—No power or system can not boot up. |
|
|
|
Back Panel
Feature |
Description |
|
|
Reset |
Using a paperclip or similar object, press this button |
|
briefly to restart the unit. Press and hold for 10 |
|
seconds to restore the factory default settings. |
|
|
Phone 1, |
Connect to an analog phone, using an RJ-11 phone |
Phone 2 (Gray) |
cable. |
Ethernet (Yellow) Can be used to connect to a device on your network, SPA122 Only such as a computer, using an Ethernet cable.
Internet (Blue) |
Connect to a broadband network device (DSL or |
|
cable modem) or a network router, using an Ethernet |
|
cable. |
|
|
Power |
Connect to a power source, using the provided |
|
power adapter. |
Cisco SPA100 Series Analog Telephone Adapters |
3 |
3 Connecting the Equipment
NOTE For wall-mounting instructions, see Mounting the ATA, page 9.
STEP 1 Connect one end of the provided Ethernet cable to the Internet (Blue) port. Connect the other end directly to your broadband network deviceConnect one end of a phone cable to the Phone 1 (Gray) port. Connect the other end to your analog phone or fax machine.
STEP 2 Connect one end of another phone cable to another analog phone or fax machine. Connect the other end to the Phone 2 (Gray) port.
STEP 3 SPA122 Only: Optionally, connect one end of an Ethernet network cable to the ETHERNET (Yellow) port of the ATA. Connect the other end to a device on your network, such as a computer.
STEP 4 Connect the provided power adapter to the Power port.
239795
WAN
4 |
Cisco SPA100 Series Analog Telephone Adapters |
Loading...