Cisco Systems SG100D08PNA User Manual

0 (0)

Quick Start Guide

Cisco Small Business

Cisco SG 100D-08 Unmanaged Gigabit Switch with QoS Quick Start Guide

Package Contents

Cisco SG 100D-08 Unmanaged Switch

Wallmount Kit

Power Adapter

This Quick Start Guide

Welcome

Thank you for choosing the Cisco SG 100D-08 Unmanaged Switch, a Cisco Small Business network communications device.

This guide will familiarize you with the layout of the unmanaged switch and describe how to deploy the device in your network. For additional information, see www.cisco.com/smb.

Network Speed and Auto MDI/MDI-X Detection

All ports support network speed auto-negotiation and auto MDI/MDI-X crossover detection. Network speed auto-negotiation automatically selects the best connection speed and mode (halfor full-duplex) for communicating with attached devices. Auto MDI/MDI-X crossover detection automatically adjusts for the cable type (straight-through or crossover) used to connect the unmanaged switch to other devices.

Green Energy Savings Technology

Green Ethernet Technology saves energy by entering sleep mode on a Cisco SG 100D-08 port while there is no connection or the device connected to that switch port is turned off.

Traffic Prioritization

The Cisco SG 100D-08 delivers Quality of Service (QoS); all received packets are examined for QoS priority encoding. The switch reads the priority level and forwards the packet based on that priority level. For example, during heavy loads voice and video traffic are given priority over data traffic. (The switch is configured to comply with 802.1p, VLAN tagged frames.) This ensures that time-sensitive traffic gets the highest level of service.

Cisco SG100D-08 Unmanaged Gigabit Switch Quick Start Guide

2

1 Before You Begin

Make sure that you have the following equipment:

Tools for installing the hardware

Network cables to connect computers, printers, network storage, IP cameras, or other network devices.

2

Getting to Know the Cisco

SG 100D-08

This section describes the exterior of the unmanaged switch.

Front Panel LEDs

The LEDs are located on the front panel of the switch.

System LED—(Green) This LED lights up and remains lit when the switch is powered on. When the LED is off, nothing is cabled to the port. Or there is a device connected to the port, but there is a problem with the cable or the connected device.

LEDs 1-8—(Green) Each LED lights up when a connection is made through its corresponding port. The LED flashes when the corresponding port is active.

3

Cisco SG100D-08 Unmanaged Gigabit Switch Quick Start Guide

Cisco Systems SG100D08PNA User Manual

Back Panel Ports

The Ethernet ports and the power port are located on the back panel of the unmanaged switch.

Ethernet Port—The unmanaged switch is equipped with auto-sensing, Ethernet (802.3) ports used for wired network communications. Autosensing technology enables each port to automatically detect the speed and duplex settings of the device connected to it, and adjust its speed and duplex settings to match the settings of the connected device. Each Ethernet port accepts an RJ-45 connector.

Side Panels

The security slot is where you can attach a Kensington lock to protect the switch from theft and is located on the right side of the unmanaged switch. The power switch is located on the left side of the unmanaged switch.

Cisco SG100D-08 Unmanaged Gigabit Switch Quick Start Guide

4

Loading...
+ 8 hidden pages