Camden Door Controls CM-1000-31, CM-1000-37, CM-1000-60KA, CM-1000-60KD, CM-1000-7012 Installation Manual

...
0 (0)
Camden Door Controls CM-1000-31, CM-1000-37, CM-1000-60KA, CM-1000-60KD, CM-1000-7012 Installation Manual

CM-1000, 1100, 1200, 2000, 2200

Series Key Switches

Installation Instructions

General Description

Camden key switches are designed to work with most 1”, 1 1/8” or 1 ¼” mortise cylinders, and with different types of cams.

One or two switches may be installed, either momentary and/or maintained (alternating on/off).

Installation

1. The switch (es) provided may be mounted in either the left or the right hole on the back of the faceplate. Thread the octagonal nut (spacer ring) on to the bushing (stem) of the switch before placing the switch in the hole.

2. Insert the switch up through the bottom of the desired hole. Secure the switch in place by screwing the round threaded washer onto the top of the switch.

3. Fit the mortise cylinder through the front of the face plate being sure to align the grooves on the sides of the cylinder with the corresponding “retainers” on

the back of the face plate.

4. Push firmly on the cylinder, until it snaps into place, lying flush in the front of the face plate (aluminum models only). Note that some cylinders may appear not to fit in the face plate. If the

grooves on the side of the cylinder are irregular and do not align with the retainers on the back of the faceplate, use a metal file to file down the retainers slightly.

Note – do not file the retainers off completely as they prevent the cylinder from spinning in the face plate.

5.Thread the brass cylinder lock ring onto the back of the cylinder, and tighten in place.

6.Turn the key in the cylinder, and ensure the cam hits the top of the switch squarely in the center. Adjust the

Weather Resistant Rubber Gasket is included with CM-1000 & CM-2000 Series

switch in the slotted hole until the cam hits in the center. It does not affect operation of the cam if the cylinder rests against the switch, so long as the switch is not fully depressed until activated by a turn of the key. If the cam does not depress the switch, or blocks the switch from resetting, raise or lower the octagon nut located under the switch, as needed. Extra spacers are provided and may be used as required.

Loading...
+ 1 hidden pages