Broan C305, C305RW, C306 User Manual

4 (2)

MODEL C305

MODEL C305RW

MODEL C306

READ AND SAVE THESE INSTRUCTIONS

INSTALLATION

ALL ELECTRICAL WORK MUST BE DONE IN ACCORDANCE WITH LOCAL AND/ OR NATIONAL ELECTRICAL CODE AS APPLICABLE.

TURN OFF POWER AT SERVICE ENTRANCE BEFORE INSTALLING, WIRING, OR SERVICING THIS PRODUCT.

1.Hold chime mechanism against wall and mark four (4) mounting holes.

2.Drill 3/16” holes where marked and tap in wall anchors from parts bag.

3.Bring wiring through access hole(s) in chime mechanism backplate.

4.Loosely attach chime mechanism to wall with screws from parts bag.

5.C306 only. Slide brackets under screw heads.

6.Tighten screws securely.

C306 only

C306 only

DO NOT OIL CHIME PLUNGERS.

Oil will cause them to stick during operation. If plungers fail to operate freely due to accumulation of dust, cooking grease, etc., clean with a non-flammable cleaning solvent which will evaporate, leaving a dry surface.

Broan C305, C305RW, C306 User Manual

INSTALLATION (continued)

6. Connect wires to appropriate terminals.

RECOMMENDED NEW CONSTRUCTION WIRING

Ground

120 Volt AC

 

 

 

 

 

 

Lighted or

 

 

 

 

 

 

Unlighted Buttons

16 VAC

 

 

Front

 

Side

Rear

 

 

 

 

 

 

Transformer

 

 

 

 

 

 

1

2

3

F

S

R

NOT USED

Nine volt batteries not used

- OPTIONAL -

Volume Control

2 or 3 chimes can be connected to a single transformer.

 

 

 

 

 

 

 

2 chimes require

 

 

 

 

 

 

 

transformer

 

 

 

 

 

 

 

Model C909 or

REPLACING EXISTING 2-NOTE CHIME

 

 

 

C907.

Ground

 

 

 

 

 

3 chimes require

 

 

 

 

 

transformer

 

 

 

 

 

 

 

120 Volt AC

 

 

 

 

 

Model C907.

 

 

 

 

 

 

 

Lighted or

 

 

 

 

 

 

 

Unlighted Buttons

 

16 VAC

 

 

Front

Side

 

Rear

 

 

 

 

 

 

 

 

Transformer

 

 

 

 

 

 

 

1

2

3

F

S

R

NOT USED

9V

9V

 

 

 

 

 

 

Requires Two

 

 

 

 

 

 

9 Volt Batteries

 

 

 

 

 

 

 

Volume Control

 

 

 

 

 

7. Install two (2) alkaline 9-volt batteries, if appropriate for your application. Turn on power at service entrance. Make sure pushbuttons operate chime properly. (Adjust switch on circuit board for 4 or 8 chime tones at front door. Side and rear doors will have 1 chime tone each.)

8. Hook cover over chime mechanism.

2

Loading...
+ 2 hidden pages