Boss Audio BV9341 User Manual
Content
Accessories
Unit Installation
Wire Connection
Parking Brake Connection
Speaker connection
Button Description
Remote Control
Main Menu
Radio Operation
DVD
Operation
USB
/SD
Operation
Settings Operation
Aux in
Operation
Notes of Disc
Troubleshooting
General Specification
………………………………………………………………………………………………………………………………………...02
………………………………………………………………………………………………………………………………..03
………………………………………………………………………………………………………………………………03
………………………………………………………………………………………………………04
……………………………………………………………………………………………………………………….05
………………………………………………………………………………………………………………………….06
………………………………………………………………………………………………………………………………..07
…………………………………………………………………………………………………………………………………………...10
……………………………………………………………………………………………………………………………….10
………………………………………………………………………………………………………………………………..11
………………………………………………………………………………………………………………………..12
………………………………………………………………………………………………………………………..12
…………………………………………………………………………………………………………………………….15
……………………………………………………………………………………………………………………………………...16
……………………………………………………………………………………………………………………………..17
To ensure safety while driving and to comply with laws, drivers should
not watch video or operate the video device while driving.
…………………………………………………………………………………………………………………..19
01
User Manual
Remote Control
Accessories
Package contains the following accessories for installation and operation of the unit.
(1) Washer,
Spring
Washer,
M5 Nut
1
(5) Rubber
Cushion
1
(2) Screw
(3) Bolt 1
(4) Mounting
Strap
1
1
Power Cable Trim Ring
(6) Screw
(7)installation
bracket
8
1 Left
1 Right
02
2
1
Unit Installation
Bracket
Screw
1. Put the 2 brackets to the left and right side of the unit;
2. Use screws to fix the brackets to the unit.
Wire Connection
The Description of the Input/output Interface
03
Parking Brake Connection
1. In order for videos to be viewed, and to comply with federal and local laws, the parking brake wire
must be connected to the power side of the parking brake switch.
Connecting the reversing line to taillight on the car
04
Speaker Connection
After connecting, when you start up the reverse gear, the unit will receive the picture from car rear
view camera.
Note:
- Use only with 4-8 ohm, non-chassis grounded speakers
- Always observe correct polarity
- Loudspeaker cables and/or optional external power amplifiers must always be about 11.8 inch
away from the antenna and/or antenna extension parts.
Connect the speakers according the following diagram, incorrect connections will damage the unit or
your loudspeakers.
Correct connection
Left front - Right front | Left rear - Right rear
Incorrect connections
05
Button Description
1. IR Sensor
IR Remote control signal receiving window. Max distance is 6-8 meters, 45 angels.
2. RST
Press it with a thin, sharp object, the device will then be reset to factory default settings.
3. MODE BUTTON
Press mode button to change mode.
4. BAND BUTTON
Press band button to band of FM and AM.
5. MENU BUTTON
Press menu button to return back to main menu.
6. POWER / MUTE Button /VOL
Press it to turn on the unit. Press and hold for 2 seconds to turn the unit off .Press the button.
briefly to mute .Please notes that the volume will be muted on all audio output connector.
Press VOL knob to power on unit, and Press and hold for 2 seconds to turn the unit off
Rotate VOL knob to increase or reduce the volume.
7. SD/MMC CARD Slot
SD/MMC card slot, for Multimedia playback files only. Insert a SD/MMC CARD into this slot and the unit
will automatically start reading and playback. * Supported Music File Format:MP3, WMA files.
8. USB Slot
USB slot for Multimedia playback files only. insert a USB into this slot and the unit will automatically
start reading and playback. * Supported Music File Format: MP3, WMA files.
9. AUX-IN Jack
Put the Aux plug into the AUX-IN jack which was marked on front panel.
10. DISC Slot
11. Info Display
LCD display Information when operation the unit.
12. EJECT Button
Press to eject a disc. If the disc is not removed for about 10 seconds after eject, the disc is reinserted
automatically.
06
Loading...