PB10
PB10
PB10-CD
Operating/Safety Instructions
Consignes de fonctionnement/sécurité
Instrucciones de funcionamiento y seguridad
Consumer Information
Renseignements pour les consommateurs
Información para el consumidor
Toll Free Number: Appel gratuit : Número de teléfono gratuito:
1-877-BOSCH99 (1-877-267-2499) http://www.boschtools.com
IMPORTANT: IMPORTANT : IMPORTANTE:
Read Before Using Lire avant usage Leer antes de usar
2
IMPORTANT SAFETY INSTRUCTIONS
WARNING
- TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR
OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
- TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO REDUCE THE RISK
OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO
USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The lighting flash with arrowhead
symbol within an equilateral
triangle is intended to alert the user
to the presence of uninsulated
“dangerous voltage” within the
product’s enclosure that may be of
sufficient magnitude to constitute a
risk of electric to persons.
CAUTION:
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and
maintenance (servicing)
instructions in the literature
accompanying the product.
1. All the safety and operating instructions should be read before the product is operated.
2. The safety and operating instructions should be retained for future reference.
3. All warnings on the appliance and in the operating instructions should be adhered to.
4. All operating and use instructions should be followed.
5. Do not use this appliance near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instruction.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other appliances (including
amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized type plug has two blades
with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or
the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
Caution: To prevent electrical shock, match wide blade plug to wide slot so as to be fully inserted.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11.Only use attachments/accessories specified by the manufacturer.
12. Unplug this apparatus during lighting storms or when unused for long periods of time.
13. Refer all servicing to qualified service personal. Servicing is required when the apparatus has been damaged in
any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or as been dropped.
This appliance shall not be exposed to dripping or splashing water and that no object filled with liquids such as
vases shall be placed on the apparatus.
3
Table of Contents
Safety ...................................................................................2-3
Important Safety Instructions ..............................................2
Table of Contents ..................................................................
3
FCC Information..................................................................3
Battery/Charger...................................................................4
Battery Care
........................................................................4
Battery Disposal ..................................................................4
Functional Description and Specifications........................5
PB10 Controls
.....................................................................6
PB10-CD Controls ..............................................................7
LCD Displays.......................................................................8
Setting the Clock .................................................................8
Operating Instructions.....................................................8-12
Radio ...................................................................................8
CD Player ............................................................................9
Aux Function .......................................................................9
Audio Settings................................................................9-10
Releasing and Inserting the Battery Pack........................
10
Charging the Battery Pack................................................10
Important Charging Notes.................................................11
To Power the Unit................................................................
11
Use of GFCI (Ground Fault Circuit Interruptor)................11
Use of GFCI ......................................................................11
GFCI Testing Procedure
...................................................11
Use of 12V Outlet..............................................................12
Changing Fuse..................................................................12
Trouble Shooting.................................................................12
Maintenance ........................................................................13
Accessories..........................................................................13
Page Page
FCC Information
This device complies with Part 15 of the FCC Rules.
Operation is subjected to the following two conditions:
(1). This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
CLASS 1 LASER PRODUCT CAUTION INVISIBLE LASER
RADIATION WHEN OPEN AND
INTERLOCKS DEFEATED.
AVOID EXPOSURE TO BEAM
This product contains a low power Laser Device.
CLASS 1 LASER PRODUCT
4
Battery/Charger Rules
Before using battery charger, read all instructions and
cautionary markings on (1) battery charger, (2) battery
pack, and (3) product using battery.
Use only the charger which accompanied your product
or direct replacement as listed in the catalog or this
manual.
Do not disassemble radio unit or operate the radio unit if
it has received a sharp blow, been dropped or otherwise
damaged in any way. Replace damaged cord or plugs
immediately.
Incorrect reassembly or damage may result in
electric shock or fire.
Do not recharge battery in damp or wet environment. Do
not expose radio unit to rain or snow. If battery case is
cracked or otherwise damaged, do not insert into
charger.
Battery short or fire may result.
Charge only Bosch approved rechargeable batteries. See
Functional Description and Specifications. Other types of
batteries may burst causing personal injury and damage.
Charge battery pack in temperatures above +40 degrees
F (4 degrees C) and below +105 degrees F (41 degrees
C). Store radio unit and battery pack in locations where
temperatures will not exceed 120 degrees F (49 degrees
C).
This is important to prevent serious damage to the
battery cells.
Battery leakage may occur under extreme usage or
temperature conditions. Avoid contact with skin and
eyes.
The battery liquid is caustic and could cause chemical
burns to tissues. If liquid comes in contact with skin, wash
quickly with soap and water, then with lemon juice or
vinegar. If the liquid contacts your eyes, flush them with
water for a minimum of 10 minutes and seek medical
attention.
Place radio unit on flat non-flammable surfaces and
away from flammable materials when re-charging
battery pack.
The charger and battery pack heat during
charging. Carpeting and other heat insulating surfaces block
proper air circulation which may cause overheating of the
charger and battery pack. If smoke or melting of the case
are observed unplug the charger immediately and do not
use the battery pack or charger.
Use of an attachment not recommended or sold by
Bosch may result in a risk of fire, electric shock or injury
to persons.
When batteries are not in tool or
charger, keep them away from metal
objects.
For example, to protect terminals from shorting DO
NOT
place batteries in a tool box or pocket with nails,
screws, keys, etc. Fire or injury may result.
To prevent fire or injury when batteries
are not in tool or charger, always place
protective cap onto end of battery pack.
Protective cap,
guards against terminal shorting.
DO NOT PUT BATTERIES INTO FIRE OR EXPOSE TO
HIGH HEAT.
They may explode.
Battery Care
Battery Disposal
Do not attempt to disassemble the
battery or remove any component
projecting from the battery terminals.
Fire or injury may
result. Prior to disposal, protect exposed terminals with
heavy insulating tape to prevent shorting.
Nickel-Cadmium Batteries
If equipped with a nickel-cadmium battery, the battery must
be collected, recycled or disposed of in an environmentally
sound manner.
“The EPA certified RBRC Battery Recycling
Seal on the nickel-cadmium (Ni-Cd) battery
indicates Robert Bosch Tool Corporation is
voluntarily participating in an industry
program to collect and recycle these batteries
at the end of their useful life, when taken out
of service in the United States or Canada. The RBRC
program provides a convenient alterative to placing used Ni-
Cd batteries into the trash or the municipal waste stream,
which may be illegal in your area.
Please call 1-800-8-BATTERY for information on Ni-Cd
battery recycling and disposal bans/restrictions in your area,
or return your batteries to a Skil/Bosch/Dremel Service
Center for recycling. Robert Bosch Tool Corporation’s
involvement in this program is part of our commitment to
preserving our environment and conserving our natural
resources.”
Nickel-Metal Hydride Batteries
If equipped with a nickel-metal hydride battery, the battery
can be disposed of in a municipal solid waste stream.
WARNIN
G
!
WARNIN
G
!
WARNIN
G
!
5
Functional Description and Specifications
Jobsite Radio with 4-way GFCI outlet
Model number
PB10 PB10-CD
Voltage rating 120 V 60 Hz 120 V 60 Hz
Amperes
12 A
12 A
Compatible batteries BAT025-045 BAT025-045
GFCI outlets
Voltage 120 V 60 Hz 120 V 60 Hz
Amperes 10 A 10 A
DC power outlets
Voltage 12 V 12V
Amperes 1 Amp fuse 1 Amp fuse
Radio AM 520-1710KHZ
AM 520-1710KHZ
FM 87.9-107.9MHZ FM 87.9-107.9MHZ
CD N/A CD/CDR/MP3 Compatible
Memory AM 10-presets
AM 10-presets
FM 20-presets FM-20presets
CARRY
HANDLE
CONTROL
PANEL
SPEAKERS
CORD
WRAP
ROLL
CAGE
POWER
CORD
12V DC
FUSE
12V DC
OUTLET
CHARGER/BATTERY
BAY
4-WAY GFCI
POWER OUTLET
CHARGER
INDICATOR
DIGITAL
CLOCK
AUXILIARY
INPUT
LOCATION OF
AAA BATTERIES
Loading...