Fire Alarm Systems | G SSPK24WLP Series Wall mount Speaker Strobes
G SSPK24WLP Series Wall mount Speaker
Strobes
High quality dB output
Frequency range of 400 Hz to 4000 Hz
Screw terminals; separate In and Out wiring 18 AWG
(1.2 mm) to 12 AWG (2.3 mm)
Field selectable power taps: 1/8 W, 1/4 W, 1/2 W, 1 W,
2 W, 4 W
Speaker voltage 25 VRMS or 70.7 VRMS standard; field selectable
Tamperproof grill
Flush mounts to a standard 4 inch square by 2.125 in. deep back box
The G SSPKWLP Low profile Wall mount Series Speaker Strobes are designed to meet code requirements for audio, visual, and voice communications. This series provides quality speaker products that offer dependable evacuation signaling and visual alarms, or a combination of both. They provide a 25 VRMS or 70.7 VRMS speaker with field selectable power taps of 1/8 W, 1/4 W, 1/2 W, 1 W, 2 W, or 4 W.
The G SSPK24 15/75WLP Fixed-candela Speaker Strobe models are UL Listed at 15 cd, but provide 75 cd on axis. The multi-candela strobe models (G SSPK24WLP) can be set for 15 cd, 30 cd, 60 cd, 75 cd, or 110 cd. The strobes maintain a constant flash rate of 1 Hz regardless of input voltage. The strobes can be synchronized by using the AVSM Synchronization Module, or by Fire Alarm Control Panels (FACPs) or power supplies that include the Gentex sync protocol.
Note Gentex Corporation holds the Listings and Approvals.
Region |
Certification |
|
USA |
UL |
UUKC: Signaling Appliances and |
|
|
Equipment for the Hearing Impaired (ANSI/ |
|
|
UL 1971), UUMW: Speakers and |
|
|
Amplifiers for Fire Protective Signaling |
|
|
Systems (UL1480) |
|
CSFM |
7320-0569: 140 |
|
NYC-MEA |
580-06-E, Vol. 3 |
|
ADA |
Complies with Americans with Disabilities |
|
|
Act |
|
NFPA |
Complies with National Fire Protection As- |
|
|
sociation NFPA 72 |
Mounting Considerations
The G SSPKWLP Series Speaker Strobes are for indoor installation only. Mount them on interior walls or other hard surfaces where they are protected from weather elements such as rain or snow. The units flush mount on a standard 4 inch square by 2.125 inch deep back box.
Wiring Considerations
Note Do not use these strobe units in coded or pulsed signaling circuits.
Wire Diameter:
www.boschsecurity.com