LHC201A
LHC202A
Pure Networking™ Fast Ethernet Media Converters
Link a 10/100BASE-TX segment to a 100BASE-FX segment on your network, and extend the 328 foot (100 m) distance limit of copper-based Ethernet.
Customer Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S.
Support call 724-746-5500) • FREE technical support 24 hours a day, 7 days Information a week: Call 724-746-5500 or fax 724-746-0746 • Mailing address:
Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 Web site: www.blackbox.com • E-mail: info@blackbox.com
Trademarks Used in this Manual
Trademarks Used in this Manual
Black Box and the Double Diamond logo are registered trademarks of BB Technologies, Inc.
Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners.
Page 2 |
724-746-5500 | blackbox.com |
FCC and IC RFI Statements
FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS
Class B Digital Device. This equipment has been tested and found to comply with the limits for a Class B computing device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or telephone reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult an experienced radio/TV technician for help.
Caution:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
To meet FCC requirements, shielded cables and power cords are required to connect this device to a personal computer or other Class B certified device.
This digital apparatus does not exceed the Class B limits for radio noise emission from digital apparatus set out in the Radio Interference Regulation of Industry Canada.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de classe B prescrites dans le Règlement sur le brouillage radioélectrique publié par Industrie Canada.
724-746-5500 | blackbox.com |
Page 3 |
NOM Statement
Normas Oficiales Mexicanas (NOM)
Electrical Safety Statement
INSTRUCCIONES DE SEGURIDAD
1.Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el aparato eléctrico sea operado.
2.Las instrucciones de seguridad y operación deberán ser guardadas para referencia futura.
3.Todas las advertencias en el aparato eléctrico y en sus instrucciones de operación deben ser respetadas.
4.Todas las instrucciones de operación y uso deben ser seguidas.
5.El aparato eléctrico no deberá ser usado cerca del agua—por ejemplo, cerca de la tina de baño, lavabo, sótano mojado o cerca de una alberca, etc.
6.El aparato eléctrico debe ser usado únicamente con carritos o pedestales que sean recomendados por el fabricante.
7.El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante.
8.Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo descrito en las instrucciones de operación. Todo otro servicio deberá ser referido a personal de servicio calificado.
9.El aparato eléctrico debe ser situado de tal manera que su posición no interfiera su uso. La colocación del aparato eléctrico sobre una cama, sofá, alfombra o superficie similar puede bloquea la ventilación, no se debe colocar en libreros o gabinetes que impidan el flujo de aire por los orificios de ventilación.
10.El equipo eléctrico deber ser situado fuera del alcance de fuentes de calor como radiadores, registros de calor, estufas u otros aparatos (incluyendo amplificadores) que producen calor.
11.El aparato eléctrico deberá ser connectado a una fuente de poder sólo del tipo descrito en el instructivo de operación, o como se indique en el aparato.
Page 4 |
724-746-5500 | blackbox.com |
NOM Statement
12.Precaución debe ser tomada de tal manera que la tierra fisica y la polarización del equipo no sea eliminada.
13.Los cables de la fuente de poder deben ser guiados de tal manera que no sean pisados ni pellizcados por objetos colocados sobre o contra ellos, poniendo particular atención a los contactos y receptáculos donde salen del aparato.
14.El equipo eléctrico debe ser limpiado únicamente de acuerdo a las recomendaciones del fabricante.
15.En caso de existir, una antena externa deberá ser localizada lejos de las lineas de energia.
16.El cable de corriente deberá ser desconectado del cuando el equipo no sea usado por un largo periodo de tiempo.
17.Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación.
18.Servicio por personal calificado deberá ser provisto cuando:
A:El cable de poder o el contacto ha sido dañado; u
B:Objectos han caído o líquido ha sido derramado dentro del aparato; o
C:El aparato ha sido expuesto a la lluvia; o
D:El aparato parece no operar normalmente o muestra un cambio en su desempeño; o
E:El aparato ha sido tirado o su cubierta ha sido dañada.
724-746-5500 | blackbox.com |
Page 5 |
Table of Contents
Table of Contents
1. |
Specifications.............................................................................................. |
7 |
|
2. |
Overview..................................................................................................... |
8 |
|
|
2.1 |
Introduction..................................................................................... |
8 |
|
2.2 |
Features........................................................................................... |
8 |
|
2.3 |
What’s Included.............................................................................. |
8 |
|
2.4 |
Connectors and Network Cables Supported.................................. |
9 |
|
2.5 |
Hardware Description..................................................................... |
9 |
|
|
2.5.1 LHC201A............................................................................... |
9 |
|
|
2.5.2 LHC202A............................................................................ |
11 |
3. |
Configuration............................................................................................ |
13 |
|
4. |
Installation................................................................................................. |
15 |
|
|
4.1 |
Typical Installation......................................................................... |
15 |
|
4.2 |
Installation Procedure.................................................................... |
15 |
5. |
Operation.................................................................................................. |
17 |
|
|
5.1 |
LEDs on the Media Converter....................................................... |
17 |
|
5.2 |
Switch............................................................................................ |
19 |
|
5.3 |
Link Fault Passthrough Function................................................... |
22 |
6. |
Troubleshooting........................................................................................ |
24 |
|
|
6.1 |
Contacting Black Box.................................................................... |
24 |
|
6.2 |
Shipping and Packaging................................................................ |
24 |
Page 6 |
724-746-5500 | blackbox.com |
Chapter 1: Specifications
1. Specifications
Maximum Distance — LHC201A: Multimode fiberoptic: 2 km, LHC202A: Single-mode fiberoptic: 20 km
Standards — IEEE 802.3, IEEE 802.3u Connectors — (1) dual SC, (1) RJ-45
Temperature Tolerance — Operating: +32 to +104° F (0 to +40° C); Storage: -40 to +158° F (-40 to +70° C)
Humidity — Operating: 10 to 90% relative humidity, noncondensing; Storage: 5 to 90% relative humidity, noncondensing
Power — External: 100–240 VAC, 50–60 Hz, 0.3 A; Output: 9 VDC, 0.6 A, 5.4 W max.
Size — 1.1"H x 3.7"W x 2.9"D (2.7 x 9.4 x 7.4 cm) Weight — 1.1 lb. (0.5 kg)
724-746-5500 | blackbox.com |
Page 7 |
Chapter 2: Overview
2. Overview
2.1 Introduction
The Pure Networking Fast Ethernet Media Converters connect a 10/100BASE-TX network segment and a 100BASE-FX network segment. Use these units to join a 10/100BASE-TX segment to a 100BASE-FX segment on your network, or use them in pairs to extend the 328-foot (100-m) distance limitation of copper based Ethernet.
The converters also feature LFP (Link Fault Passthrough, as described in Section 5.3). Two converter models are available:
•LHC201A: This fiber SC media converter transmits/receives data by 1310-nm short-wave laser over multimode fiber.
•LHC202A: This fiber SC media converter transmits/receives data by 1310-nm short-wave laser over single-mode fiber.
2.2 Features
•Complies with 802.3u 10/100BASE-TX and 100BASE-FX standards.
•Provides one SC connector and one RJ-45 connector.
•Supports autonegotiation of duplex mode on the twisted-pair port.
•Supports autonegotiation of 10/100 Mbps and auto MDI/MDI-X for the twisted-pair port.
•Supports Link Fault Passthrough (LFP) and Far End Fault (FEF) functions.
•Extends fiber distance up to 2 km for multimode fiber and 20 km for single-mode fiber.
•Easy-to-view LED indicators provide status to easily monitor network activity.
•Uses an external power supply (included).
2.3 What’s Included
Your package should contain the following items. If anything is missing or damaged, contact Black Box Technical Support at 724-746-5500 or info@blackbox.com.
•(1) Pure Networking Fast Ethernet Media Converter
•(1) DC adapter
•This user’s manual
Page 8 |
724-746-5500 | blackbox.com |
Chapter 2: Overview
2.4 Connectors and Network Cables Supported
The connectors and network cables supported by the converter are listed as follows.
•Connectors: RJ-45, SC.
•Network cables: CAT5 twisted-pair (TP), 1310-nm 62.5/125-µm, 50/125-µm single-mode/multimode fiber.
Table 2-1. Connectors and network cable supported.
|
|
|
|
Output |
|
Part |
|
Transmission |
Transmission |
Center |
|
Number |
Interface |
Distance |
Media |
Wavelength |
|
|
|
|
|
|
|
|
RJ-45 TP |
|
Multimode |
|
|
LHC201A |
and SC |
2 km |
1310 nm |
||
fiber, TP |
|||||
|
fiber |
|
|
||
|
|
|
|
||
|
|
|
|
|
|
|
RJ-45 TP |
|
Single-mode |
|
|
LHC202A |
and SC |
20 km |
1310 nm |
||
fiber, TP |
|||||
|
fiber |
|
|
||
|
|
|
|
||
|
|
|
|
|
2.5 Hardware Description
Figures 2-1 through 2-4 show the front and back panels of the media converters. Tables 2-2 and 2-3 describe their components.
2.5.1 LHC201A
1 |
|
2 |
3 |
4 |
5 |
6 |
7 |
|
|
|||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
8 9
Figure 2-1. Front panel of the LHC201A.
724-746-5500 | blackbox.com |
Page 9 |
Loading...