Beko WCB 77107, WCB 77087, WCB 77127 User Manual

0 (0)

Washing machine

WCB 77127 WCB 77107 WCB 77087

1 Warnings

General Safety

Never place your machine on a carpet covered floor. Otherwise, lack of airflow from below of your machine may cause electrical parts to overheat. This may cause problems with your washing machine.

If the power cable or mains plug is damaged you must call Authorized Service for repair.

Fit the drain hose into the discharge housing securely to prevent any water leakage and to allow machine to take in and discharge water as required. It is very important that the water intake and drain hoses are not folded, squeezed, or broken when the appliance is pushed into place after it is installed or cleaned.

Your washing machine is designed to continue operating when the power restores after a power interruption. The machine will resume its program when the power restores. Press the “Start/Pause/ Cancel” button for 3 seconds to cancel the program (See, Canceling a Program)

There may be some water in your machine when you receive it. This is from the quality control process and is normal. It is not harmful to your machine.

Some problems you may encounter may be caused by the infrastructure. Press “Start/Pause/Cancel” button for 3 seconds to cancel the program set in your machine before calling the authorized service.

This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities,or lack of experience and knowledge,unless they

have been given supervises or instruction concerning use of the appliance by a person responsible for their safety.

First Use

Carry out your first washing process without loading your machine and with detergent under “Cottons 90°C” program.

Ensure that the cold and hot water connections are made correctly when installing your machine.

If the current fuse or circuit breaker is less than 16 Amperes, please have a qualified electrician install a 16 Ampere fuse or circuit breaker.

While using with or without a transformer, do not neglect to have the grounding installation laid by a qualified electrician. Our company shall not be liable for any damages that may arise when the machine is used on a line without grounding.

• Keep the packaging materials out of reach of children or dispose them by classifying according to waste directives.

Intended use

This product has been designed for home use.

The appliance may only be used for washing and rinsing of textiles that are marked accordingly.

Safety instructions

This appliance must be connected to an earthed outlet protected by a fuse of suitable capacity.

The supply and draining hoses must always be securely fastened and remain in an undamaged state.

Fit the draining hose to a washbasin or bathtub securely before starting up your machine. There may be a risk of being scalded due to high washing temperatures!

Never open the loading door or remove the filter while there is still water in the drum.

Unplug the machine when it is not in use.

Never wash down the appliance with a water hose! There is the risk of electric shock!

Never touch the plug with wet hands. Do not operate the machine if the power cord or plug is damaged.

For malfunctions that cannot be solved by information in the operating manual:

Turn off the machine, unplug it, turn off the water tap and contact an authorized service agent. You may refer to your local agent or solid waste collection center in

your municipality to learn how to dispose of your machine.

If there are children in your

house...

Keep children away from the machine when it is operating. Do not let them tamper with the machine.

Close the loading door when you leave the area where the machine is located.

2 - EN

Beko WCB 77107, WCB 77087, WCB 77127 User Manual

2 Installation

Removing packaging reinforcement

Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon.

Opening the transportation locks

ATransportation safety bolts must be removed before operating the washing machine! Otherwise, the machine will be damaged!

1.Loosen all the bolts with a spanner until they rotate freely (“C”)

2.Remove transportation safety bolts by turning them gently.

3.Fit the covers (supplied in the bag with the Operation Manual) into the holes on the rear panel. (“P”)

C Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future.

C Never move the appliance without the transportation safety bolts properly fixed in place!

Adjusting the feet

ADo not use any tools to loosen the lock nuts. Otherwise, they can be damaged.

1.Manually (by hand) loosen the lock nuts on the feet.

2.Adjust them until the machine stands level and firmly.

3.Important: Tighten all lock nuts up again.

If you are going to use your double waterinlet machine as a single (cold) water-inlet unit, you must install the stopper*, supplied with your machine to the hot water valve.

If you want to use both water inlets of the product, you can connect the hot water hose after removing the stopper and gasket group from the hot water valve.

* Applies for the products supplied with a blind stopper group.

Models with a single water inlet should not be connected to the hot water tap.

When returning the appliance to its place after maintenance or cleaning, care should be taken not to fold, squeeze or block the hoses.

Connecting to the drain

The water discharge hose can be attached to the edge of a washbasin or bathtub. The drain hose should be firmly fitted into the drain as to not get out of its housing.

Important:

The end of the drain hose must be directly connected to the wastewater drain or to the washbasin.

The hose should be attached to a height of at least 40 cm, and 100 cm at most.

In case the hose is elevated after laying it on the floor level or close to the ground (less than 40 cm above the ground), water discharge becomes more difficult and the laundry may come out wet.

Connecting to the water supply.

Important:

The water supply pressure required to run the machine must be 1-10 bar (0,1 – 1 MPa).

Connect the special hoses supplied with the machine to the water intake valves on the machine.

The hose should be pushed into the drainage for more than 15 cm. If it is too long you may have it shortened.

The maximum length of the combined hoses must not be longer than 3.2 m.

3 - EN

Electrical connection

Connect the machine to an earthed outlet protected by a fuse of suitable capacity.

Important:

• Connection should comply with national regulations.

• The voltage and the allowed fuse protection are specified in the section “Technical Specifications”.

• The specified voltage must be equal to your mains voltage.

• Connection via extension cords or multiplugs should not be made.

BA damaged power cable must be replaced by a qualified electrician.

BThe appliance must not be operated unless it is repaired! There is the risk of electric shock!

3 Initial preparations for

washing

Preparing clothes for washing

Laundry items with metal attachments such as, bras, belt buckles and metal buttons will damage the machine. Remove metal attachments or place the items in a clothing bag, pillow case, or something similar.

Sort the laundry according to type of fabric, color, and degree of soiling and permissible water temperature. Always follow the advice on the garment labels.

Place small items like infants’ socks and nylon stockings, etc. in a laundry bag, pillow case or something similar. This will also save your laundry from getting lost.

Wash “machine washable” or “hand washable” labeled products only with an appropriate program.

Do not wash colors and whites together. New, dark colored cottons may release a lot of dye. Wash them separately.

Use only dyes/color changers and lime removers suitable for machine wash. Always follow the instructions on the packaging.

Wash trousers and delicate clothes turned inside out.

Correct load capacity

C Please follow the information in the "Program Selection Table". Washing results will degrade when the machine is overloaded.

Loading door

The door locks during program operation and the Door Locked Symbol lights up. The door can be opened when the symbol fades out.

Detergents and softeners

Detergent Drawer

The detergent drawer is composed of three compartments:

The detergent dispenser may be in two different types according to the model of your machine.

(I) for prewash

(II) for main wash - (III) siphon

() for softener

Detergent, softener and other cleaning agents

Add detergent and softener before starting the washing program.

Never open the detergent dispenser drawer while the washing program is running!

When using a program without pre-wash, no detergent should be put into the pre-wash compartment (Compartment no. I).

Detergent quantity

The amount of washing detergent to be used depends on the amount of laundry, the degree of soiling and water hardness.

Do not use amounts exceeding the quantities recommended on the package to avoid problems of excessive foam, poor rinsing, financial savings and finally, environmental protection.

Never exceed the (> max <) level marking; otherwise, the softener will be wasted without being used.

Do not use liquid detergent if you want to wash using the time delay feature.

4 - EN

Loading...
+ 8 hidden pages