PHONE EASY
Big Button Telephone
User guide
Downloaded from: http://www.guardianalarms.net
LOCATION OF CONTROLS
|
|
|
|
|
|
8 |
1 |
1 |
|
2 |
3 |
|
|
|
4 |
|
5 |
6 |
|
9 |
|
7 |
|
8 |
9 |
|
|
2 |
|
|
|
|||
|
|
|
0 |
|
|
|
|
M1 |
M2 |
M3 |
|
|
10 |
|
STORE/MUTE MEMORY |
RECALL REDIAL |
VOL |
+ |
3 4 5 6 7
1 |
Handset hanger hook |
6 |
Recall button |
2 |
Memory card |
7 |
Last number redial |
3 |
Direct memories M1, M2, M3 |
8 |
Visual ring indicator |
4 |
Store/Mute button and indicator |
9 |
Keypad 0-9, *, # |
5 |
Memory button (Indirect) |
10 |
Volume controls |
1
CONNECTING
#Connect the line cord to the telephone and to the telephone socket.
#Lift the handset and check for a dial tone.
WALL MOUNTING
The Audioline Phone Easy can be wall mounted directly onto the standard wall plate or to the wall by following the instructions below:
#Mark the position of the two holes 83 mm apart, one above the other.
#Ensure there are no hidden cables, water pipes, etc., before drilling holes. Check that the intended mounting point is within reach of a telephone socket.
#Drill the holes.
#Fit the screws (not supplied) to the wall, leaving 5 mm protruding (use wall plugs if necessary, not supplied).
#Place the telephone in position and locate the two holes on the base of the telephone over the screws, then slide into place.
#The handset hanger hook (item 1 on page 1) must be removed, rotated 180 degrees and replaced.
TO MAKE A CALL
PLift the handset and wait for dial tone.
PDial the phone number.
PReplace the handset to terminate the call.
LAST NUMBER REDIAL
To redial the number called, lift the handset and press the [REDIAL] button. The number will be dialled automatically.
The number will be retained in memory until another number is dialled.
The [REDIAL] button will not operate if the number dialled was from memory.
MUTE
To speak privately to a third party while on a call, press the [MUTE] button (the small red LED will flash). When you wish to resume your telephone conversation, press the [MUTE] button again.
2