AT&T CL82859, CL82509, CL82359, CL82659, CL82109 User Manual

...
0 (0)
AT&T CL82859, CL82509, CL82359, CL82659, CL82109 User Manual

Quick start guide

CL82109/CL82209/CL82309/

CL82359/CL82409/CL82509/

CL82609/CL82659/CL82859 DECT 6.0 corded/cordless telephone/answering system with caller ID/call waiting

Installation

 

 

 

You must install and charge the

STOP!

See page 3-4 for easy instructions.

handset battery before using the

 

cordless handset.

 

 

 

 

 

 

 

Install the telephone base close to a telephone jack and a power outlet not controlled by a wall switch. The telephone base can be placed on a flat surface or vertically mounted on the wall. For optimum range and better reception, place the telephone base in a central and open location.

If you subscribe to high-speed Internet service (digital subscriber line - DSL) through your telephone line, you must install a DSL filter between the telephone line cord and the telephone wall jack (see the following page). The filter prevents noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.

Your product may be shipped with a protective sticker covering the handset or telephone base display - remove it before use.

For customer service or product information, visit our website at

www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.

Avoid placing the telephone base too close to:

Communication devices such as: television sets, VCRs, or other cordless telephones.

Excessive heat sources.

Noise sources such as a window with traffic outside, motors, microwave ovens, refrigerators, or fluorescent lighting.

Excessive dust sources such as a workshop or garage.

Excessive moisture.

Extremely low temperature.

Mechanical vibration or shock such as on top of the washing machine or workbench.

1

Telephone base & charger installation

Install the telephone as shown below.

The telephone base is ready for tabletop use. If you want to change to wall mounting, see user’s manual for details.

1.Plug one end of the telephone line cord into the telephone jack on the bottom of the telephone base.

7.Raise the antenna.

2. Route the power adapter cord through the slot.

3. Plug the small end of the telephone base power adapter into the power

jack on the bottom of the telephone base.

4. Place the cords into the channels.

Telephone line cord

Power

adapter

6. Plug the other end

If you have DSL high

of the telephone

speed Internet

line cord into a

service, a DSL filter

telephone jack or a

(not included) is

required.

DSL filter.

 

Charger installation

IMPORTANT INFORMATION

5. Plug the large end of the power adapter

into a power outlet not controlled by a wall switch.

Plug the power adapter into an electrical outlet not controlled by a wall switch.

1.Use only the power adapter(s) supplied with this product. To order a replacement power adapter, visit our website at www.telephones.att.com, or call

1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.

2.The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under- the-table or cabinet outlet.

2

Loading...
+ 6 hidden pages