American Standard 4332.350.XXX User Manual
Installation
Instructions
PEKOE
Single Lever Semi-Professional
Kitchen Faucet
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Recommended Tools
4332.350.XXX
Certified to comply with ANSI A112.18.1M
M968577 Rev.1.1
Phillips Screwdriver
INSTALL FITTING
1
CAUTION
Make certain the SEAL (1) is properly seated in recess
of faucet body.
Insert supply HOSES (2) and SHANK (3) through center
hole of sink or mounting surface.
Assemble RUBBER WASHER (4), PLASTIC WASHER (5),
METAL WASHER (6) and threaded LOCKNUT (7) onto
SHANK (3) from underside of sink or mounting surface.
Hand tighten LOCKNUT (7) and check that faucet is centered.
Use a screwdriver to tighten SCREWS (8) on LOCKNUT (7).
Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
Turn off hot and cold water
supplies before beginning.
Channel Locks
Adjustable Wrench
Plumbers' Putty or Caulking
RECESS
3
Tubing Cutter
1
2
4
5
6
7
8
MAKE WATER SUPPLY CONNECTIONS
2
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection
on fitting supplies are 3/8" compression. Connect left supply
(Marked with a Red Stripe) to Hot and right supply (Marked with
Blue Stripe) to Cold wall supply. Use adjustable wrench to
tighten connections. Do not over tighten.
Faucet supplies are 27-1/2" long from faucet base.
Note: If additional supply length
is required, installer must
purchase additional parts
separately.
Important: If SUPPLY HOSES
(1, 2) are too long, loop as
illustrated to avoid kinking.
TEST INSTALLED FAUCET
3
3
Move HANDLE (1) into "off" position.
Unthread SPRAY END (2) from HOSE END (3).
RED
STRIPE
HOT
BLUE
STRIPE
2
1
COLD
Turn on water supplies and check connections for leaks
Operate HANDLE (1) on and off, hot and cold to flush water
lines thoroughly. Replace SPRAY END (2).
Check all drain connections for leaks.
Move HANDLE (1) to "off" position.
.
3
2
1
HOT & COLD SUPPLIES
M968577 Rev.1.1
Loading...