CHAMPION® 4 ELONGATED TOILET
❑ 2018.214
• Vitreous china
• EverClean® surface inhibits the growth of
stain- and odor-causing bacteria, mold,
and mildew on the surface
• Low-consumption (6.0 Lpf/1.6 gpf)
• Features Champion® 4 Flushing System
performance platform
• 4" non-adjustable, piston action Accelerator™
ush valve
• Elongated siphon action jetted bowl
• 2-3/8" fully-glazed trapway
• Speed Connect® tank/bowl coupling system
• Chrome-plated trip lever
• Sweeping pier on bowl
• 100% factory ush tested
• 2 bolt caps
• 10 year warranty
❑ 3121.016 Bowl
❑ 4266.014 Tank
CHAMPION® 4
ELONGATED TOILET
VITREOUS CHINA
Nominal Dimensions:
772 x 464 x 797mm (30-3/8" x 18-1/4" x 31-3/8")
Fixture only, seat and supply by others
Alternate Tank Congurations Available:
❑ 4266.504 Tank complete with Aquaguard Liner
❑ 4266.604 Tank complete with tank cover
locking device
❑ 4266.704 Tank complete with Aquaguard Liner
and tank cover locking device
❑ 4266.804 Tank complete with trip lever
located on right side
❑ 4266.904 Tank complete with tank cover locking
device and trip lever located on right side
❑ 4266.954 Tank complete with Aquaguard Liner,
tank cover locking device, and trip lever
on right side
Compliance Certications Meets or Exceeds the Following Specications:
• ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter,
Trap Seal Depth and all Dimensions
• Los Angeles Department of Water and Power
Supplementary Purchase Specication for
Non-Adjustability - July, 2003 revision
SEE REVERSE FOR ADDITIONAL ROUGHING-IN
DIMENSIONS
To Be Specied:
❏ Color:
❏ White ❏ Bone ❏ Silver ❏ Linen ❏ Black
❏ Design Matched Seat: #5280.016
❏ Alternate Seats:
❏ Champion® Slow Close Elongated #5325.010
❏ Rise & Shine Elongated #5324.019
❏ Rise & Shine Elongated-Open Front #5325.024
❏ EverClean® Elongated Seat with Slow Close
Snap-Off Hinges #5321.110
❏ Supply with stop:
NOTES:
THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF
305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.
SUPPLY NOT INCLUDED WITH FIX TURE AND MUST BE ORDERED
SEPARATELY.
DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.
*
IMPORTANT: Dimensions of xtures are nominal and may var y within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
© 2008 AS America Inc.
K35
Revised 2/08