American Standard M962689-0070A, M962688-YYY0A, M962659-0070A, 4332.300.XXX, M962690-0070A User Manual

0 (0)
Installation
Instructions
PEKOE PULL DOWN
4332.300.XXX
SINGLE CONTROL KITCHEN FAUCET with PULL DOWN SPRAY
Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin.
Recommended Tools
Phillips Screwdriver
1
CAUTION
Turn off hot and cold water supplies before beginning.
Channel Locks
Adjustable Wrench
Plumbers' Putty or Caulking
Certified to comply with ANSI A112.18.1M
M968581 Rev.1.1
Tubing Cutter
Make certain the O-RING SEAL (1) is properly seated in recess of faucet body.
Insert supply HOSES (2), SHANK (3) and SPRAY HOSE (4) through center hole of sink or mounting surface.
Assemble RUBBER WASHER (5), PLASTIC WASHER (6), RUBBER & METAL “C” WASHERS (7) and long LOCKNUT (8) onto SHANK (3) from underside of sink. Hand tighten LOCKNUT (8) and check that faucet is centered.
Tighten LOCKNUT (8) with WRENCH (12) supplied. Insert screwdriver into hole in WRENCH (12) and tighten.
Feed HOSE END (9) through HOSE GUIDE (10). Slide other side of HOSE GUIDE (10) onto SHANK (3) and secure with LOCK NUT (11). Do not over tighten!
RECESS
5
6
7
10
1
4
3
8
11
9 2
12
SCREWDRIVER
MAKE WATER SUPPLY CONNECTIONS
2
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten.
RED
STRIPE
BLUE
STRIPE
Faucet supplies are 27-1/2" long from faucet base.
Note: If additional supply length is required, installer must purchase additional parts separately.
Important: If SUPPLY HOSES (1, 2) are too long, loop as illustrated to avoid kinking.
CONNECT HOSE SPRAY
3
and INSTALL WEIGHT
Check that seal washers are installed in both ends of SPRAY HOSE ADAPTER (1). Thread SPRAY HOSE ADAPTER (1) onto faucet SHANK (2). Tighten with adjustable wrench.
Thread HOSE END (3) into bottom of SPRAY HOSE ADAPTER (1). Tighten with adjustable wrench. Make sure all connections are tight. Figure 1.
Install RUBBER BUSHING (4) onto SPRAY HOSE (5). Install WEIGHTS (6) onto HOSE (5) using two screws (7). Locate WEIGHTS (6) 18" from underside of mounting surface on HOSE (5). Tighten SCREWS (5) firmly. Figure 2.
1
HOT
2
COLD
Figure 1.
Figure 1
UNDER SIDE
OF MOUNTING
SURFACE
2
SEAL WASHER
1
18"
SEAL
3
WASHER
6
4
57
Figure 2
M968581 Rev.1.1
Loading...
+ 2 hidden pages