CADET® 3 ROUND FRONT 10" ROUGH-IN TOILET
VITREOUS CHINA
CADET® 3 ROUND FRONT 10"
ROUGH-IN TOILET
2384.010
•Vitreous china
•Low-consumption (6.0 Lpf/1.6 gpf)
•EverClean® surface inhibits the growth of stainand odor-causing bacteria, mold, and mildew on the surface
•Features the Cadet® 3 Flushing System
•Space saving round front siphon action jetted bowl
•Fully-glazed 2-1/8" trapway with 2" ball pass
•Generous 9" x 8" water surface area
•Close-coupled tank with flat tank cover for superior storage
•Oversized 3" flush valve with chemical resistant flapper
•Chrome trip lever
•Speed Connect® tank-to-bowl coupling system
•Sanitary dam on bowl with four point tank stabilization
•2 color-matched bolt caps
•100% factory flush tested
•5 year warranty
3011.016 Round Front Bowl
4019.016 Tank
Nominal Dimensions:
667 x 432 x 740mm
(26-1/4" x 17" x 29-1/8")
Fixture only, seat and supply by others
Alternative Tank Configurations Available:
4019.600 Tank complete with tank cover locking device
4019.800 Tank complete with trip lever on right side
4019.900 Tank complete with tank cover locking device and trip lever on right side
SEE REVERSE FOR ADDITIONAL ROUGHING-IN DIMENSIONS
To Be Specified:
Color: White Bone Silver Linen Black
Seat: #5330.010 Round front Champion® Slow Close solid plastic seat and cover with easy lift off feature
Seat: #5282.011 Round Front EverClean® solid plastic seat and cover
Seat: #5320.110 EverClean® Round Front Seat with Slow Close Snap-Off Hinges
Supply with stop:
Compliance Certifications -
Meets or Exceeds the Following Specifications:
•ASME A112.19.2M for Vitreous China Fixtures - includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions
•Los Angeles Department of Water and Power Supplementary Purchase Specification for Non-Adjustability
© 2008 AS America Inc.
NOTES:
THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 254MM (10") FROM FINISHED WALL TO C/L OF OUTLET.
SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY.
* DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.
K69
Revised 2/08