American Standard 0228.018, 0224.040, 0228.080, 0224.014 User Manual

0 (0)
American Standard 0228.018, 0224.040, 0228.080, 0224.014 User Manual

ANTIQUITY™

PEDESTAL SINK

VITREOUS CHINA

ANTIQUITY™ PEDESTAL SINK

Turn-of-the-century detailing on lavatory and pedestal

Made from vitreous china

Rear overflow

Supplied with mounting kit

Faucet ledge with large deck area (faucet not included)

Design matched to Antiquity toilets

0228.080 Faucet holes on 8" (203mm) centers (Illustrated)

0224.040 Faucet holes on 4" (102mm) centers

Nominal Dimensions:

610 x 483 x 864mm

(24-1/2" x 19" x 34")

Separate Components:

0228.018 Pedestal top-8" (203mm) centers

0224.014 Pedestal top-4" (102mm) centers

731007-400 Pedestal only

 

 

FINISHED

89mm

203mm

WALL

(8)

 

(3-1/2)

 

 

 

203mm

(8)

Bowl sizes:

483mm (19") wide

298mm (11-3/4") front to back 140mm (5-1/2") deep

Compliance Certifications -

Meets or Exceeds the Following Specifications:

• ASME A112.19.2M for Vitreous China Fixtures

To Be Specified:

Color: White Bone Linen

Faucet*:

Faucet Finish:

Supplies:

1-1/4" Trap:

483mm PEDESTAL ANCHORING (19)

SCREW HOLES 8mm (5/16) DIA.

622mm

13mm

(24-1/2)

(1/2") DIA.

 

 

HOLES FOR

264mm

ANCHOR BOLTS

51mm

(10-3/8)

REF.

(2)

 

DRAIN

203mm

CHASE

 

(8)

 

203mm

SUPPLIES AS

(8)

REQUIRED 178mm

 

(7)

*578mm

 

1-1/4 O.D.

 

(22-3/4)

 

WASTE

864mm

 

 

 

*521mm

 

 

 

(34)

 

(20-1/2)

1-1/4 O.D.

 

 

 

 

 

 

TAILPIECE

 

FINISHED

356mm

FLOOR

(14)

* See faucet section for additional models available

© 2008 AS America Inc.

241mm (9-1/2)

NOTES:

* DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE SUGGESTED.

PEDESTAL ANCHORING SCREWS NOT INCLUDED.

SUITABLE FOR REINFORCEMENT ONLY. ACTUAL DIMENSIONS MUST BE TAKEN FROM FIXTURE.

FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY. PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS. INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2.

These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

J12

Revised 2/08

Loading...