MatrixTM UPS
Hard-wire kit accessory
MXA001
MXA002
User's
Manual
American Power Conversion
®
The world's most reliable power protection
Important safety instructions!
Please read this manual! Veuillez lire ce manuel!
Bitte lesen Sie dieses Anleitungshandbuch! ¡Se ruega leer este manual de instrucciones!
PLEASE SAVE THIS MANUAL ! It includes important instructions for the safe use and installation of the UPS and its accessories.
CONSERVER CES INSTRUCTIONS ! Cette notice contient des instructions importantes concernant la sécurité.
Entire contents copyright © 1993 American Power Conversion. All rights reserved; reproduction in whole or in part without permission is prohibited. Matrix UPS is a trademark of APC.
Table of contents
1.0 |
Introduction ................................................................................. |
2 |
2.0 |
Presentation ................................................................................. |
3 |
3.0 |
Installation ................................................................................... |
4 |
|
Input voltage requirements ............................................................................. |
4 |
|
Installation materials and tools....................................................................... |
4 |
|
Input wiring procedure .................................................................................. |
5 |
|
Output wiring procedure................................................................................ |
8 |
Page 1
1.0 Introduction
The hard-wire kit allows the UPS's input and/or output terminals to be permanently secured to building service wiring. This kit is used in place of the power distribution plate and/or input cable plate originally furnished with the UPS. The kit contains input cable and output power distribution plates with "knock-outs'' for interface to standard sized fittings.
Hard-wire kit parts
Page 2
2.0 Presentation
Power distribution plate
Provides an interface for output hard-wiring of loads. It is used in place of the power distribution plate for cord connected equipment originally furnished with the UPS.
Input cable plate
Used to replace the input cable plate originally furnished with the UPS. It allows hard-wiring of the input connections.
Wiring inspection cover
Whenremoved,thewiringinspectioncoverrevealstheoutputwiringconnectionstotheUPS. It is necessary to inspect the connections during installation as the wires may move when the power distribution plate is attached.
Electrical fittings "knock-outs"
Knock-outsappropriate foruse with ½"(outputonly), ¾"and1" electricalcableclampfittings are provided at the input cable plate, and at the output power distribution plate.
UPS output power connector
Thisselflockingconnectorplugsintoaninternalreceptacle. Thematingconnectorisrevealed when the power distribution plate and top cover of the UPS Isolation Unit are removed. The connector provides all necessary output voltages to the output wiring terminals.
Earth bonding ring terminal
The earth bonding ring terminal connects the output earthing terminations on the power distribution plate to the input protective earth. This terminal is bolted to the Isolation Unit's earthing stud. See the Installation section of this manual.
Page 3
Loading...