American Power Conversion BE325 User Manual

0 (0)
American Power Conversion BE325 User Manual

®SurgeArrest® Surge Protector

www.apc.com

+ Battery Backup (BE325-UK)

 

User’s Manual

Connect Battery

The APC SurgeArrest Surge Protector + Battery Backup is shipped with the battery disconnected. The unit will not operate until the battery is connected. NOTE: Small sparks may occur during battery connection. This is normal.

1

2

3

4

5

Connect Equipment

 

32 - 104oF (0 - 40oC)

Battery Backup + Surge Protection

These outlets are powered whenever the unit is switched ON. During a power outage or other utility problems (brownouts, overvoltages), these outlets will be powered for a limited time by the internal battery. Plug your computer and 17” (or smaller) monitor, into these two outlets.

Connect FAX/Modem/Phone

The unit protects a single line (2-wire) fax, modem or phone from surges when it is connected as shown below.

Connect AC Line Cord

Connect the AC line cord to a 230-volt outlet.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Surge Protector

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

+ Battery Backup

 

 

 

 

 

w w w.apc.com

 

 

 

 

 

 

 

325VA

Battery Backup plus Surge Protection

Top View

Surge Protection

These outlets provide full-time protection from surges even if the unit is switched OFF. Plug your printer, fax machine, scanner, or other peripheral that does not need battery power into these outlets.

egruSnoitcetorP

Fax/Modem/Phone

Telephone Wall

Outlet

230-Volt Wall

Outlet

RJ-11

Connectors

End View

AC Line

 

Circuit

Cord

Circuit Breaker

 

 

 

 

Breaker

 

Push to Reset

 

End View

Side View

Status Indications

Power On

The Surge Protector + Battery Backup should be allowed to charge for at least 16 hours to ensure sufficient runtime. The unit is being charged whenever it is connected to utility power, and the unit is turned ON.

Power ON the unit by pressing the ON/OFF button. Turn on your equipment.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Surge Protector

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

+ Battery Backup

 

 

 

 

 

w w w.apc.com

 

 

 

 

 

 

 

325VA

Battery Backup plus Surge Protection

Top View

Note: The on/off switch is illuminated when in the ON position. The switch may flash to indicate changing power conditions (see Status Indications).

The Surge Protector + Battery Backup provides status indications through the flashing of the “Power On” indicator, as well as audible beeps. The indications are as follows:

Status

Visual Indications

Audible

Alarm Terminates

 

 

Indication

When

 

 

 

 

On Line - Unit is supplying

Power On LED - ON

None

n/a

conditioned utility power to your

 

 

 

equipment

 

 

 

 

 

 

 

On Battery - Unit is supplying battery

Power On LED - ON

Beeping 4 times

Unit returns to an On

power to the equipment connected to

(off during beep)

every 30 seconds

Line status or when

the battery powered outlets

 

 

the unit is turned off.

 

 

 

 

Low Battery Warning - Unit is

Power On LED -

Rapid beeping

Unit is turned OFF,

supplying battery power and the

Flashing

(one second

returns to On Line or

battery is nearly depleted. Once

 

intervals)

when the battery is

depleted, the unit will turn off.

 

 

finally exhausted and

 

 

 

the unit turns off.

 

 

 

 

Replace Battery - Battery may need

Power On LED -

Continuous tone.

Unit is turned OFF

to be replaced, or the battery is not

Flashing

 

and then ON and it

connected.

 

 

passes a subsequent

 

 

 

battery test. (This test

 

 

 

occurs automatically

 

 

 

whenever the unit is

 

 

 

turned ON and every

 

 

 

14 days)

 

 

 

 

Overload Shutdown - During On

Power On LED -

Continuous tone.

Unit is turned off

Battery operation a battery-power

OFF

 

using the ON/OFF

outlet was overloaded.

 

 

button.

 

 

 

 

990-2124 Copyright © 2003 American Power Conversion. All rights reserved.

APC is a registered trademark of American Power Conversion

 

All other trademarks are property of their respective owners.

Loading...
+ 1 hidden pages