|
PTAC |
|
Installation Instructions |
|
|
Standard Louvered and |
|
|
|
|
Architectural Outdoor Grilles |
|
|
|
|
|
|
|
|
|
|
|
|
|
Standard Louvered Grille
NOTE: A baffle kit must not be used with a standard louvered grille on any PTAC installation.
Before installing the grille, remove the cardboard stiffener |
|
and rear enclosure panel from the wall sleeve. These |
|
items can be removed from inside of the building. The |
|
sleeve stiffener must be taken out before the rear sleeve |
Figure 2 |
enclosure panel can be removed from the sleeve. |
Sleeve Stiffiner Removal
Fold the two outside flaps “A” in and downward to remove (Figure 1).
A |
A |
Standard Louvered Grille Installation Instructions
Figure 3
Figure 1
Rear Enclosure Removal
Remove the rear enclosure by folding the front ends of the top and bottom towards the center. Grasp the top and bottom flanges as shown in Figure 2 and pull out diagonally from one side of the sleeve.
Made in USA
1.Position the grille so that all four flanges are in the up position.
2.Insert the six grommets provided so the square end protrudes through the grille in the opposite direction from the flanges.
3.Manipulate the grille out through the rear sleeve opening using the plastic handle (not shown) provided.
4.Align the guide pins located in the lower rightand lefthand corners of the grille (Figure 3) with the corresponding holes in the rear of the wall sleeve.
5.Secure the grille by threading each of the six screws into the plastic grommets.
6.Remove the plastic handle (not shown) from the center of the grille prior to installing the chassis into the sleeve.
CAUTION
Be sure to keep a firm grip on the plastic handle and grille to prevent it from dropping and /or causing possible injury or property damage.
|
The installation and servicing of this equipment should be |
|
performed by qualified, experienced technicians. |
October 2000 |
A3495703 |
Rev. 1 |
|