Undercounter Dishwasher
PRODUCT MODEL NUMBERS
ADB1400PY |
ADB1300AF |
ADB1400AG |
ADB1500AD |
ADB1100AW |
|
|
|
Electrical Requirements: 120-volt, 60 Hz, AC-only, 15or 20-amp. fused electrical supply. Copper wire only. A time delay fuse or circuit breaker and separate circuit is recommended.
If direct wiring dishwasher: Use flexible, armored or nonmetallic, sheathed copper 
wire with grounding wire that 
meets the wiring requirements for
your home and local codes and ordinances.
Use a UL Listed or CSA Approved conduit connector.
If connecting dishwasher with a power supply cord:
Use power supply cord kit (Part
Number 4317824) marked for use with dishwashers. Follow the kit
instructions for installing the power supply cord.
Power supply cord must plug into a grounded 3 prong outlet located in the cabinet next to the dishwasher opening. Outlet must meet all local codes and ordinances.
Water Supply Requirements: A hot water line with 20 to 120 psi (138 to 862 kPa) water pressure. Water temperature must be 120°F (49°C) water at dishwasher. Use " O.D. copper tubing with compression fitting or flexible braided water supply line
Note: 
" minimum plastic tubing is not recommended.
Use a 90° elbow with " hose connection with rubber washer (part number W10273460). Do not solder within 6" (15.2 cm) from water inlet valve.
Drain Requirements: A new drain hose is supplied with your dishwasher. If this is not long enough, use a new drain hose with a maximum length of 12' (3.7 m) (Part No. 3385556) that meets all current AHAM/IAPMO test standards, is resistant to heat and detergent, and fits the
1" (2.5 cm) drain connector of the dishwasher.
Make sure to connect the drain hose to waste tee or disposer inlet above drain trap in house plumbing and 20" (50.8 cm) minimum above the floor. It is recommended
air gap |
that the drain hose either be |
|
looped up and securely |
||
|
||
|
fastened to the underside of |
|
|
the counter, or be connected |
|
|
to an air gap. |
Make sure to use an air gap if the drain hose is connected to house plumbing lower than 20" (50.8 cm) above subfloor
or floor.
Use 1/2" (1.3 cm) minimum I.D. drain line fittings.
If required, the air gap should be installed in accordance with the air gap installation instructions. When connecting the air gap a rubber hose (not provided) will be needed to connect to the waste tee or disposer inlet.
PRODUCT DIMENSIONS
|
33 |
|
|
|
|
||
(85. |
|
||
|
1 |
cm) |
|
min |
|
||
rear |
|
with |
|
|
legsleveling |
||
removed |
|||
|
|
|
|
Page 1 of 2
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation |
Ref. W10435040C |
Instructions packed with product. Specifications subject to change without notice. |
12/2016 |
Loading...