Rotary Switch Conversion Kit Installation Instructions
for Amana Quiet Zone Room Air Conditioners
Introduction
This instruction sheet provides directions for installing Rotary Switch Conversion Kit #R9900326 in Amana Quiet Zone Room Air Conditioners and affects model numbers 5QZ21RC, 5QZ21RC1, 7QZ21RC, 7QZ21RC1, 9QZ22RC, 9QZ22RC1, 10QZ22RC, 10QZ22RC1, 12QZ22RC, 12QZ22RC1, 14QZ23RC, 14QZ23RC1, 18QZ33RC, 18QZ33RC1, 21QZ33RC, 21QZ33RC1
Kit converts Quiet Zone model window air conditioners from electronic control to rotary switch control.
Contents of Kit #R9900326
Qty |
Description |
Part # |
1 |
Thermostat |
10711201 |
1 |
Installation Instructions |
R9900327r0 |
1 |
Rotary Switch |
10710601 |
1 |
Escutcheon |
C6383605 |
1 |
Escutcheon |
C6399811 |
1 |
Escutcheon |
C6420813 |
2 |
Control Knobs |
D7795807 |
1 |
Jumper Wire |
D5559984 |
2 |
Bulb Clips |
11110101 |
5 |
Insulated Terminals |
M0322506 |
2 |
Screws |
M0232012 |
2 |
Screws |
M0202321 |
1 |
Wiring Diagram |
10701201 |
1 |
Altered Control Tag |
20194901 |
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Installation Instructions
1.Remove horizontal insert, filter, control knobs (2), hex head screws (3 or 4) , and front frame (see Figure 1).
2.Remove thermostat sensor and sensor clip from evaporator coil.
3.On 14, 18, and 21,000 btu models remove the metal return bend cover between the control box and evaporator (1screw). Remove the control panel (4 screws). Unplug the control board from the terminal housing (see Figure 2).
4.Remove the four screws connecting the control board to the control panel. Discard the board.
Figure 1 |
|
|
|
|
Front |
|
|
frame |
Horizontal |
Filter |
Control knobs |
insert |
Figure 2 |
Return bend cover |
Control board |
Control panel |
WARNING
Discharge capacitior through a 10,000 ohm resistor before continuing.
5.Disconnect the black BK-10 wire from the capacitor “C” terminal on the terminal housing.
6.Cut the remaining (5) wires on the housing, and discard the terminal housing.
7.Strip the wires previously cut in step 6 and crimp a quick connect terminal on each wire.
Part No. R9900327 Revision 0 |
©1999 Amana Appliances |
|
Printed in USA |
8/99 |
Amana, Iowa 52204 |