SERVICE MANUAL
DISHWASHER
|
|
|
Dishwasher |
|
|
|
|
Easytronic Dishwashers |
|
|
|
|
|
|
|
|
|
with Flow Heater - |
|
© AEG Hausgeräte GmbH |
Publ.-Nr.: |
Fully Integrated, |
|
|
Integrated, Built Under, |
|
|||
Muggenhofer Straße 135 |
599 50 69 24 |
|
||
Freestanding |
|
|||
D-90429 Nürnberg |
685 |
|
||
|
|
|||
Germany |
|
EN |
|
|
Fax +49 (0)911 323 1420 |
|
|
|
|
TSE - N |
|
|
|
|
Ausgabe: |
11.98 |
|
|
|
Edition: |
11.98 |
|
|
|
|
|
|
|
|
Dishwasher |
292137201 |
Easytronic Dishwashers with Flow Heater - Fully Integrated, Integrated, Built Under, Freestanding
Technical Data
Dimensions |
|
Build-in dimensions for Fully Integrated |
Build-in dimensions for Integrated |
Dishwashers |
Dishwashers |
ÖKO-FAVORIT 6270 / 5270 / 3270 Vi |
ÖKO-FAVORIT 8081 i, 6060 i, 5060 i, 5050 i |
H:\H1\GSP\TECHNIK\AEGHB\137201GB.P65
Build-in dimensions for Built-Under Dishwashers
ÖKO-FAVORIT 5060 U, 4230 U
*Appliances with height adjustable feet
*Appliances with height-adjustable feet Plinth height for appliances 820 mm high 100 - 175 mm
Plinth height for appliances 870 mm high 150 - 230 mm
Dimensions for Freestanding Dishwasher
Height |
85 cm |
Width |
60 cm |
Depth |
60 cm |
Height with worktop removed 82 cm Feet adjustment 1 cm
04.99 HV 83-N
H:\H1\GSP\TECHNIK\AEGHB\137201GB.P65
Dishwasher |
292292137202 |
Easytronic Dishwashers with Flow Heater - Fully Integrated, Integrated, Built Under, Freestanding
Technical Data
Demand Values
Model |
half loading |
full loading |
noise |
||
|
water |
energy |
water |
energy |
|
|
|
|
|
|
|
ÖKO-FAVORIT 6080 ...... |
13 l ............ |
0,95 kWh ........... |
15 l ........... |
1,15 kWh ...... |
45 dB |
ÖKO-FAVORIT 5080 ...... |
13 l ............ |
0,95 kWh ........... |
15 l ........... |
1,15 kWh ...... |
47 dB |
ÖKO-FAVORIT 5070 ...... |
14 l ............ |
1,05 kWh ........... |
16 l ........... |
1,25 kWh ...... |
47 dB |
ÖKO-FAVORIT 4070 ...... |
14 l ............ |
1,05 kWh ........... |
16 l ........... |
1,25 kWh ...... |
49 dB |
ÖKO-FAVORIT 6280 U ... |
13 l ............ |
0,95 kWh ........... |
15 l ........... |
1,15 kWh ...... |
45 dB |
ÖKO-FAVORIT 5270 U ... |
14 l ............ |
1,05 kWh ........... |
16 l ........... |
1,25 kWh ...... |
47 dB |
ÖKO-FAVORIT 6280 i ..... |
13 l............ |
0,95 kWh ........... |
15 l ........... |
1,15 kWh ...... |
43 dB |
ÖKO-FAVORIT 5280 i ..... |
13 l............ |
0,95 kWh ........... |
15 l ........... |
1,15 kWh ...... |
45 dB |
ÖKO-FAVORIT 5270 i ..... |
14 l............ |
1,05 kWh ........... |
16 l ........... |
1,25 kWh ...... |
47 dB |
ÖKO-FAVORIT 4270 i ..... |
14 l............ |
1,05 kWh ........... |
16 l ........... |
1,25 kWh ...... |
47 dB |
ÖKO-FAVORIT 6270 vi ... |
13 l ............ |
1,05 kWh ........... |
15 l ........... |
1,25 kWh ...... |
43 dB |
ÖKO-FAVORIT 5270 vi ... |
14 l ............ |
1,05 kWh ........... |
16 l ........... |
1,25 kWh ...... |
47 dB |
ÖKO-FAVORIT 3270 vi ... |
15 l ............ |
1,10 kWh ........... |
17 l ........... |
1,30 kWh ...... |
49 dB |
|
|
|
|
|
|
Programme Table
|
|
intensive |
normal |
normal |
economy |
quick |
pre-rinse |
|
|
70 ° / 65 ° |
65 ° |
BIO 50 ° |
BIO 50 ° |
50 ° / 40 ° |
|
6080 |
/ 6280 u / 6280 i |
70 ° |
X |
X |
X |
40 ° |
X |
5080 |
/ 5280 i |
70 ° |
X |
X |
- |
50 ° |
X |
5070 |
/ 5270 u / 5270 i |
70 ° |
X |
X |
- |
50 ° |
X |
4070 |
/ 4270 i |
65 ° |
- |
X |
- |
50 ° |
X |
6270 vi |
70 ° |
X |
X |
X |
40 ° |
X |
|
5270 vi |
70 ° |
X |
X |
- |
50 ° |
X |
|
3270 vi |
- |
X |
X |
- |
50 ° |
- |
04.99 HV 83-N
H:\H1\GSP\TECHNIK\AEGHB\137201GB.P65
Dishwasher |
292292137203 |
Easytronic Dishwashers with Flow Heater - Fully Integrated, Integrated, Built Under, Freestanding
Technical Data
Components
Interference Filter
The interference filter is connected in the terminal board parallel to the mains feed.
Pressure Switch
The pressure switch controls the water level.
Without water, contact 11 - 12 is closed.
fN |
Switch point with level |
65 mm Ws |
|
Reset point with level |
45 mm Ws |
fS |
Switch point with safety level |
114 mm Ws |
|
Reset point |
90 mm Ws |
The pressure switch is not adjustable.
fS |
17 |
fS |
17 |
16 |
16 |
||
fN |
12 |
fN |
12 |
11 |
11 |
||
|
14 |
|
14 |
65 mm
45 mm
Flow Heater
The flow heater heats the water to the required temperature. During the wash cycle, water is contantly passing through the flow heater.
Power output |
2100 W |
Resistor |
25 Ω |
Protector |
98 °C ± 5 K |
Thermal fuse |
260 °C |
04.99 |
|
HV 83-N |
|
Dishwasher |
292292137204 |
Easytronic Dishwashers with Flow Heater - Fully Integrated, Integrated, Built Under, Freestanding
Technical Data
Circulation Pump
The circulation pump is driven by an asynchronous motor with an auxiliary winding. The auxiliary winding ist in circuit with a 4 mF capacitor. A tacho generator is used for speed control.
There are three speeds for rinsing1600 1/min 2000 1/min 2800 1/min
Power output 50 W
Drain Pump
The drain pump is driven by a synchronous motor.
Power output 30 W.
Pump rate 15 l/min.
H:\H1\GSP\TECHNIK\AEGHB\137201GB.P65
NTC Temperature Sensor
NTC-Tem peraturfühler |
|
|
|
|
Tem perature sensor NTC-resistor |
|
|
|
|
Temperatur/Widerstand |
20 °C |
/ 6032 |
Ω |
|
temperature/resistor |
25 °C |
/ |
4829 |
Ω |
(nur bei vollelektron. |
30 °C |
/ |
3891 |
Ω |
Geschirrspüler) |
40 °C |
/ |
2573 |
Ω |
(only for fully electronic dishw asher) |
50 °C |
/ |
1741 |
Ω |
|
55 °C |
/ 1444 |
Ω |
|
|
60 °C |
/ 1204 |
Ω |
|
|
65 °C |
/ 1009 |
Ω |
|
|
70 °C |
/ |
849 |
Ω |
04.99 HV 83-N
Dishwasher |
292292137205 |
Easytronic Dishwashers with Flow Heater - Fully Integrated, Integrated, Built Under, Freestanding
Technical Data
Detergent / Rinse Aid Combination Dispenser Unit
Detergent dosage = 20 ml - 30 ml
Rinse Aid capacity |
150 ml |
Dosage settings |
1 - 6 |
Quantity |
1 cm3 - 6 cm3 |
H:\H1\GSP\TECHNIK\AEGHB\137201GB.P65
The detergent dispenser is activated by a release coil. The first operation adds the detergent, and the second the rinse aid. If the door is opened, the latching bar is reset to the detergent dosage position.
Input Module
The programs are selected via the input module, which is mounted in the door. All components are connected to this module.
Output Module
Depending on models displays are integrated into the output module.
o |
salt |
o |
rinse aid |
o |
water |
o |
filter |
o |
display |
o |
residual run time |
o |
delay start |
o |
fault display |
o |
water hardness |
o |
program cycle display |
Fully integrated control Panel
1Input module
2Output module
04.99 HV 83-N
release coil
1 2
H:\H1\GSP\TECHNIK\AEGHB\137201GB.P65
Dishwasher |
292137206 |
Easytronic Dishwashers with Flow Heater - Fully Integrated, Integrated, Built Under, Freestanding
Technical Data
Electronic
On electronic models, a micro processor controls all components, this is done using triacs. The electronic also memorizes all programme data.
2
Drying Fan
The drying fan sucks the humid air from the tub, and mixes it with dry air which is drawn up from in between the door panels (1) and blows it out through a vent situated below the door handle (2).
During the wash cycle the fan intake vent on the inside of the door is closed by a thermoelectric valve (3).
3 1
Servo Door Lock
Fully integrated dishwashers have a servo door lock. Once the program has started the door is locked automatically, however the door can be openend by using extra effort.
04.99 HV 83-N
H:\H1\GSP\TECHNIK\AEGHB\137201GB.P65
Dishwasher |
292292137207 |
Easytronic Dishwashers with Flow Heater - Fully Integrated, Integrated, Built Under, Freestanding
Technical Data
Water Softening |
|
|
The components required for water softening. |
|
|
1. |
softener unit |
2 |
2.regeneration dosage chamber
The incoming water flows through the softener which works according to the ion exchange principle. The ion exchanger is filled with small epoxy resin balls. The resins exchange the hardness constituents (calcium and magnesium), for sodium ions.
1
When all the sodium ions are used up, it is necessary to regenerate the softener. This is done by flushing a brine solution through the softener.
Afterwards the softener is washed out with fresh water and is now fully effective.
Depending on the water hardness, regeneration is only necessary after several wash cycles.
The softening system is designed for a water hardness of up to 50 °dH.
Position of Components
Detergent dispenser (1)
Drying fan intake vent (2)
Spray arms (3) |
3 |
|
|
|
3 |
1
2
input module (1) output module (2)
1 2
04.99 HV 83-N
Dishwasher |
292137208 |
Easytronic Dishwashers with Flow Heater - Fully Integrated, Integrated, Built Under, Freestanding
Technical Data
Detergent dispenser (1)
Drying fan (2)
1
2
H:\H1\GSP\TECHNIK\AEGHB\137201GB.P65
Electronic (1) |
|
Thermal sensor (2) |
|
Drain pump (3) |
1 |
Pressure switch (4) |
2 3 4
Flow heater (1)
Terminal board (2)
Inlet valve (3)
1
2
3
To remove side panel :
1Remove fixing screws
2Pull the panel away from the rear, and gently out of the front trim.
04.99 HV 83-N