Upright Vacuum Cleaner
Household Type
Owner’s Guide
Z2270-Z2290 Series
Index |
|
Important Safeguards |
.............2 |
Service Information ................ |
4 |
Assembly............................ |
5 -6 |
Use......................................... |
7 |
Thermal Cut Off............... |
4 & 7 |
Accessories............................ |
8 |
Brush Roll............................... |
9 |
Brush Roll Belt.................. |
9 - 10 |
Dust Bag......................... |
10 - 11 |
Hose Blockage ............... |
12 - 13 |
Motor Filter ........................... |
14 |
Bonus Hose.......................... |
15 |
Problem Solving ................... |
17 |
Guarantee............................... |
4 |
IMPORTANT
For any advice on your cleaner and to order dust bags, filters
and accessories, please telephone the Customer helpline 08706 055055
www.electrolux.com
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
To reduce the risk of fire, electric shock, or injury:
•Do not use outdoors or on wet surfaces.
•Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing.
•Do not allow to be used as a toy. Close attention is necessary when used by or near children.
•Use only as described in this manual. Use only manufacturer’s recommended attachments.
•Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center before using.
•Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run vacuum cleaner over cord. Keep cord away from heated surfaces.
•Do not use extension cords or outlets with inadequate current carrying capacity.
•Turn off all controls before unplugging.
•Do not unplug by pulling on cord.To unplug, grasp the plug, not the cord.
•Do not handle plug or vacuum cleaner with wet hands.
•Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow.
•This vacuum cleaner creates suction and contains a revolving brush roll. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
•Do not place cleaner on furniture or stairs as the brush roll may cause damage. Place cleaner on floor with the handle in storage position while using attachments.
•Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
•Do not use without dust bag in place.
•Belt pulleys can become hot during normal use.To prevent burns, avoid touching the belt pulley when servicing the drive belt.
•Use extra care when cleaning on stairs.
•Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present.
•Store your cleaner indoors in a cool, dry area.
•Keep your work area well lighted.
•Unplug electrical appliances before vacuuming them.
PLEASE SAVETHESE INSTRUCTIONS
WARNING
The brush in the cleaning head rotates at high speed and can cause damage to the mains supply cable if the cleaner passes over it during cleaning operations.
Care should be taken to ensure that this does not happen. If the cleaning head has accidentally passed over the mains supply cable the following action should be taken:
1. Switch off and remove the plug from the socket outlet.
2. Examine the mains supply cable for damage (only after removing the plug from the socket outlet).
3.If there is any sign of damage to the supply cable it MUST be renewed. The repair MUST be carried out by an Electrolux Service Agent or a similar qualified person.
4.NEVER use the machine with a damaged mains supply cable.
Proprietary carpet conditioning and air freshening materials
After using proprietary carpet conditioning powders, it is recommended that the filters be changed. Some of these preparations contain substances which if left in the vacuum cleaner for extended periods could damage the plastic mouldings which form the structure of the cleaner.
Many air fresheners, household deodorants, sprays and polishes contain a highly flammable gas propellant.
Because of this, it is particularly important that these products are used strictly in accordance with the relevant manufacturer’s instructions.
It is essential that none of the above products are sprayed directly into the vacuum cleaner or any of its filters, hose assembly, dustbag chamber or dust cup.
Thermal Cut Off
This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner switches off, push the switch pedal once and unplug the cleaner. Check the cleaner for a possible source of overheating such as a full dust cup, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 60 minutes before attempting to use the cleaner. After the 60 minute period, plug the cleaner back in and push the on/off switch On (I). If the cleaner still does not run, please call Electrolux Customer Care.
2
BEFOREYOU START
CHECK THE VOLTAGE
Before connecting the cleaner to an electrical supply, ensure that the voltage shown on the rating plate located beneath the cleaner is of the correct voltage for your electricity supply. If it is not, do not use the cleaner but refer back to your dealer.
CONNECTING TO YOUR ELECTRICITY SUPPLY
Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse.
In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux Retailers and must be of the same colour as indicated by the coloured insert on the base of the plug.
If difficulty is experienced in obtaining a replacement, contact Electrolux Customer Services on 08706 055055.
In no circumstances must the plug be used without a correct fuse cover fitted.
If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home.
The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. Brown: Live.
As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. This cleaner is double insulated and no earth connection is necessary.
It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, consult a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the guarantee.
|
Fuse |
|
|
13 Amp Fuse |
|
Cover |
|
|
|
|
|
|
|
13 Amp |
|
|
Fuse |
Blue |
Brown |
|
|
|
||
|
|
|
Cord |
|
|
|
|
|
|
|
|
|
|
Clamp |
The symbol |
on the product or on its packaging indicates that this product may not be treated as household waste. |
|||
Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
3
SERVICE
Should you require service on your Electrolux cleaner, please telephone Electrolux on 08706 055055. Before requesting service, please check whether your problem is covered under Service Checklist (see below).
New filter pads, dust bags, brush rollers and drive belts can be obtained from Electrolux Retailers. If difficulty is experienced in obtaining spares, please contact Electrolux on 08706 055055.
SERVICE CHECKLIST
•If your cleaner will not operate, check the plug connection, plug fuse and mains fuse.
•Never allow the dust bag to become so full that it impedes the air-flow, thus reducing the cleaning efficiency of the machine. The character of household dust and its effect on the air-flow through the machine may vary considerably. Fluffy dust allows air to pass through readily whereas fine powdery dust or proprietary cleaning powders, pack tightly in the dust bag, offering greater resistance to air-flow and will reduce cleaning efficiency if the bag becomes overloaded. Always ensure that you have a spare genuine Electrolux dust bag.
•Always store your cleaner and spare dust bags/filters in a dry place.
• Renew the filter pads three or four times a year. This is essential to ensure continued high filtration of dust particles.
•Sucking up such items as stockings, clippings of cloth, sizeable pieces of paper, wrappings from cigarette packets or sweets etc., may block the hose. Electrolux regrets that the clearing of blocked hoses cannot be regarded as service that can be given free of charge, under the guarantee. Should a blockage occur, first disconnect the cleaner from the electricity supply, refer to section headed “Blockages”. If these operations are not successful, contact us on 08706 055055.
•Never pick up hot cinders or lighted cigarette ends.
•Make certain that your cleaner does not come into contact with water or any other liquid. It is not designed as a wet pick up cleaner, and must never be used on damp carpets or wet floors.
Important - in the event of the mains supply cable of this vacuum cleaner requiring replacement, we recommend that this be carried out by Electrolux Service Staff.
Spares
New filters, dust bags, brush rollers and drive belts can be obtained from Authorised Electrolux Dealers and electrical retailers. If difficulty is experienced in obtaining spares please call us on 08706 055055.
Guarantee
This guarantee is in addition to your statutory and other legal rights. This product is for househould use only.
Electrolux products are carefully designed, manufactured, tested and inspected and, in consequence, we undertake to replace or repair any part found to be defective in material or workmanship, within one year of delivery to the original purchaser, free of charge.You may be required to take the product to your nearest service provider if the product requires attention during the first year.
There are certain conditions which may invalidate this guarantee:
a.It is dependent upon the appliance being correctly installed and used in accordance with the Company’s instructions under normal domestic conditions within the United Kingdom or the Republic of Ireland.
b.Service at all times must be carried out by an Electrolux Service Representative or authorised agent.
c.The guarantee may be invalidated by unauthorised repair or modification of the appliance.
d.You may be charged by Electrolux if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet. (example: blocked/dirty filters)
The Company does not accept liability for defects arising from neglect, misuse or accident. This guarantee excludes such normal wearing parts as drive belts, brushes, filters and dust bags as the life of these depends upon the amount and nature of use.
Proof of the date of purchase will be required before service under guarantee is provided. Please call 08706 055055 for assistance.
Important:
For future reference we suggest you record the following details here, and keep the receipt with the handbook as proof of purchase.
Purchased from_____________________________________________
Date purchased______________ Model no_______________________
4
HOWTO ASSEMBLE
CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts, make sure on/off switch is in off position before plugging in.
NOTE: Features may vary by model yet all parts assemble the same.
Step A Attach Handle |
Step B Store Hose and Accessories |
CAUTION: Do not catch cord under handle. |
|
|
Dusting |
|
Brush |
|
Upholstery |
|
Tool |
|
Hose |
|
Hook |
|
Hose |
|
Nested |
|
Extension |
|
Wands |
1. Remove bag cover.
2.From front of cleaner, align handle with groove and slide onto cleaner.If necessary, use thumb and finger pressure to slide handle into position.
3.Attach handle with 5/8 inch screw in the assembly packet.
Use a Phillips® head screwdriver. |
Hose |
|
|
|
Retainer |
5
Step C Check Disposable Dust Bag/Reusable Cloth Bag (on some models)
Inlet
Tube
Inlet
Handle Hole
Latch
4.Remove front cover.Press down on handle latch and lift cover away from cleaner.
5.Check to be sure the paper bag/reusable cloth bag inlet hole is secure on the inlet tube.
Step D Store Electrical Cord
Cord
Hook
Cord
Hook
6.Replace front bag cover.Place the tabs on the bottom of the front cover into slots at bottom of bag compartment and press cover against unit until it clicks shut.
7.Next wind the cord around the two cord hooks on the right side of cleaner. On some models the upper cord hook turns to release the cord. Turn the hook up to store the cord.
NOTE:For easier access to bag compartment,when you store the electrical cord use a figure 8 pattern.
8.Secure the plug to the cord to prevent unwinding.
6
Loading...