ADTRAN Total Access 1500 User Manual

0 (0)
Total Access® 1500
Dual 4-Wire TO Access Module
CONTENTS
1. GENERAL .............................................................. 1
2. INSTALLATION ................................................... 2
3. PROVISIONING .................................................... 5
4. TEST FEATURES ................................................. 6
5. MAINTENANCE ................................................... 6
6. SPECIFICATIONS................................................. 6
7. WARRANTY AND CUSTOMER SERVICE ........ 6
FIGURES
Figure 1. Dual 4-Wire TO...........................................1
Figure 2. Dual 4-Wire TO Menu Tree ........................ 5
TABLES
Table 1. Compliance Codes ...................................... 2
Table 2. Time Slot and Wiring Interconnect ....... 3, 4
Table 3. Dual 4-Wire TO Options ........................... 5
Table 4. Front Panel LEDs ....................................... 5
Table 5. Specifications ............................................. 7
Section 61180212L2-5A
Issue 1, July 2002
CLEI Code: VAL230JA_ _
DUAL
TO
1180212L2
1
2
STATUS
1. GENERAL
This practice provides installation and maintenance procedures for the ADTRAN Total Access 1500 Dual 4-Wire Transmit Only (TO) Access Module. Figure 1 is an illustration of the Total Access 1500 Dual 4-Wire TO.
Revision History
This is the initial release of this document. Future revisions to this document will be explained in this subsection.
General Description
The Dual 4-Wire TO Access Module is intended to be deployed in the Total Access 1500 Chassis. The Dual 4-Wire TO provides for two individual 4-wire analog interfaces between a VF transmission facility and the Total Access 1500 Pulse Coded Modulation (PCM) backplane. Each TO interface provides 4-wire voice-grade (analog) data services with no signaling associated with the circuit, or where signaling is provided by in-band tones.
Figure 1. Dual 4-Wire TO
Features
The features of the Dual 4-Wire TO (P/N 1180212L2) include the following:
• Two independent DC-isolated 4-wire VF channel interfaces
• Extended operating temperature range from
-40ºC to +65ºC
• TLP transmit input range of +5.0 to -16.0 dBm in
0.1 dB increments
• TLP receive output range of +8.5 to -9.5 dBm in
0.1 dB increments
• Supports configurations for Sink, Source or No Sealing Current
• Provisioning by craft interface or Site Manager
• Digital Loopback and 1004 Hz Digital Reference Signal (DRS) Tone Tests via craft port or Site Manager
• NEBS Level 3 and UL 1950 compliant
61180212L2-5A Section 61180212L2-5, Issue 1 1
Trademarks: Any brand names and product names included in this document are
trademarks, registered trademarks, or trade names of their respective holders.
2. INSTALLATION
C A U T I O N
C A U T I O N
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
HANDLING PRECAUTIONS REQUIRED.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
!
2. This device must accept any interference received, including interference that may cause undesired operation.
Remove the Total Access 1500 Dual 4-Wire TO from the carton and visually ensure that damage has not occurred during shipping or handling. If damage has occurred, file a claim with the carrier, then contact ADTRAN. Refer to Warranty and Customer Service section of this practice.
The Dual 4-Wire TO inserts into any Access Module slot (1 through 24) of the Total Access 1500 chassis.
To install the Dual 4-Wire TO access module, perform the following steps:
1. Hold the unit by the front panel while supporting the bottom side.
2. Align the card edges to the guide grooved for the designated slot.
3. Insert the card until the edge connector seats firmly into the backplane.
4. Push the ejector in place to ensure the unit is fully seated.
Compliance
Table 1 shows the Compliance Codes for the Dual 4-Wire TO. The Dual 4-Wire TO complies with UL 1950, third edition. It is intended for installation in restricted access locations only and in equipment with a Type “B” or “E” installation code.
Changes or modifications not expressly approved by ADTRAN could void the user’s authority to operate this equipment.
Time Slot Assignments
For time slot assignments in the Dual T1 mode and in the Quad T1 mode, refer to Table 2.
The Total Access 1500 platform can have multiple time slots in the T1 data stream assigned to each physical slot in the channel bank. The Total Access 1500 allows craft selectable time slots using the electronic provisioning interface. The system will automatically map DS0s in the T1 as determined by the LIU operational configuration. Manual mapping is available via the LIU menu.
Connections
Four 50-pin male amphenol connectors on the rear of the Total Access 1500 chassis provide the interconnect wiring for each of the access module physical slots. The Dual 4-Wire TO requires P1 (T/R) and P2 (T1/ R1) for the odd ports of each access module, while P3 (T/R) and P4 (T1/R1) for the even ports. See Table 2 for wiring interconnect details.
Code Input Output
Power Code (PC) C C Telecommunication Code (TC) X Installation Code (IC) A
2
Table 1. Compliance Codes
Section 61180212L2-5, Issue 1
61180212L2-5A
Table 2. Time Slot and Wiring Interconnect
lacisyhP
tolS
11A
23A
35A
47A
59A
1TlauD)4D(1TdauQ)D1D(1TdauQ
1A
2A
4A
6A
8A
01A
2A
5A
6A
9A
01A
31A
41A
71A
81A
OSD/1TdetaicossAtroPlonehpmA
1A
3A
9A
11A
71A
91A
2A
4A
01A
21A
1
2
1
2
1
2
1
2
1
2
tcennocretnI
noitcennoC
1/62-1P 1/62-2P 1/62-3P 1/62-4P
2/72-1P 2/72-2P 2/72-3P 2/72-4P
3/82-1P 3/82-2P 3/82-3P 3/82-4P
4/92-1P 4/92-2P 4/92-3P 4/92-4P
5/03-1P 5/03-2P 5/03-3P 5/03-4P
gniriW
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
611A
731A
851A
971A
0191A
1112A
12A
21A
41A
61A
81A
02A
22A
22A
1B
2B
5B
6B
9B
01B
31B
41B
51B
61B
81A
02A
1B
3B
9B
11B
71B
91B
2B
4B
01B
21B
1
2
1
2
1
2
1
2
1
2
1
2
6/13-1P 6/13-2P 6/13-3P 6/13-4P
7/23-1P 7/23-2P 7/23-3P 7/23-4P
8/33-1P 8/33-2P 8/33-3P 8/33-4P
9/43-1P 9/43-2P 9/43-3P 9/43-4P
01/53-1P 01/53-2P 01/53-3P 01/53-4P
11/63-1P 11/63-2P 11/63-3P 11/63-4P
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
R/T
1R/1T
2132A
42A
61180212L2-5A Section 61180212L2-5, Issue 1 3
12B
22B
81B
02B
1
2
21/73-1P 21/73-2P 21/73-3P 21/73-4P
R/T
1R/1T
R/T
1R/1T
Loading...
+ 5 hidden pages