Addonics Technologies ST6ESA, ST4ESA, ST4US-B, ST4SAML, ST5X1PM User Manual

...
0 (0)

Addonics

T E C H N O L O G I E S

Storage Tower

ST4IDEU2, ST4SAML, ST5X1PM, ST5XHPM,

ST4US, ST4ESA, ST6ESA, ST5ESAIUS, STMPC, STBTO ST4IDEU2-B, ST4SAML-B, ST5X1PM-B, ST5XHPM-B, ST4US-B, ST4ESA-B, ST6ESA-B, ST5ESAIUS-B, STMPC-B

User’s Guide

Version 1.0

FCC Warning Statement

This equipment has been tested and found to comply with the limits for a class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interf erence in a residential installation. This equipment generates, uses and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try and correct the interference by one or more of the following suggestions.

Reorient or relocate the receiving antenna

Increase the distance between the equipment and the receiver

Connect the equipment to a different power outlet other than the one where receiver is connected

Consult a certified television or radio technician

Storage Tower Overview

Model: ST6ESA

Model: ST4US

Model: ST4IDEU2

Model: ST5X1PM

Addonics Technologies ST6ESA, ST4ESA, ST4US-B, ST4SAML, ST5X1PM User Manual

Storage Tower Preparation

Side panel screw locations

Side panel

Remove the side panel screws.

Slide the side panel towards the backside then pull or lift to open.

To remove the front face panels, unscrew 2 screws on opposite sides of the 5 ¼” drive bay on the tower

Sample Installation on the tower using IDE hard drives

IDE Drives

Screw Holes

IDE drives Mounting

Brackets

Front Face Plates

Make sure that screws are placed for both sides of the mounting bracket to secure the drives.

This picture shows the storage tower without both the side panels and front faceplate.

After installing the hard drive, attach the side panels back to the storage tower.

Loading...
+ 5 hidden pages