Page 1
www.Accessible-Bathrooms.com
FREE
Care and Cleaning
Care & Cleaning of Gelcoat Units
Abrasive cleaners must not be used on any gelcoat unit as they may scratch and dull the surface. To clean the unit after
installation, use warm water and one of the stronger liquid detergents, such as: Top Job, Liquid Ajax or Mr. Clean. Use these
liquid detergents for normal day-to-day cleaning also. Minor stains can be spot removed with a household strength
ammonia or bleach.
DO NOT USE BLEACH ON STAINLESS STEEL OR METAL FINISHES. This will cause permanent corrosion.
Plaster can be removed with a nylon or polypropylene scrubber. Do not use steel wool, metal scraper, wire brush or other
metal tools. One of the powder type detergents, such as Spic & Span, may be used on a damp cloth to provide mild abrasive
action to remove residue plaster.
A periodic scrub down with a gel gloss or a dishwashing detergent (wear rubber gloves) will usually remove any soap or
mineral deposits. Periodic waxing with an automotive polish followed by a light application of liquid was, such as Johnson's
Jubilee will add luster and preserve the nish.
OM
SHOWERS
Lighted smoking materials will leave burn marks on berglass products. This or other similar damages can often be repaired
by rubbing the aected area with an automotive type polishing compound, such as Dupont No. 7, followed by an automotive
body wax, such as Simoniz. More severe burns require careful sanding with 400-600 grit wet carborundum sandpaper and a
nal rub out with the automotive polishing compound and wax.
Extensive damage can be completely repaired. Such repair work should be performed by a professional service repairman in
your area. If local service is not available, or if you need further assistance, contact Accessibility Professionals. Repair kits with
gelcoat included may be purchased through customer service by calling 1-877-947-7769.
If the unit received has a painted applied textured oor please use the box which contained the unit as a mat in the unit while
doing any plumbing in the unit. This will protect the painted surface and reduce clean-up to a minimum. If dirt does get on
the painted surface use any liquid cleaner (Ajax, Pine Sol, etc.) to clean it.
9677-749-778-1 moc.smoorhtaB-elbisseccA.www
Loading...