QUICK START GUIDE
KICK Personal Bluetooth Speaker
1 |
Fully charge Kick for at least 2 hours through a |
wall outlet before first use (see step ). |
|
2 |
To recharge Kick |
|
Insert the supplied USB 2.0 cable (micro USB |
|
end a ) into Kick’s 5V input port b . Insert USB |
|
end of cable c into the USB 2.0 port of your |
|
wall adaptor, laptop or PC d . |
|
b |
|
h |
|
a |
|
e |
3 |
Pairing Kick for the first time with your device |
Enable your device’s (eg. smartphone or tablet) Bluetooth. Slide the Power Button h to ‘ON’ to turn Kick on. It will make a sound and the
Bluetooth/Speakerphone button e will flash blue. Hold down the Bluetooth/Speakerphone button
e for 4 seconds and wait for a tone. Kick should appear in your device’s paired devices list. ‘Pair’ your device with Kick. Kick will then make another tone to confirm the pairing. You are now free to play music & audio through Kick. Adjust the volume of Kick through your device’s volume settings. For every pairing after your first, you only need to turn on your device’s Bluetooth, turn on Kick and hold down Bluetooth/Speakerphone button e for 4 seconds. See tips adjacent for other button uses.
d
c
d
Bluetooth Audio
•Press e for four seconds to enter Bluetooth Mode.
•Press e for 1 second to pause/play.
•When the speaker is in standby, press e for 4 seconds to change between Bluetooth and AUX Mode.
Speakerphone
•Press e to pick up or hang up an incoming call (while in Bluetooth Mode only).
•Press e for 2 seconds to reject a call.
Important Safety Information
PLEASE READ BEFORE OPERATION
1.Before recharging Kick through a wall outlet make sure wall outlet voltage is 5V.
2.Make sure to use a standard USB 2.0 Charge & Sync Cable with the appropriate specifications - other
cables may damage your smartphone, tablet or Kick.
3.Do not drop, knock, dissasemble or attempt to repair Kick.
4.Do not immerse or put Kick in water and keep Kick in a dry place.
5.Do not expose Kick to excessive heat including sunlight and fire.
6.Do not use Kick near explosive gases or flammable materials.
7.Do not burn or incinerate Kick.
8.Do not expose Kick to harsh chemicals.
9.Turning Kick’s volume up to the max shortens the life of Kick. It also may damage your hearing.
10.Putting anything in Kick’s input or output ports, other than a standard USB 2.0 charge & sync cable will cause damage or short out Kick.
11.When encountering any fault during operation, please cut off the power supply and disconnect the USB cable to prevent further damage to the speaker or other components.
12.The Bluetooth transmission range or connectivity could be affected by low battery power. In that case, recharge immediately.
For more information visit www.3sixtgear.com/support |
3S-0336/0337/0338/0339 |
Loading...