ZyXEL Communications P-660HW-Dx User Manual

0 (0)

P-660HW-Dx v2

802.11g Wireless ADSL2+ 4-port Gateway

Quick Start Guide

Version 3.40

3/2007

Edition 1

P-660HW-Dx v2 Quick Start Guide

Overview

The P-660HW-Dx v2 is a wireless ADSL router with a four-port built-in switch.

This Quick Start Guide shows you how to use the P-660HW-Dx v2 to connect to the Internet and how to configure the device settings to connect wirelessly.

See your User’s Guide for background information on all features.

Quick Login Information

LAN IP address

http://192.168.1.1

 

 

default administrator password

1234

 

 

How to use the included CD

For a multimedia animation of how to make hardware connections, see the installation tutorial on the included CD.

1On the included CD, click Setup > Multimedia Auto Provisioner

2At the end of the tutorial, use Configuration Genie to set up your P-660HW-Dx v2 to connect to the Internet.

2

ZyXEL Communications P-660HW-Dx User Manual

P-660HW-Dx v2 Quick Start Guide

1 Hardware Connections

1DSL: Use the gray telephone wire to connect your P-660HW-Dx v2’s DSL port to a telephone jack (or to the modem port on a splitter if you are using one).

2ETHERNET: Use the yellow Ethernet cable to connect a computer to an ETHERNET port for initial configuration and/or Internet access.

3POWER: Use the included power adaptor to connect an appropriate power source to the POWER socket. Make sure the power source is on.

4Push in the POWER button.

5Look at the lights on the front panel.

3

P-660HW-Dx v2 Quick Start Guide

The POWER light blinks while your P-660HW-Dx v2 starts up and stays on once it is ready.

Each ETHERNET light stays on if the corresponding ETHERNET port is properly connected and blinks when there is traffic.

The DSL light is on when the P-660HW-Dx v2 has a DSL connection.

The INTERNET light is on when you are able to access the Internet and blinks when the P-660HW-Dx v2 is sending or receiving data. Wait a couple of minutes while your device checks the connection.

If any of these lights are not on, check your connections and inspect your cables for damage. If the lights are still off, contact your local vendor.

2 Internet Connection Setup: Automatic

Use this section to have your P-660HW-Dx v2 automatically detect and set up your Internet connection.

1Open your web browser to a website. Wait while your P-660HW-Dx v2 tries to detect your DSL connection to your ISP. This may take a few minutes.

2After it detects the connection, the DSL light shows green on your device and the Internet light comes on when the Internet is ready for you to use. If you have a PPPoE connection, you will have to enter your user name and password.

3Go to section 3 if you wish to configure your wireless settings.

4If you do not see the connection test screen, or the connection test is not successful, follow the instructions in the screen below, or check your connections and restart the P-660HW-Dx v2. If you still cannot access the Internet, follow the steps in section 3.

3 Internet and Wireless Setup Wizard

Use this wizard to connect to the Internet and configure your wireless settings.

Follow these steps to access the Internet and Wireless Setup Wizard:

1 Open your browser and enter the following URL address: http://192.168.1.1.

4

Loading...
+ 7 hidden pages