NX-E200
Speaker System
Systeme D’enceintes
OWNER’S MANUAL
MODE D’EMPLOI
1
Thank you for selecting this Yamaha NX-E200 speaker system.
PRECAUTIONS
Read this before using the speakers.
•To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.
•Install the speakers in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the speakers to rain or water.
•To prevent the enclosure from warping or discoloring, do not place the speakers where they will be exposed to direct sunlight or excessive humidity.
•Do not place the following objects on the speakers: Glass, chine, etc.
If glass etc. falls by vibrations and breaks, it may cause personal injury.
A burning candle etc.
If the candle falls by vibrations, it may cause fire and personal injury.
A vessel with water in it
If the vessel falls by vibrations and water spills, it may cause damage to the speakers, and/or you may get an electrical shock.
•Do not place the speakers where foreign objects such as water drips might fall. It might cause a fire, damage to the speakers, and/or personal injury.
•Do not place the speakers where they are liable to be knocked over or struck by falling objects. Stable placement will also ensure better sound performance.
•Placing the speakers on the same shelf or rack as the turntable can result in feedback.
•Any time you note distortion, reduce the volume control on your receiver to a lower setting. Never allow your receiver to be driven into “clipping”. Otherwise the speakers may be damaged.
•When using a receiver with a rated output power higher than the nominal input power of the speakers, care should be taken never to exceed the speakers' maximum input.
•Do not attempt to clean the speakers with chemical solvents as this might damage the finish. Use a clean, dry cloth.
•Do not attempt to modify or fix the speakers. Contact qualified YAMAHA service personnel when any service is needed. The cabinet should never be opened for any reasons.
•Secure placement or installation is the owner's responsibility.
YAMAHA shall not be liable for any accident caused by improper placement or installation of speakers.
CONNECTION TO YOUR RX-E200
RECEIVER
BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE RX-E200 RECEIVER IS SWITCHED OFF.
•When this unit is connected to the RX-E200 receiver, refer also to the owner's manual supplied with the receiver.
■ CONNECTIONS
•Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the receiver with the provided speaker cables.
•One side of the speaker cable is red and the other side is black. Connect the (+) terminals on the receiver and speakers using the red side. Connect the (–) terminals on both components using the black side of the cable.
•Connect one speaker to the left (marked L) terminals of the receiver, and the other to the right (marked R) terminals. Make sure not to reverse polarity (+, –).
If a speaker is connected with reverse polarity, the sound will be unnatural and lack bass.
Loosen
Tighten
Black (–)
Red (+)
Red line
Speaker (R) |
Speaker (L) |
Red line 
Black line 
Speaker output terminals of the receiver
RX-E200
2
Loading...