® Trademark
Please do not return unit to retailer.
Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l’outil au détaillant.
1-800-554-6723
Register your product online at: Registre su producto en línea en:
Enregistrez votre produit en ligne à l’adresse : www.weedeater.com
|
Instruction Manual |
|
Manual de Instrucciones |
245157 |
Manuel d’Instructions |
WE EL-11
WARNING:
Read and follow all Safety Rules and Operating Instructions before
using this product. Read instructions carefully before assembling. Failure to do so can result in serious injury.
ADVERTENCIA:
Lea el manual del operador y siga todas las advertencias e instruc-
ciones de seguridad. Antes de ensamblar el producto lea cuidadosamente el instructivo. El no hacerlo puede resultar en lesiones gra-
ves.
AVERTISSEMENT:
Veuillez lire le manuel de l’utilisateur et bien respecter tous les avertissements et toutes les instructions de sécurité. Bien lire les
instructions avant d’assembler l’outil. Tout défaut de le faire pourrait entraîner des blessures graves.
WEED EATER |
WEED EATER |
7349 Statesville Road |
850 Matheson Blvd. West |
Charlotte, NC 28269 |
Mississauga, Ontario L5V 0B4 |
115253326 Rev.3 05/07/10 JBW
ENGLISH
LOÑAPSE
SIAÇNARF
SAFETY RULES
WARNING: When using electric gar-
dening appliances, basic safety precautions must always be followed to reduce the risk of fire, electric shock, and serious injury. Read and follow all instructions.
SAFETY INFORMATION
ON THE UNIT
This power unit can be dangerous! Operator is responsible for following the warnings and
instructions in this manual and on the unit. Read entire instruction manual before using unit! Be thoroughly familiar with the controls and the proper use of the unit. Restrict the use of this unit to persons who read, understand, and follow unit and manual warnings and instructions. Never allow children to operate this unit. Close attention is necessary when used near children.
DANGER: Never use blades or flail-
ing devices. Unit is designed for line trimmer use only. Use of any other accessories or attachments will increase the risk of injury.
WARNING: Trimmer line throws ob-
jects violently. You and others can be blinded/ injured. Wear safety glasses, boots, and leg protection. Keep body parts clear of rotating
line.
Safety Glasses or similar eye protection
|
Hazard Zone |
|
15 m |
Boots |
50 ft. |
|
Keep children, bystanders, and animals 50 feet (15 meters) away. If approached stop unit immediately.
If situations occur which are not covered in this manual, use care and good judgement. If you need assistance, call 1-800-554-6723.
OPERATOR SAFETY
S Dress properly. Always wear safety glasses or similar eye protection when op-
erating, or performing maintenance on your unit. (Safety glasses are available.) Always wear face or dust mask if operation is dusty. Always wear heavy, long pants, long sleeves, boots, and gloves. Do not go barefoot or wear sandals.
SSecure hair above shoulder length. Secure or remove loose clothing and jewelry or
clothing with loosely hanging ties, straps, tassels, etc. They can be caught in moving parts.
SBeing fully covered also helps protect you from debris and pieces of toxic plants
thrown by spinning line.
SStay Alert. Do not operate unit when you are tired, ill, upset or under influence of al-
cohol, drugs, or medication. Watch what you are doing; use common sense.
S Avoid unintentional starting of the unit. Never carry unit with your finger on the switch. Be sure the switch is in the OFF position and never touch the switch when connecting extension cord.
ELECTRICAL SAFETY
WARNING: Avoid a dangerous environment. To reduce the risk of electrical shock, do not use in rain, in damp or wet loca-
tions, or around swimming pools, hot tubs, etc. Do not expose to snow, rain, or water to avoid the possibility of electrical shock.
S Use a voltage supply as shown on unit.
SAvoid dangerous situations. Do not use in the presence of flammable liquids or gases to avoid creating a fire or explosion and/or causing damage to unit.
STo reduce the risk of electrical shock, this equipment has a polarized plug (one blade is wider than the other) and will require the use of a polarized extension cord. The appliance plug will fit into a polarized extension cord only one way. If the plug does not fit fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension cord will require the use of a polarized wall outlet. This plug will fit into the polarized wall outlet only one way. If plug does not fit fully into the wall outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or extension
cord plug in any way.
STo reduce risk of electrical shock, use extension cords specifically marked as suitable for outdoor appliances having electrical rating not less than the rating of unit. Cord must be marked with suffix “W--A” (in Canada “W”). Make sure your extension cord is in good condition. Inspect extension cord before use and replace if damaged. Do not use a damaged cord. Cord insulation must be intact with no cracks or deterioration. Plug connectors must be undamaged. An undersized extension cord will cause a drop in line voltage resulting in loss of power and overheating. If in doubt, use the next heavier gauge. The lower the gauge number, the heavier the cord (see SELECT AN
EXTENSION CORD in the OPERATION section).
S Do not use multiple cords.
2
SDo not abuse cord. Never carry the unit by the extension cord or yank extension cord
to disconnect unit.
SUse cord retainer to prevent disconnection of extension cord from unit and possible damage to the unit due to plug movement (see ATTACH THE EXTENSION CORD
TO YOUR TRIMMER in the OPERATION section).
SDo not use the unit if the switch does not turn the unit on and off properly. Repairs to the switch must be made by your autho-
rized service dealer.
S Keep the extension cord clear of operator and obstacles at all times. Do not expose cords to heat, oil, water, or sharp edges.
S To avoid the possibility of electric shock,
avoid body contact with any grounded conductor, such as metal fences or pipes.
S Ground Fault Circuit Interrupter (GFCI) protection should be provided on circuit or outlet to be used. Receptacles are available having built-in GFCI protection and may be used for this measure of safety.
UNIT SAFETY
SInspect unit before use. Replace damaged parts. Make sure all handles, guards, and fasteners are in place and securely fastened. Parts that are damaged must be repaired or replaced by an authorized service dealer These include head parts that are
cracked, or chipped, guards, and any other part that is damaged.
S Do not repair unit yourself.
S Use only 0.065 inch (1.65 mm) diameter recommended trimmer line (see USER REPLACEABLE SERVICE PARTS in the SERVICE AND ADJUSTMENTS section). Never use wire, rope, string, etc.
S Use specified trimmer spool. Make sure
spool is properly installed and all parts are securely fastened.
SUse only WEED EATER replacement parts and accessories as recommended.
CUTTING SAFETY
WARNING: Inspect area to be cut. Remove objects (rocks, broken glass, nails, wire, string, etc.) which can be thrown or become entangled in cutting head.
SDo not overreach or stand on unstable support. Keep firm footing and balance.
SKeep the cutting head below waist level. Do not raise handles above your waist. Cutting head can come dangerously close to your
body.
SKeep away from cutting head and spinning line.
S Use unit properly. Use only for trimming, scalping, and mowing. Do not force unit. It will do the job better and with less risk of injury at the rate for which it was designed.
S Use only in daylight or in good artificial light.
MAINTENANCE SAFETY
WARNING: Disconnect unit from the power supply before performing maintenance, or when changing trimmer line.
S Maintain unit according to recommended procedures. Keep cutting line at proper length. Follow instructions for changing trimmer line.
SHave all service and maintenance not explained in this manual performed by an au-
thorized service dealer to avoid creating a hazard.
SNever douse or squirt the unit with water or any other liquid. Clean unit and labels with
a damp sponge. Keep handles dry, clean, and free from oil and grease.
SKeep the air vents clean and free of debris to avoid overheating the motor. Clean after each use.
TRANSPORTING AND STORAGE
S Stop the unit and disconnect the power source when not in use.
S Carry the unit with motor stopped.
SStore the unit so the line limiter blade (on underside of shield) cannot cause injury.
SStore unit indoors in a high, dry place out of the reach of children. Store unit unplugged.
SDo not hang unit so that the trigger switch is depressed.
DOUBLE INSULATION CONSTRUCTION
This unit is double insulated to help protect against electric shock. Double insulation construction consists of two separate “layers” of electrical insulation instead of grounding.
Tools built with this insulation system are not
intended to be grounded. No grounding means is provided on this unit, nor should a means of grounding be added to this unit. As a result, the extension cord used with your unit can be plugged into any standard 120 volt electrical outlet.
Safety precautions must be observed when operating any electrical tool. The double insulation system only provides added protection against injury resulting from an internal
electrical insulation failure.
WARNING: All electrical repairs to
this unit, including housing, switch, motor, locking sleeve assembly, wires, etc., must be diagnosed and repaired by qualified service personnel. Replacement parts for a double insulated appliance must be recommended by the manufacturer. A double insulated appliance is marked with the words “double insulation” or “double insulated”. The symbol
(square within a square) 
may also be
marked on the appliance. Failure to have the unit repaired by qualified service personnel can cause the double insulation construction to become ineffective and result in serious injury.
SAVE THESE INSTRUCTIONS
3
Loading...