VTech LS6325-2, LS6325-4, LS6326-5, LS6325, LS6325-5 User Manual

...
0 (0)
VTech LS6325-2, LS6325-4, LS6326-5, LS6325, LS6325-5 User Manual

Quick start guide

for models LS6325/LS6325-2/LS6325-3/ LS6325-4/LS6325-5/LS6326-5

Install the telephone base and charger(s)

Install the telephone base and charger(s) as shown below.

Telephone wall jack

If you have DSL high speed Internet service, a DSL filter (not included) is required.

Telephone line cord

Telephone base power

adapter

Charger adapter

Electrical outlet not controlled by a wall switch

Charger

Telephone base

Battery installation and charging

Install the battery as shown below. After installing the battery, you may be able to make and receive short calls. For best performance, charge the handset battery for at least 16 hours before use.

1

2

If the battery compartment cover is on the handset, press on the indentation and slide the cover to remove.

Plug the battery connector securely into the socket inside the handset battery compartment, matching the color-coded label.

3

4

Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment.

Align the cover flat against the battery compartment, then slide it towards the center of the handset until it clicks into place.

Use only the power adapters and batteries supplied with your VTech telephone.

For complete feature instructions, please refer to your user’s manual.

5

Charge the handset by placing it in the telephone base or charger. The CHARGE light is on when the handset charges.

CHARGE light

Make, answer and end a call Make a call

1. Press /FLASH or . You hear a dial tone.

2. Dial the number.

Make a predial call

1. Dial the number.

2. Press /FLASH or .

Answer a call

Press /FLASH, or any of the dialing keys (0-9, #, TONE).

End a call

Press OFF/CLEAR or put the handset in the telephone base or charger.

Push to talk (PTT)

You can directly broadcast messages from one handset to the speakerphone of one or all other handsets. Any handset you call can respond by pressing PUSH TO TALK to begin a two-way communication.

When the connection is made, both the caller and the destination handsets display Press and hold [PTT] to talk and beep once.

Only one handset can be talk at a time. To do so, press and hold PUSH TO TALK.

For complete PTT instructions, please refer to your user’s manual.

Loading...
+ 1 hidden pages