User’s Guide
CPSMM-120
Single-Slot Master Management Module
Transition Networks CPSMM-120 Single-Slot master management module enables network management of a single PointSystem™ chassis (CPSMC0200-2x0, CPSMC0800-100, CPSMC13xx-100, CPSMC18xx-xxx and CPSMC19xx-100) and any installed media converter slide-in-modules.
The CPSMM-120 includes Transition Networks CPSMM100 firmware embedded in the module, which can be accessed via the DB-9 serial port or the 10Base-T RJ-45 Ethernet port.
Installing the CPSMM-120 . . . . . .3
Network Management . . . . . . . . .4
Operation . . . . . . . . . . . . . . . . . . .4
Technical Specifications . . . . . . . .5
Troubleshooting . . . . . . . . . . . . . .6
Contact Us . . . . . . . . . . . . . . . . . .7
Compliance Information . . . . . . . .8
CPSMM-120
CPSMM-120 Single-Slot Master Management Module
The figure below illustrates the components of the CPSMM-120 management module:
•A panel fastener screw that secures the management module to the
Pointsystem™ chassis.
•PWR (power), LINK, RX (receive), and TX (transmit) LED indicators.
•A reset switch, which resets ONLY the CPSMM-120 management module (not the chassis in which it is installed).
•A 10Base-T RJ-45 Ethernet port, through which the management module communicates, using the Ethernet network, with a remote Network management Station (NMS) or with a Telnet connection
•A DB-9 serial port, through which the management module communicates with the command-line interface.
Panel Fastener Screw
TX PWR |
|
|
LEDs |
RX LNK |
|
R |
Reset Switch |
S |
|
E |
|
E |
|
T |
|
T-10BASE |
RJ-45 Ethernet Port |
|
|
SERIAL |
DB-9 Serial Port |
|
|
CPSMM120 |
|
Application CD
The enclosed application CD contains:
1.CPSMM100 Firmware, which includes:
•a Command-Line Interface (CLI),
•a Telnet server,
•a Web browser, and
•an SNMP agent.
2.FocalPoint™ 2.0 Management Application, which can be used to monitor and control the PointSystem™ chassis from a remote location.
3.A User’s Guide, which describes in detail how to use both the
CPSMM100 firmware and the FocalPoint™ 2.0 management application.
Installing the CPSMM-120
The CPSMM-120 management module is designed to be installed into a Transition Networks PointSystem™ chassis to enable network management of any media converter slide-in-modules installed in the chassis. The following chassis are available:
•CPSMC0200-100, 2-slot PointSystem™ chassis
•CPSMC0800-100, 8-slot PointSystem™ chassis
•CPSMC13xx-100, 13-slot PointSystem™ chassis
•CPSMC18xx-xxx, 18-slot PointSystem™ chassis
•CPSMC19xx-100, 19-slot PointSystem™ chassis
|
TX PWR |
The CPSMM-120 management module is installed |
|
|
RX LNK |
in one of the Transition Network PointSystemTM chassis. |
|
|
RESET |
(Configuration for the 13-slot, 18-slot, or 19-slot chassis is shown here.) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Redundant Management
Two CPSMM-120 management modules may be installed in the same network. In this set-up, the two modules auto-negotiate; where one is the primary module while the other is in stand-by mode. If the primary module fails, the stand-by module automatically takes over and manages the network.
Replacing the CPSMM-120
The CPSMM-120 can be hot-swapped, that is, the CPSMM-120 can be replaced while the PointSystem™ chassis is powered. However, please note that:
•If there are two management modules installed in the same network, the stand-by module will continue to manage the network while the primary module is replaced. Also, the stand-by module will retain all network settings.
•If there is only one management module installed, all SNMP management operations will cease once the module is removed. The newly installed management module must be reconfigured to resume network management.
For more information on installing and replacing the CPSMM-120, see the user’s guide for the chassis in which the module will be installed. The chassis manuals can be found on the Transition Network website at: www.transition.com.
2 |
24-hour Technical Support: 1-800-260-1312 - International: 00-1-952-941-7600 |
techsupport@transition.com -- Click the “Transition Now” link for a live Web chat. |
3 |