Texas Instruments 3000 MCU User Manual
Size:
575.87 Kb
Download

T1 Remote Module Installation

Link Wireless Telephone System

Link 3000 MCU

Part Number: 72-0059-06

Issue E

SpectraLink Corporation

T1 Remote Module Installation

 

Link WTS – Link 3000 MCU

NOTICE

SpectraLink Corporation has prepared this document for use by SpectraLink personnel and clients. The drawings and specifications contained herein are the property of SpectraLink and shall be neither reproduced in whole or in part without the prior written approval of SpectraLink, nor be implied to grant any license to make, use, or sell equipment manufactured in accordance herewith.

SpectraLink reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult SpectraLink to determine whether any such changes have been made.

The terms and conditions governing the sale of SpectraLink hardware products and the licensing of SpectraLink software consist solely of those set forth in the written contracts between SpectraLink and its customers. No representation or other affirmation of fact contained in this document including but not limited to statements regarding capacity, response-timeperformance, suitability for use, or performance of products described herein shall be deemed to be a warranty by SpectraLink for any purpose, or give rise to any liability of SpectraLink whatsoever.

In no event shall SpectraLink be liable for any incidental, indirect, special, or consequential damages whatsoever (including but not limited to lost profits) arising out of or related to this document, or the information contained in it, even if SpectraLink has been advised, knew, or should have known of the possibility of such damages.

Trademark Information

SpectraLink LinkPlus

Link Wireless Telephone System NetLink Telephony Gateway NetLink Wireless Telephone NetLink SVP Server SpectraLink Voice Priority

ccLink Wireless Telephone System

are trademarks and registered trademarks of SpectraLink Corporation.

All other trademarks used herein are the property of their respective owners.

T1 Remote Module Installation

Link WTS

Link 3000 MCU

System Documentation

© 2002 SpectraLink Corporation.

All Rights Reserved

Printed in the United States of America

SpectraLink Corporation 5755 Central Avenue Boulder, CO 80301

Within the United States, dial 303.440.5330 or toll free 800.676.5465

Outside the U.S., dial +1.303.440.5330 www.spectralink.com

 

 

 

 

 

 

 

 

 

Part Number: 72-0059-06-E.doc

Page 2

SpectraLink Corporation

T1 Remote Module Installation

 

Link WTS – Link 3000 MCU

Note concerning the Master Control Unit:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Note concerning shielded cable:

SpectraLink recommends the use of shielded cable for all external signal connections in order to maintain FCC Part 15 emissions requirements.

Note concerning the Wireless Telephone and Base Stations:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

WARNING Changes or modifications to this equipment not approved by SpectraLink Corporation may cause this equipment to not comply with part 15 of the FCC rules and void the user’s authority to operate this equipment.

WARNING SpectraLink products contain nouser-serviceableparts inside. Refer servicing to qualified service personnel.

Part Number: 72-0059-06-E.doc

Page 3

SpectraLink Corporation

T1 Remote Module Installation

 

Link WTS – Link 3000 MCU

UL Information

This symbol on the nameplate means the product is listed by Underwriter’s Laboratories, Inc. It is designed and manufactured to meet rigid U.L. safety standards against X-radiation,fire, casualty, and electrical hazards.

The following are statements required for UL certification, related to safety procedures that must be adhered to during installation.

Follow these general precautions while installing telephone equipment:

Never install telephone wiring during a lightning storm.

Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

Use caution when installing or modifying telephone lines.

When installing Base Stations outside or in buildings other than the one containing the System Controller, take the following precaution:

If wiring for a Base Station exits a building—whetherto reach an outdoor Base Station location or to reach a Base Station in anotherbuilding—thewiring must be protected at both ends by a Quick Clip Fuse from Illinois Tool Works, Linx Division, model numberSCP-2X2.The Quick Clip Fuse replaces the bridging clips on the 66 blocks for all four connections to thenon-internalBase Station.

Part Number: 72-0059-06-E.doc

Page 4

SpectraLink Corporation

T1 Remote Module Installation

 

Link WTS – Link 3000 MCU

FCC Information

The Master Control Unit Complies with Part 68, FCC Rules

FCC Registration Numbers:

Link 3000: IYGUSA-7385Q-PX-T

Ringer Equivalence: Link 3000: 0.3B SpectraLink Corporation Link 3000

Made in the USA

This equipment complies with Part 68 of the FCC Rules. On the back of this equipment is a label that contains, among other information, the FCC Registration Number and Ringer Equivalence Number (REN) for this equipment. If requested, this information must be given to the telephone company.

This equipment uses RJ-21connectors.

The REN is useful to determine the quantity of devices you may connect to your telephone line and still have all of those devices ring when your number is called. In most, but not all, areas, the sum of the RENs of all devices connected to one line should not exceed five (5.0). To be certain of the number of devices you may connect to your line, as determined by the REN, you should contact your local telephone company to determine the maximum REN for your calling area.

If your telephone equipment causes harm to the telephone network, the telephone service may discontinue your service temporarily. If possible, they will notify you in advance. But if advance notice isn’t practical, you will be notified as soon as possible. You will be informed of your right to file a complaint with the FCC.

Your telephone company may make changes in its facilities, equipment, operations or procedures that could affect the proper functioning of your equipment. If they do, you will be notified in advance to give you an opportunity to maintain uninterrupted telephone service.

If you experience trouble with this telephone equipment, please contact SpectraLink Corporation for information on obtaining service or repairs.

SpectraLink Corporation 5755 Central Avenue Boulder, CO 80301 303-440-5330

The telephone company may ask that you disconnect this equipment from the network until the problem has been corrected or until you are sure that the equipment is not malfunctioning. There are no user serviceable parts in this equipment.

This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to state tariffs.

Part Number: 72-0059-06-E.doc

Page 5

SpectraLink Corporation

T1 Remote Module Installation

 

Link WTS – Link 3000 MCU

Industry Canada (IC) Notice

Notice:

The Industry Canada (IC) label identifies certified equipment. This certification means that the equipment meets telecommunications network protective, operational, and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The department does not guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made by a user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.

Notice: The Ringer Equivalence Number (REN) assigned to each terminal device provides as indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination of an interface may consist of any combination of devices.

REN 0.3B Approval Numbers:

Link 3000: 2128-9508A

Warranty and Repair Service Center:

SpectraLink Corporation 5755 Central Avenue Boulder, CO 80301 303-440-5330

DOC Spread Spectrum certification

Base Station

Cert. No.

2128-K1373

Wireless Telephone

Cert. No.

2128-K1374

Part Number: 72-0059-06-E.doc

Page 6

SpectraLink Corporation

T1 Remote Module Installation

 

Link WTS – Link 3000 MCU

Table of Contents

1. ABOUT THIS DOCUMENT

8

1.1

Contacting SpectraLink

8

1.2

Icons Used in this Document

8

1.3

Remote Installation Overview

9

1.4

Remote Installation Steps (Overview)

10

2.

SITE PREPARATION

11

 

2.1

Required Materials Provided by Customer

11

 

2.2

T1 Configuration Requirements

12

 

2.3

Check Components

13

3.

INSTALL T1 REMOTE MODULE AT LOCAL SITE

14

4.

INSTALL SYSTEM AT REMOTE SITE

17

 

4.1

Survey Site

17

 

4.2

Install Shelves

17

 

4.3

Connect Power to Shelves

18

 

4.4

Install Cards

18

 

4.5

Connect Cables to T1 Remote Module

19

 

4.6

Connect Multiple Remote Shelves

19

 

4.7

Connect Demarc Block RJ-21 Cables to Interface Modules

21

5.

CONFIGURE REMOTE SYSTEM

22

 

5.1

Configure Remote Shelf

22

 

5.2

Master Clock Configuration

23

 

5.3

Test System

23

6.

SITE CERTIFICATION

24

7.

INSTALLATION FORMS

25

 

7.1

Base Station Location Form

26

 

7.2

Extension Assignments Worksheet

27

 

7.3

Site Preparation Checklist

28

 

7.4

Customer Acceptance Form

29

Part Number: 72-0059-06-E.doc

Page 7