Targus Wireless Keypad & Mini Optical Mouse User Manual

Size:
207.89 Kb
Download

Targus Wireless Keypad

& Mini Optical Mouse

Making Your Mobile Life Easier.®

Visit our Web site at: www.targus.com Features and specifications are subject to change without notice.

© 2003 Targus Group International and Targus, Inc..400-0139-001A

USER’S GUIDE

Making Your Mobile Life Easier.®

BRUSSELSHANNOVERBARCELONATOKYOMILANOAMSTERDAMSINGAPORELONDONPARISNEWYORKLOSANGELESTORONTOHONGKONGSYDNEY

TARGUS WIRELESS

KEYPAD &

MINI OPTICAL MOUSE

Introduction

Congratulations on your purchase of the Targus Wireless Keypad and Mini Optical Mouse Combo Set. This combo set offers the latest technology for interference-freeoperation with 27MHz wireless connection and 4,096 IDs per channel. Both keypad and mouse feature on/off switch and auto power saving management for effective power conservation.

This user’s guide describes how to connect the receiver to your computer, install default software drivers and set up the radio link.

Contents

In addition to this user’s guide, this package contains:

Targus Wireless Keypad

Targus Wireless Mini Optical Mouse

USB Receiver

USB extension cable

4 AAA batteries (2 for mouse, 2 for keypad)

Carrying pouch

2

Targus Wireless Keypad & Mini Optical Mouse

System Requirements

To use the keypad and mouse, your computer must meet the following hardware requirements and run one of the operating systems listed below.

Hardware

PC with an Intel® Pentium® processor or equivalent

USB 1.1 interface

Operating System

• Windows® 98SE/Me/2000/XP

NOTE: The third button and the scrolling wheel of the mouse only work with the operating systems listed above. If you use the mouse with a different operating system, it will lose its enhanced features and function as a standard, two-buttonmouse.

Installing the Batteries

Optical Mouse

1Remove the battery cover from the top of the mouse by pressing the top center (over the Targus logo) and sliding it back..

Removing the battery cover

2Insert the supplied batteries, making sure that the positive (+) and negative (-)ends of each battery match the polarity indicators inside the battery housing.

3

Targus Wireless Keypad & Mini Optical Mouse

WARNINGS: When replacing the batteries, you may use alkaline or other heavy-dutyNiMH batteries. Never combine an alkaline with a NiMH battery in a device.

Avoid mixing new and used batteries in a device.

3Slide the battery cover back into position until it “clicks” firmly into place.

4Turn on the mouse by sliding the on/off switch on the bottom of the mouse to the “on” position.

The optical sensor, located on the bottom of the mouse, glows red.

Wireless Keypad

1Remove the battery cover located on the bottom of the keypad.

2Insert the supplied batteries, making sure that the positive (+) and negative (-)ends of each battery match the polarity indicators inside the battery housing.

3Turn on the keypad by sliding the Power switch on the right side of the keypad to the “on” position.

4

Targus Wireless Keypad & Mini Optical Mouse

Connecting the Receiver

To connect the receiver:

1Plug the USB receiver into an available USB port on your computer.

2Follow any on-screeninstructions to complete the default driver installation.

The “Lock LED” light turns on.

You are now ready to set the identification code to establish a communication link with the receiver.

Setting the Identification Code

After your computer detects the USB receiver and the driver software is installed, you must set the ID code between the receiver and the mouse as well as between the receiver and the keypad BEFORE you can use them. To do this, do the following:

NOTE: Make sure that your computer is turned on and has detected the USB receiver before you set the ID code.

5

Targus Wireless Keypad & Mini Optical Mouse

Optical Mouse

1Press and release the setup key on the receiver. The Lock LED light turns off.

2Press the setup key on the bottom of the mouse.

When the LED on the receiver is lit, the mouse is set up with an ID and the receiver is locked.

You are now ready to use the mouse.

Wireless Keypad

1Press and release the setup key on the receiver again.

2Press the setup key on the keypad.

When the light emitter diode (LED) on the receiver is lit, the keypad is set up with an ID and the receiver is locked.

You are now ready to use the keypad.

6

Targus Wireless Keypad & Mini Optical Mouse

Using the Keypad

Activate Num Lock (LED illuminated)

Definition of the keys:

Num

/

*

Bk Sp

Lock

 

 

 

7

8

9

-

 

 

 

 

4

5

6

+

 

 

 

 

1

2

3

 

 

 

 

Enter

0

00

.

 

 

 

 

 

Deactivate Num Lock

Definition of the keys:

Num

/

*

Bk Sp

Lock

 

 

 

Home

 

PgUp

-

 

 

 

 

 

 

 

+

 

 

 

 

End

 

PgDn

 

 

 

 

Enter

Ins

 

Del

 

 

 

 

 

 

Power Management

To power the keypad and mouse on and off, slide the on/off switch to the desired position.

When power is on, the mouse goes into “power saving mode” after 4 minutes of inactivity. To activate the mouse, move the mouse or press any button.

7

Targus Wireless Keypad & Mini Optical Mouse

To save battery power, turn off the keypad and mouse while traveling or when you’re not using them.

CAUTION: Removing the batteries will require you to reset the ID code.

Operating Hints

For optimal performance and RF reception:

Place the receiver at least 8 inches (20 cm) away from all electrical devices, such as your monitor, speakers or external storage devices.

If necessary, use the supplied extension cable to keep the receiver away from the computer. Plug the receiver into the extension cable, and the extension cable to the computer.

Avoid using the optical mouse on a metal surface. Metals, such as iron, aluminum or copper, shield the radio frequency transmission and may slow down the mouse’s response time or cause the mouse to fail temporarily.

The mouse will enter a suspend mode at the same time your computer does. To activate the mouse, press any of the buttons.

If your computer has a metal case that contains aluminum or magnesium, use the optical mouse to the side. The display panel may interfere with the radio frequency signal if you use the mouse directly in front of the computer.

Never use the optical mouse on a glass or mirrored surface as these surfaces will cause the mouse to fail temporarily.

To maximize battery life, use the optical mouse on a white, or light colored surface. Dark surfaces cause the mouse’s

8

Targus Wireless Keypad & Mini Optical Mouse

LED to glow brighter, which causes the battery to discharge more rapidly.

Comfortable Usage

Research suggests that physical discomfort and injury to nerves, tendons, and muscles may be related to repetitive motion, an improperly set up work area, incorrect body posture, and poor work habits.

To reduce the risk of injury, follow these precautions:

Stand, stretch, and move around several times every hour.

Switch hands while performing tasks. Use shortcut keys to avoid repetitive or awkward mouse movements.

Relax your shoulders and keep your elbows at your sides. Adjust the keyboard’s position so that you don’t have to stretch to reach it.

Adjust your position so that you don’t have to bend your wrists to type; avoid placing your wrists on a sharp edge.

If you feel discomfort or numbness in your hands, wrists, arms, shoulders, neck, or back while typing, consult a qualified medical professional.

Things to Remember

Batteries

General

You must reset the ID code every time you change the batteries.

To extend the life of your batteries, turn off the mouse and keypad while not in use and during travel.

9

Targus Wireless Keypad & Mini Optical Mouse

Power Saving Mode

The mouse’s power saving mode feature activates after 4 minutes of non-operation.To activate the mouse, move the mouse or press any button.

Specifications

ID Selections

4096

 

Operation Frequency

27 MHz

 

Operating Voltage

Keypad:

3V

 

Mouse:

3.3V

 

Receiver:

5V (powered by the USB port)

Operating Current

Keypad:

Below 20mA

 

Mouse:

Below 55mA

 

Receiver: Below 25mA

Dimensions

Keypad:

 

 

4.59 x 2.97 x 1. inches

 

(122 x 74 x 25 mm)

 

Mouse:

 

 

3.25 x 1.88 x 1.13 inches

 

(82 x 47 x 31 mm)

 

Receiver:

 

 

2.75 x 0.86 x 0.71 inches

 

(70 x 22 x 18 mm)

Weight

Keypad (without batteries): 3.35 oz (95 g)

 

Mouse (without batteries): 2.4 oz (68 g)

 

Receiver:0.6 ounces (17 g)

10