Sony D-T405 User Manual

0 (0)

3-860-096-22 (1)

FM/AM

Compact Disc

Compact Player

Operating Instructions

About area code

The area code of the Discman you purchased is shown on upper left of the bar code label on the package.

For accessories supplied with your Discman, check the area code of your model and refer to “Supplied accessories” toward the end of this manual.

D-T405

Sony Corporation ã1997 Printed in Malaysia

Welcome!

Thank you for purchasing the Sony FM/AM Compact Disc Compact Player. Before operating your Discman, please read this manual and retain it for future reference.

Owner’s Record

The model and the serial numbers are located at the bottom. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product.

Model No. D-T405 Serial No. _____________

WARNING

To prevent fire or shock hazard, do not expose the unit to rain or moisture.

To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.

CAUTION

The use of optical instruments with this product will increase eye hazard.

INFORMATION

For the customers in the USA

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV

technician for help.

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

For the customers in Australia

The supply cord of the AC power adaptor cannot be replaced; if the cord is damaged, the AC power adaptor should be discarded.

For the customers not in Poland

The mark on the unit is valid only for products marketed in Poland.

For the customers not in Europe

The CE mark on the unit is valid only for products marketed in the European Union.

For the customers not in Russia

The mark on the unit and package is valid only for products marketed in Russia.

Playing a CD right away!

If you want to play a CD right now, choose to use your Discman on house current. Other choices are the following three: rechargeable battery, dry batteries (see “Power Sources” on the reverse side) and car battery.

1 Connect

When using earphones

AC power adaptor

to a wall outlet

Headphones or Earphones

PHONES/REMOTE

DC IN 4.5 V

 

For the models supplied with the AC plug adaptor

If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.

For the models supplied with the remote control

Connect the microplug of the earphones to the remote control, not to the PHONES/ REMOTE jack of the Discman.

Connect the earphones to the remote control firmly. A loose connection may cause noise during playback.

For the customers in the USA

U2 model supplied with headphones does not come supplied with a remote control.

2 Place a CD

OPEN

Label

side

up

 

 

 

 

 

 

 

1Slide OPEN to open the lid.

2Fit the CD to the pivot.

3 Play

1Set the CD/RADIO switch to “CD (RADIO OFF).”

Setting of the CD/RADIO switch

2Press ^.

When listening to the CD

When listening to the radio (See “Radio operations” on the reverse side.)

3Adjust the volume

To stop play, press p.

D-T405.3-860-096-2X.E.U/CA2/E33/E92/AU

Sony D-T405 User Manual
(RMS play)

To

Press

 

 

Pause (main unit

^

only)

 

 

 

Resume play after

^

pause (main unit

 

only)

 

 

 

Find the beginning

=(=side of

of the current track

(on the remote

(AMS*)

control) once**

 

 

Find the beginning

=(=side of

of previous tracks

() repeatedly**

(AMS)

 

 

 

Find the beginning

+(+side of

of the next track

() once**

(AMS)

 

 

 

Find the beginning

+(+side of

of succeeding

() repeatedly**

tracks (AMS)

 

 

 

Go forward

Hold down

quickly

+(+side of

 

() **

 

 

Go backwards

Hold down

quickly

=(=side of

 

() **

 

 

*AMS = Automatic Music Sensor

**These operations are possible during both play and pause.

To remove the CD

Remove the CD while pressing the pivot.

Notes on controlling the volume with the remote control

Set the VOL (volume) control on the remote control to MAX. Then adjust the volume on the Discman to the level that you want to be the maximum volume of the remote control.

Notes on display

When you press ^or ((when RESUME is set to OFF), the total number of tracks in the CD and the total playing time appear for about 2 seconds.

During play, the track number and the elapsed playing time of the current track appear.

During pause, the elapsed playing time flashes in the display.

Between tracks, the time to the beginning of the next track will appear with the “–” indication.

Notes on handling CDs

To keep the CD clean, handle it by its edge. Do not touch the surface.

Do not stick paper or tape onto the CD.

Do not expose the CD to direct sunlight or heat sources such as hot air ducts. Do not leave the CD in a car parked under direct sunlight.

Not these ways

D-T405.3-860-096-2X.E.U/CA2/E33/E92/AU

zOther CD Operations

Playing tracks repeatedly

(Repeat Play)

You can play tracks repeatedly in normal, INTRO PGM, shuffle or RMS (Random Music Sensor) play modes. Repeat all the tracks or only one track.

PLAY

MODE

REPEAT/

ENTER

To repeat all the tracks

Press REPEAT/ENTER during play. The ” ” indication appears.

To cancel repeat play, press REPEAT/ENTER again.

To repeat a single track

1Press REPEAT/ENTER while the track you want to repeat is playing.

The ” ” indication appears.

2Press PLAY MODE repeatedly until “1” appears.

To repeat another track, press =or +.

To cancel repeat play, press REPEAT/ENTER again.

Playing tracks in random order (Shuffle Play)

You can play the tracks in a CD in random order.

PLAY

MODE

During play, press PLAY MODE repeatedly until “SHUF” appears.

The tracks play in random order.

To cancel shuffle play, press PLAY MODE repeatedly until the play mode indication disappears from the display.

Note

During shuffle play, you cannot return to previous tracks by pressing =.

Playing tracks in the order you want

You can program up to 22 tracks to play in any order you choose.

=/+

PLAY

 

MODE

^

REPEAT/

ENTER

1 During play, press PLAY MODE repeatedly until “RMS” flashes.

Playing only the tracks you want (INTRO PGM Play)

You can choose and play your favorite tracks by scanning through the beginning of each track in a CD.

+

PLAY

 

MODE

 

^

REPEAT/

ENTER

1 During play, press PLAY MODE repeatedly until “INTRO PGM” flashes.

Flashing

2 Press ^to start scanning .

The Discman plays about the first 15 seconds of each track and “INTRO PGM” flashes faster.

3 Press REPEAT/ENTER while the track you want is playing. To skip the track, press +or just wait for the next track.

After you have gone through the CD, “INTRO PGM” stops flashing and the tracks you have chosen play automatically.

To finish programming before going through the whole CD, press ^. The selected tracks will be played.

To cancel INTRO PGM play, press PLAY MODE repeatedly until the play mode indication disappears from the display.

Flashing

2 Press =or + to choose a track. The track number and the playing order appear.

Track number Flashing

Playing order

3 Press REPEAT/ENTER to program the track.

4 Repeat steps 2 and 3 to program the remaining tracks.

5 Press ^.

“RMS” stops flashing and the tracks you have chosen play in the order you specified.

To cancel RMS play, press PLAY MODE until “RMS” disappears.

To check the program

During programming:

Press REPEAT/ENTER before step 5. During RMS play:

Press PLAY MODE repeatedly until “RMS” flashes, then press REPEAT/ENTER.

Each time you press REPEAT/ENTER, the track number and the playing order appear in the order you specified.

Note

If you program another track after the 22nd track, the first track programed is cleared and the new track is programed instead.

Using other functions

To enjoy more powerful bass sound

You can enjoy a powerful bass-boosted sound.

˝

NORM MID MAX

Set MEGA BASS to the desired position.

Note

If the sound is distorted when emphasizing bass, turn down the volume.

To prevent sound from skipping (ESP)

The ESP (Electronic Shock Protection) function prevents the sound from skipping by using a buffer memory that stores music data for about 10 seconds. Use this function when listening in a car or during a walk.

ESP

Press ESP.

The ESP indication appears.

To release the ESP function, press ESP again.

Notes

Playing may stop when the Discman gets a strong shock even with the ESP function on.

You may hear a noise or sound skip when:

listening to a dirty or scratched CD,

listening to an audio test CD or,

the Discman receives continuous shock.

Sound may drop for a while if you press ESP during play.

When you use an optical digital connecting cord, the ESP function will be disabled.

To lock the buttons

You can lock your Discman against any accidental operations.

You can still operate the unit with the earphones with remote control.

HOLD

Slide HOLD in the direction of the arrow. When you press any button, “Hold” appears in the display and you cannot operate the unit.

To unlock, slide HOLD back.

To protect your hearing (AVLS)

The AVLS (Automatic Volume Limiter System) function keeps down the maximum volume to protect your ears.

NORM LIMIT

AVLS

(AUTO VOLUME LIMITER SYSTEM)

(rear)

Set AVLS to LIMIT.

The AVLS indication appears.

Note

If the sound is distorted when you listen to the bass-boosted sound with the AVLS function, turn down the volume.

Loading...
+ 4 hidden pages