How to Connect a Sharp Projector to a Network
Quick Reference Guide
Applicable Models: |
XG-V10WU |
XG-V10XU |
B.) Set IP Address |
|
XG-V10WM |
XG-V10XM |
|
|
|
|
NOTE: IP Address is Static - verify with |
Quick Reference Guide Sections: |
|
IT / MIS Department. |
1.) AN-L10T Installation
2.) Projector Configuration
3.) S.A.P.S. Configuration
1.) Install Lan Card into expansion slot on A/V connector side of the projector
Refer to Operation Manual - page 5
C.) Set Gateway
Refer to O/M page numbers 2 - 3 for details
2.) Configure Projector Menu
There are (4) four items to configure on the projector menu.
A.) Set ID Number |
Must be |
Refer to Operation Manual - page 6 |
B.) Set IP Address |
obtained from |
|
C.) Set Gateway |
IT / MIS |
|
D.) Set Subnet Mask |
Department |
|
A.) Set ID Number |
|
D.) Set Subnet Mask |
Refer to Operation Manual - page 7
Refer to Operation Manual - page 4
|
|
3:18 PM |
L:\tekcentr\cactrain\qck_ref.xls |
1 |
10/12/2001 |