XE-A206 Quick Start Guide
English
The following describes how to get the cash register ready for operate. Follow these steps before you use the cash register for the first time.
Before you set up the cash register, prepare three new alkaline batteries LR6 ("AA" size) which are necessary for memory backup. Find a stable and flat surface not subject to direct radiation, to place the cash register.
1 Initializing the Cash Register
To ensure the cash register operates properly, please use the following procedure:
1.Make sure the power cord is unplugged and batteries are not installed on the register.
2.Insert the manager (MA) key into the mode switch and turn it to the REG position.
3.Insert the plug of the power cord into the AC outlet. The buzzer will sound three times.
IMPORTANT: This operation must be performed without batteries installed.
4.The cash register has now been initialized. The register display will show “0.00” with “
”.
MA
3 |
Installing the Paper Roll |
|
(for receipt printing) |
|
REG |
OPX/Z |
MGR |
OFF |
X1/Z1 |
|
|
VOID |
X2/Z2 |
PGM |
|
If you want to use a paper roll for journal printing, please refer to GETTING STARTED section of the instruction manual.
1. Lift up the print roller release lever to unlock and open the print roller arm.
2. Set a paper roll in the paper roll cradle as illustrated right.
NOTE: When setting a new paper roll in the paper roll cradle, be sure to cut the paper end behind the taped (or pasted) point in advance.
Print roller arm
Print roller release lever
To the printer
Correct
To the printer
Incorrect
2 Installing the Batteries
1.Push the printer cover forward and detach it.
2.Open the battery compartment cover next to the paper roll cradle.
3.Install three new alkaline batteries LR6 (“AA” size) as shown at the right. (Batteries are not supplied with the cash register.) Make sure that positive (+) and negative (–) poles of each battery are properly oriented.
4.When the batteries are properly installed, “
” on the display will disappear. Close the battery compartment cover.
3.Feed the end of the paper along with the paper positioning guides as illustrated at the right.
Paper positioning guides
4.While holding down the paper, slowly close the push down the arm until you hear a click locking Make sure you securely push down the center of arm as illustrated at the right. The paper will be fed
5.Cut off the excess paper using the edge of the replace the printer cover. Press the Fkey to
end comes out of the printer cover and clean paper
NOTE: If the print roller arm is not securely locked, the unit will If this problem occurs, open the arm, and close the above.
Loading...