1/3" Colour CCD |
VCC-6975P |
Colour |
High-resolution Camera |
PAL |
|
|
||
|
|
|
Built in DSP (digital signal processing) circuit |
|
|
Intelligent digital motion detector |
|
|
x32 Electronic sensitivity (minimum illumination of 0.05 Lux) |
|
|
x8 Digital zoom with digital pan and tilt |
|
|
480 TV lines of horizontal resolution |
|
|
SSP compatible |
|
Accredited |
|
|
|
Dual power operation, 24V AC / 12V DC |
|
by the RvA |
ISO 9001 REGISTERED FIRM |
||
DNA Certification B. V., THE NETHERLANDS |
||
|
|
|
Horizontal |
TV Lines |
|
|
SF-1407MV |
1/3" Colour CCD
High-resolution Camera
VCC-6975P
Shown with optional lens
An all-new Intelligent Digital Motion Detector is built-in to detect moving objects in the picture and send an alarm
The intelligent Digital Motion Detector analyzes changes in picture brightness on the screen and uses the direction of motion and size of the object to identify moving objects. The system can be set to produce an external alarm signal and/or switch to a x2 digital zoomin display. Furthermore, the center of the zoom-in picture stays focussed on the moving object.
|
x2 zoom |
|
CAMERA 1 |
Display of monitor |
Display of monitor |
x2 zoom
CAMERA 1 |
Display of monitor |
Intelligent digital motion detector uses size of object and direction of motion to identify moving objects.
Detection of a moving object prompts the camera to zoom in on the object (x2), and blinking camera ID is displayed on the monitor. An external alarm signal is also sent.
During the zoom-in display, the center of the picture travels and stays focussed on the object. Duration of the zoom-in display is adjustable to
5, 10, 20, 30, and 60 seconds.
Reliable detection of moving objects
The intelligent Digital Motion Detector uses seven factors in analyzing changes in picture brightness to enable reliable motion detection and reduce false alarms.
1
Direction
It is possible to narrow the target to objects moving in certain directions only. This feature enables the system to detect people coming into a room while disregarding people going out. It is also possible to detect all moving objects without setting the direction.
DIRECTION |
CAMERA 1 |
Set the direction to “right”
2
Size
Freely set the size of target objects.
3
Masking
Freely establish the area where motion detection is turned off.
An area where motion detection is turned off
4
Magnitude of movement
Set the magnitude of movement to be detected.
5
Brightness
Set the lowest level of brightness to be analyzed. Use this feature to avoid influences of electric noises on the darker area of the screen.
Brightness
Not detection
Noise
Time
6
Magnitude of brightness shift
Set the magnitude of changes in brightness. This feature is used to disregard a sudden and huge change in brightness such as one caused by turning on/off the lights.
7
Duration
Set the time the system should continue monitoring before identifying a moving object. This feature enables the system to neglect high speed objects such as automobiles.
*The intelligent Digital Motion Detector function is not available when the electronic sensitivity is set to ON or when the electronic shutter is set to “long mode”.