RTS RT-2M User Manual

Size:
377.89 Kb
Download

RT-2M(90007891000) Quick Start Guide

INCLUDED PARTS:

 

 

 

 

 

 

 

RT-2MUnit

 

 

 

 

 

 

 

DB-9Cable

 

 

 

 

 

 

 

 

 

NOTE:

See the entire system diagram on reverse side.

 

 

 

RS-232Cable Pinout

Step 1. Cable the Trunk Supervisor/TrunkEdit PC to the

Step 2. Cable theRT-2Mto the Frame.

 

 

RT-2M.

 

To cable theRT-2Mto the Frame, do the following:

 

 

NOTE:

In Trunk Supervisor, you must designate

 

 

1. Using the appropriate connector defined below, connect the

 

 

 

the intercom and port number the RT-2M

 

 

 

 

RT-2M to the Frame:

 

 

 

sends the test signal over.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

To cable the Trunk Supervisor/TrunkEdit PC to the

 

CONNECTOR

 

CONNECTION

 

 

 

 

RJ-12

Plug pins 2 and5 into the Ch 1 input connector terminals.

 

 

 

RT-2M,do the following:

 

 

 

 

 

 

Plug pins 3 and4 into the Ch 1 output connector terminals.

 

 

 

1. Using the included cable, connect aCOM port on

 

DB-9

Plug pins 7 and8 into the Ch 1 input connector terminals

 

 

 

the Trunk Supervisor computer to the RS-232

 

 

Plug pins 4 and5 into the Ch 1output connector terminals.

 

 

 

Interface connector on the rear panel of theRT-2M.

2. Connect theother end of the connector to the trunking

 

 

 

 

 

 

 

 

 

connection port as defined in the Trunk Supervisor software.

 

 

 

 

 

 

 

 

 

LIT000306000 Rev. A

11/2008