Radio Shack 49-2515 User Manual

Size:
98.57 Kb
Download

315/+PEJ"$(9"+PFQQT11WVFQQT"%COGTC

www.radioshack.com

OWNER’S MANUAL —

 

49-2515

Please read before using this equipment.

 

 

 

 

Thank you for purchasing a RadioShack 1/3-

Built-inSpeaker and Microphone— allow

Passive Infrared (PIR) Sensor — detects

Inch B&W Indoor/Outdoor Camera. Your

2-waycommunication with compatible

motion up to 16.5 feet away from an angle of

camera is super-smalland compact. It is

equipment.

up to 100°.

designed for use with a RadioShack 10-Inch

CMOS (Complementary Metal-Oxide

Weatherproof — so you can mount the

B&W Single Channel Security Monitor (Cat.

Semiconductor) Sensor — provides

camera indoors or outdoors.

No. 49-2514)to provide a safe and secure

superior-resolutionB&W images.

 

environment.

 

 

 

%#/'4#"/1706+0)")7+&'.+0'5

Carefully plan where and how you will position the camera and where you will route the cable that connects the camera to the monitor. When planning the installation:

Select a location for the camera that provides a clear view of the area you want to monitor, is free from dust, and is not in direct sunlight or in line-of-sightof a strong light source .

• Do not install the camera in a location

±"016'"±"

Though the camera is highly sensitive, it cannot “see” over a wide area in total darkness. To assist the camera’s night vision, install a 100watt incandescent lamp (rich in infrared radiation) to illuminate the camera’s viewing area. You can also use a small incandescent flood lamp. Halogen lamps, other high pressure outdoor lamps, and fluorescent lighting are infrared-poorand not recommended.

where it will be exposed to high humidity or rain.

Plan the cable’s route so it is not close to power or telephone lines, transformers, microwave ovens, or other electrical equipment that could interfere with (or accept interference from) the system.

Select a location for the camera that has an ambient temperature between –4°F(–20°C)and 122°F (50°C).

If you plan to install the camera in a location that has conditions not recommended in this manual, consult with a professional installer and consider use of a separate camera cover or housing.

/1706+0)"#0&"+056#..+0)"6*'"%#/'4#

You can mount the camera indoors or

arm and sleeve together by tightening

2. Connect the 59-footcable to the

outdoors in a permanent location such as a

the screw.

monitor’s mini-DINport.

wall or on a movable platform (such as a

 

 

tripod) for mounting on a desk, shelf, or table.

 

 

1. Use the base of the camera as a guide, mark the locations for the screw holes on the mounting surface.

2. Drill a starter hole at each marked location. If necessary, drill a third hole (at least 14 mm in diameter) below the mounting holes to permit the camera’s cable to be inserted through the mounting surface.

3.If necessary, insert the supplied drywall anchors into the screw holes.

4.Insert one of the two supplied screws through each of the screw holes in the bracket and into the mounting surface, then tighten each screw until the base is secure.

5.Loosen the screw from the camera’s arm-sleeveand fully insert the base’s arm into the sleeve. Then secure the

5'66+0)"72"6*'" %#/'4#

%100'%6+0)"&+4'%6.;"61"6*'" /10+614

1.Connect the camera’s mini-DINplug into the supplied59-footcable’smini-DINsocket.

WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture.

CAUTION

RISK OF ELECTRIC

!

SHOCK

DO NOT OPEN

 

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NOUSER-SERVICEABLEPARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.

The lightning symbol is intended to alert you to the presence of uninsulated dangerous voltage within this product’s enclosure that might be of sufficient magnitude to constitute a

risk of electric shock. Do not open the product’s case.

The exclamation symbol is intended to inform you that important operat-

!ing and maintenance instructions are included in the literature accom-

panying this product.

#"+/2146#06"#

If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for

pertinent information.

 

 

 

 

Rý— Warning

# — Important

±— Note

.— Caution

° — Hint

© 2002 RadioShack Corporation.

All Rights Reserved.

RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.

75+0)"#18"+02765"14"#"59+6%*$1:

1. Connect the extension cable’s mini-DINplug into the supplied6-inchadapter cable’smini-DINsocket.

2.Connect the adapter cable’s yellow end to your TV’s video jack, and connect the white end to your TV’s audio jack.

3.Connect the adapter cable’s red power socket to the supplied DC adapter’s barrel plug.

4.Connect the DC adapter to a standard AC outlet.

%#4'

Keep the camera dry; if it gets wet, wipe it dry immediately. Use and store the camera only in normal temperature environments. Handle

the camera carefully; do not drop it. Keep the camera away from dust and dirt, and wipe it

with a damp cloth occasionally to keep it looking new.

5'48+%'"#0&"4'2#+4

If your camera is not performing as it should, take it to your local RadioShack store for assistance. Modifying or tampering with the

camera’s internal components can cause a malfunction and might invalidate its warranty.

52'%+(+%#6+105

Input Voltage ..................................

15 V DC

Lens Angle ..........

90° (viewing angle is 76° )

Video Output ...................

1.0 Vp-p,75 Ohm

Audio Output ..................................

1.2 Vp-p

Maximum Audio Output Power

(Speaker) ............................................

0.4 W

Audio Distortion ....................................

<1%

Audio Frequency

 

Response .........................

300 Hz to 5 KHz

Resolution ........

250,000 pixel, 330 TV lines

Minimum Illumination ..............

2 lux @ F2.0

Specifications are typical; individual units might

 

 

(without IR LED)

vary. Specifications are subject to change and

 

 

0 lux @ F2.0

improvement without notice.

 

 

(with IR LED)

 

Operating Temperature .............

4° to 122° F

 

 

 

(–20°to 50° C)

 

PIR Maximum Range ................

100° ×16.5ft

 

PIR Detection Angle (H/V) ..

Horizontal 100°

 

 

 

Vertical 45°

 

Dimensions ..........

21/16 × 35/16 × 13/4 inches

 

 

 

(52 × 84 × 45 mm)

 

Weight (with wire)

.................

5.8 oz (165 g)

 

2