Quantum Sun StorEdge L100 User Manual

Size:
4.52 Mb
Download

Appendix D

 

Regulatory Statements

D

FCC Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Any changes or modifications made to this equipment may void the user's authority to operate this equipment.

Operation of this equipment in a residential area may cause interference in which case the user at his own expense will be required to take whatever measures may be required to correct the interference.

Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

165

Appendix D Regulatory Statements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:

1 This device may not cause harmful interference, and

2This device must accept any interference received, including interference that may cause undesired operation.

Taiwan Statement

!" #$%&'()*+ ,-.

Industry Canada (Digital Apparatus)

Reference: Interference-CausingEquipment Standard, ICES-003,

Issue 2

This Class A digital apparatus meets all requirements of the

Canadian Interference-CausingEquipment Regulations.

166 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

CISPR-22

Warning!

Appendix D Regulatory Statements

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Notice for USA and CANADA Only

If shipped to USA, use the UL LISTED power cord specified below for 100-120V operation. If shipped to Canada, use the CSA CERTIFIED power cord specified below for100-120Voperation.

Plug Cap

Parallel blade with ground pin (NEMA 5-15P

 

configuration)

Cord

Type: SJT, three 16 AWG (1.5 mm2) or

 

18 AWG (1.0 mm2) wires

Length

Maximum 15 feet (4.5m)

Rating

Minimum 10 A, 125 V

Laser Statement

Class 1 Laser

Product

CAUTION: With all panels and enclosures in place, this product is rated as a Class I laser product. The bar code scanner inside this product, however, is a Class II laser. Avoid exposure to the laser light emitted from the bar code scanner. Do not stare into the beam.

CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous exposure.

Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

167

Appendix D Regulatory Statements

Library Battery Statement

Caution

This product contains a Lithium battery. The nonvolatile RAM,

 

Dallas Semiconductor DS1743-100,contains a Lithium battery.

 

Lithium may be considered a hazardous material. Dispose of this

 

battery in accordance with local, state, and federal laws.

MC300 Battery Statement

Caution

Danger of explosion if battery is incorrectly replaced.

 

Replace only with the same or equivalent type recommended by

 

the manufacturer. Dispose of used batteries according to the

 

manufacturer’s instructions.

168 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

Appendix D Regulatory Statements

Declaration of Conformity

Figure 60 Declaration

of Conformity, L25

Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

169

Appendix D Regulatory Statements

Figure 61 Declaration

of Conformity, L100

170 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

Glossary

B

C

F

G

H

back panel The panel at the back of the library that contains the power switch and connectors for attaching external cabling to the library.

bar code label The identification label on cartridges.

bar code scanner A laser device that is mounted on the robotic hand and reads the cartridge bar code labels.

calibration The software measurements and configuration required for successful operation of the library.

FCC Class A Standard established by the U.S. Federal Communications Commission governing electromagnetic emissions.

FSE Field service engineer

GUI Graphical user interface. The panel on the front of the L25 and L100 libraries that provides the user interface.

host computer The computer that issues SCSI commands to control the library robotics.

Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

171

Glossary

M

MTBF Mean Time Between Failures

 

MTTF Mean Time To Repair

 

NVRAM Nonvolatile random access memory

N

 

on-line Ready for communications with a host

O

 

pick The act of removing a cartridge from one location in

P

 

preparation for placing it in another location.

 

place The act of placing a cartridge in a location after it has been

 

picked from another location.

 

PROM Programmableread-onlymemory

 

RAM Random access memory

R

 

SCSI Small Computer System Interface. A communications

S

 

standard for attaching peripheral equipment to small computers.

 

tape drive The mechanism that reads data from, and writes data

T

 

to, a tape.

 

UL Underwriters Laboratories

U

172 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

Index

A

Auto-Cleanoption, turning on or off72

Auto-Importoption, turning on or off7475

B

Back panel 11

Bar code scanner, enabling or disabling 66

Barcode Scanner test, running 8788 Baud rate, setting67

C

Cartridge magazines, removing 3845

Cartridges handling 159160

importing and exporting 3137 inspecting for damage160163 moving2629

Cleaning a tape drive 7980 Confidence test9899 Configuration screen, accessing53

Configuration, library, changing 5375

Contrast, GUI, adjusting 8384

Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

173

Index

D

Date, setting 6869

Demonstration programs, running 97104

Diagnostic tests, running 8595 Barcode Scanner test8788 Display test95

Move Location test 9295 Move Medium test8992

Diagnostics Menu screen accessing 85

Display test 95 Drive

cleaning 7980 information, viewing22 power, turning on or off

using Quick View Menu screen 2426

using the Maintenance screen 8183

serialization, turning on or off 62 statistics, viewing48

E

Emulation, setting 59

Exporting tape cartridges 3137

F

Fault symptom codes see FSCs

Front panel 5 FSCs111158

G

GUI

contrast, adjusting 8384 overview1419

I

Ignore Host Lock option, turning on or off 73

Illumination, turning on or off 64 Import/Export option, setting6971 Importing tape cartridges3137 Information, viewing

drive 22 inventory23 library2021

Inventory information, viewing 23

L

Library

configuration, changing 5375 features512

back panel 11 front panel5

information, viewing 2021 statistics, viewing47

174 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

M

Magazines, removing 3845 Maintenance screen, accessing77 Manual access port (MAP)70 Move Location test, running9295 Move Medium test, running8992

O

Off-linetime, setting65

Index

T

Tape cartridges handling 159160

importing and exporting 3137 inspecting for damage160163 moving2629

Tape drive, cleaning 7980 Terminator power

turning on or off 58 Time, setting6768

W

Q

Wide negotiation, turning on or off 61

Quick View Menu screen 1926

S

SCSI history, viewing 49 SCSI IDs, setting

library 55

tape drive 5657 Serialization, turning on or off62

Short Labels option, turning on or off 63

Statistics, library, viewing 4550 Sync negotiation, turning on or off60

Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide

175

Index

176 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide