Savi® W710-M/W720-M
Multi Device Wireless Headset System
User Guide
TM
Welcome |
4 |
|
|
|
|
|
|
System Requirements |
4 |
|
|
|
|||
What's in the Box |
5 |
|
|
|
|
|
|
Base and Headset Basics |
6 |
|
|
|
|||
Accessories |
7 |
|
|
|
|
|
|
Customize Your Headset |
8 |
|
|
|
|||
Adjust the Headband |
8 |
|
|
|
|||
Adjust the Mouthpiece |
8 |
|
|
|
|||
Charge Your Headset |
10 |
|
|
|
|
||
Desk Phone: Connect and Call |
11 |
|
|
||||
Choose Desk Phone Setup |
11 |
|
|
||||
Make a Desk Phone Call |
12 |
|
|
||||
Mobile: Connect and Call |
13 |
|
|
|
|||
Computer: Connect and Call |
14 |
|
|
||||
Connect Your Computer |
|
14 |
|
|
|||
Place a Softphone Call |
14 |
|
|
||||
Position Your Base |
14 |
|
|
|
|
||
Headset Features |
15 |
|
|
|
|
|
|
Headset Controls 15 |
|
|
|
|
|||
Headset Power |
15 |
|
|
|
|
|
|
Headset Battery Level |
16 |
|
|
|
|||
Mute your Headset During a Call |
16 |
||||||
Adjust Your Headset Volume |
16 |
|
|||||
Turn On/Off Headset LED |
17 |
|
|
||||
Out of Range Warning Tones |
17 |
|
|||||
Base Features 18 |
|
|
|
|
|
|
|
Base Buttons |
18 |
|
|
|
|
|
|
Base Subscription Button |
18 |
|
|
||||
Set the Range |
19 |
|
|
|
|
|
|
Bluetooth Pairing Button |
19 |
|
|
||||
Daily Use |
21 |
|
|
|
|
|
|
Incoming Calls |
21 |
|
|
|
|
|
|
Outgoing Calls |
21 |
|
|
|
|
|
|
Multi-Phone Status |
23 |
|
|
|
|||
Mobile Phone and Headset Audio |
23 |
Combine Audio From Any Two Lines or Channels 23
Conference Up to Three Additional Headsets 23
Advanced Use |
25 |
|
|
Install Plantronics Software |
25 |
||
Plantronics Control panel |
25 |
|
|
Devices Tab |
25 |
|
|
Device Settings > Base Tab |
26 |
|
|
Device Settings > Headset Tab |
28 |
||
Device Settings > Security Tab |
29 |
||
Applications Tab 29 |
|
|
|
Preferences |
29 |
|
|
2
About Tab |
30 |
|
Plantronics Update Manager 30 |
||
Troubleshooting |
32 |
|
Headset |
32 |
|
Desk Phone |
33 |
|
Mobile |
33 |
|
Softphone |
33 |
3
Congratulations on purchasing your new Plantronics product. This guide contains instructions for setting up and using your Savi W710-M/W720-M
Please refer to the safety instructions in the quick start guide for important product safety information prior to installation or use of the product.
Computer
•Supported Operating Systems: Windows® 7, Windows® 8, Windows XP®, Windows Vista®
•Processor: 400 MHz Pentium® processor or equivalent (Minimum); 1 GHz Pentium processor or equivalent (Recommended)
•RAM: 96 MB (Minimum); 256 MB (Recommended)
•Hard Disk: 280 MB (Minimum); 500 MB or more (Recommended)
•Microsoft Windows XP-Service Pack 3 (SP3) or later (Recommended) Microsoft Windows VistaService Pack 1 (SP1) or later (Recommended)
Display
•At least 800 x 600, 256 colors
•1024 x 768 high color, 32-bit (Recommended)
Browser
•Internet Explorer® V6 or better must be on the user’s system (Required)
4
WH300 headset (monaural) |
WH350 headset (binaural) |
Base and charge cradle
USB cable |
Telephone interface cable |
Power supply |
5
Base
1 |
Power jack |
8 |
Computer button |
2 |
Handset lIfter jack |
9 |
Mobile phone button |
3 |
Telephone interface cable jack |
10 |
Desk phone button |
4 |
USB port |
11 |
Bluetooth pairing button/LED |
5 |
Desk phone speaking volume |
12 |
Subscription button/LED |
6 |
Desk phone configuration switch |
13 |
Charging LED |
7 |
Desk phone listening volume |
|
|
Headset
1 |
Headset LED |
4 |
Mute button |
2 |
Volume up button |
5 |
Volume down button |
3 |
Call control button |
6 |
Microphone |
6
1Electronic hookswitch cable (EHS cable) Electronically and automatically takes your desk phone handset off hook. Enables remote call control with your headset.
2HL10 lifter Automatically lifts handset and returns it to the cradle. Enables remote call control with your headset.
7
Optimize the comfort and fit of your headset.
2 On the WH300, position the stabilizer T-bar above your ear.
3 For a tighter fit, gently pull the opposite ends of the headset inward as shown.
2Position the click-stop turret and boom so that the microphone is two finger-widths from the corner of your mouth.
8
3Make sure the front of the microphone faces your mouth. If necessary, twist the microphone slightly so it’s in the proper position. Do not use forceful twisting motions or try to turn the microphone completely around.
9
1Align the charging cradle pins with the base and press firmly until the cradle rests evenly on the base.
2Plug one end of power supply into power jack on back of the base and other end into working power outlet.
3Place the headset in the charge cradle. The charging LED will flash green when charging the headset and turn solid green when the headset is fully charged. Charge for at least 20 minutes prior to the first use. A full charge takes 3 hours.
NOTE This product has a replaceable battery. Use only the battery type supplied by Plantronics.
10
Choose Desk Phone
Setup
Choose a desk phone setup A, B or C and connect cables.
A Desk phone (standard)
USE
•Connect one end of the telephone interface cable to the back of the base
•Disconnect the handset coil cord from the base of the desk phone and re-connect it to the telephone interface cable junction box.
•Finally connect the remaining end of the telephone interface cable into the open handset port on the desk phone.
NOTE If your phone has a built-in headset port, you should only use the headset port if you will not be using the HL10 lifter. In this configuration, you must press both the headset button on your phone and the call control button on the headset to answer or end calls.
BDesk phone + HL10 lifter (sold separately)
See the user guide at plantronics.com/accessories for details.
USE
CDesk phone + EHS cable (sold separately)
See the user guide at plantronics.com/accessories for details.
USE
11