LEARN MORE
ML10 and ML12
Bluetooth® Headset
TAKE A GOOD LOOK
CALL BUTTON
•Take a call or end it (1 tap)
•Redial (2 taps)
•Initiate phone’s voice-dialing
(2 second press until tone is heard)
• Reconnect lost Bluetooth connection
(1 tap if the headset doesn’t automatically reconnect)
•Activate pairing mode after initial set up (press until LED flashes red/blue)
•Cancel missed call LED (1 tap)
POWER SWITCH
•On (slide to reveal black)
•Off (slide to reveal red)
MICRO USB CHARGING PORT
•Use with the AC charger:
1 hour before first use
2 hours (for full charge)
•Do not use headset while charging
VOLUME BUTTONS
•Volume: up/down (tap + or – buttons per level change)
LED
•Charging (solid red)
•Low battery (3 red flashes at powering on)
•On a call (blue flash every 2 seconds)
•Missed call (purple flashes. Repeats for 5 minutes or until cancelled.)
•Pairing mode (repeating red/blue flashes)
Be safe! Please read the safety guide for important safety, charging, battery and regulatory information before using your new headset.
2
CONNECT TO YOUR PHONE
“Pairing” is the set-up process of introducing your headset to your phone.
Before using your headset for the first time, you must pair it with your Bluetoothenabled phone.
Pairing is a one-time process unless your phone loses the connection or you want to pair a new phone.
1. READY
Activate the Bluetooth feature on your phone, then get phone to add/search/discover new Bluetooth devices.
Phones have different menus to select from:
iPhone: Settings > General > Bluetooth > On
(starts the search for devices)
BlackBerry® smartphone:
Settings/options > Bluetooth: On > Search for devices
2. SET
First time, right out of the box:
With headset turned off, activate Bluetooth pairing mode by sliding Power switch on. The LED flashes red/blue to indicate pairing mode.
Pairing new phone/ reconnecting original:
With headset turned off, slide Power switch on. Press and hold the Call button until the LED flashes red/blue.
3. CONNECT
Select “PLT_MLXX” from the list of Bluetooth devices shown on your phone.
If phone asks for a passcode, enter four zeros (0000). You may see **** on screen. Some phones also ask to confirm headset connection after pairing.
Headset LED will stop flashing red/blue once your phone and headset are successfully paired/ connected.
You can now make a call using your phone’s keypad or voicedialing feature.
3