CS50-USB & CS60-USB DECT™ WIRELESS HEADSET SYSTEM
User Guide
DIAGRAMS
HEADSET
FIG.1
|
4 |
|
5 |
|
|
|
|
2 |
|
|
|
|
|
|
3 |
7 |
6 |
|
1 |
BASE UNIT |
|
|
POWER SUPPLY |
FIG.2 |
|
17 |
FIG.2.1 |
|
|
|
8
16 |
14 |
|
15 |
FIG.3 |
13 |
12 |
|
11
10
18
9
1
DIAGRAMS
EARLOOP
FIG.3.1
HEADBAND Available as an accessory.
FIG.3.2
2
DIAGRAMS
NECKBAND Available only as an accessory.
FIG.3.3
3
DIAGRAMS
LISTEN VOLUME ADJUST |
MUTE FEATURE |
FIG.4.1 |
FIG.4.2 |
INSTALLING A REPLACEMENT BATTERY
FIG.5
4
WELCOME
CS50-USB/CS60-USB
Wireless Headset
System User Guide.
Thank you for selecting the CS50-
USB/CS60-USB Wireless Headset
System from Plantronics.
The CS50-USB/CS60-USB offers wireless, hands-free headset convenience and long range workspace mobility.
This user guide provides instructions on the installation and usage of your system.
For safety and regulatory information, please refer to the separate "Important Safety Information" booklet. Detailed technical information and a copy of the Declaration
of Conformity can be found at www.plantronics.com/ documentation
www.plantronics.com
5
USAGE INSTRUCTIONS
DIAGRAM KEY
HEADSET |
DESK CHARGER |
||
1 |
Microphone |
8 |
AC Power Adapter |
2 |
Speaker |
9 |
AC Power Adapter Port |
3 |
Talk Button |
10 |
Headset Docking Cradle |
4 |
Volume/Mute Control |
11 |
Charge Contacts |
5 |
On-line Indicator |
12 |
Status Indicator |
6 |
Charge Contacts |
13 |
Charge Indicator |
7 |
Battery Door |
14 |
Stand |
|
|
15 |
Stand Pegs |
|
|
16 |
Ringer Switch On/Off |
|
|
17 |
USB Connector |
|
|
18 |
Subscription button access hole |
|
|
|
(paperclip required) |
1. GETTING STARTED
To use your Plantronics CS50-USB/CS60-USB Headset System, please follow these simple steps:
1.Install the hardware.
2.Install the software.
3.Charge your headset battery.
4.Choose your headset wearing style.
5.Carry out the initial set-up
INSTALLING THE CS50-USB/CS60-USB BASE UNIT
To install the base-unit, attach the stand by inserting the Stand Pegs into the locating holes on the underside of the base unit. Connect to the USB connector shown in Fig. 2 on page 1 to a free USB port on your computer. A USB hub can be used but you should ensure it can supply sufficient power (250mA) to charge the headset. This will create the finished assembly (refer to Fig.3, page 1). Alternatively, the Velcro strips included can be used to attach the base unit to a PC monitor. The optional AC Power Adapter can be installed as shown in Fig. 2.1
6