4 Easy Steps
The fastest way to setup your CS55™ Headset System
Base Power
Adapter
HL10
Automatic
Handset Lifter*
CS55 Headset
with Earloop
CS55
Headset Base
*Not included in all configurations
CS55 Series SETUP GUIDE
CS55 PACKAGE CONTENTS
4 Easy Steps |
The fastest way to setup your |
CS55 Headset System |
Setup Guide
Headset
Headset Base with Preinstalled Phone Cable
Base Power Adapter |
Headband |
Ear Loops |
Please refer to the separate Safety Instructions for important product safety information prior to installation or use of the product.
CS55 With Automatic Handset Lifter* Adds:
HL10 Automatic |
HL10 |
|
User Guide |
||
Handset Lifter |
||
|
*Automatic Handset Lifter is bundled with certain CS55 configurations and also available separately.
HL10 Additional Parts Kit (if needed)
Extender |
Ringer |
Adapter for |
Arm |
Microphone |
Nortel i2004 |
|
|
Phones |
2Plantronics CS55 Setup Guide
STEP1&ATTACHADJUSTHEADBANDFIT |
OR EARLOOP TO HEADSET |
Snap the speaker of the headset into the retaining ring of the headband or one of the three ear loops provided. See below.
Speaker
Ear Loop |
Headset |
Headband
If you will be wearing the headband, adjust the band for the most comfortable fit. See 1 below.
2
1 1
For either wearing option, rotate the headset in the retaining ring until the microphone is pointed toward your mouth. See 2 above.
Questions? For fast, efficient Technical Support call: 800-544-4660 Ext. 5538 3
S T E P
2CONNECT BASE TO DESK PHONE
Use Configuration A if:
You will use the Automatic Handset Lifter or…
Your phone has NO built-in headset functionality (no Headset button).
Configuration A
1. Unplug the handset coil cord from the desk phone handset port [A], then plug it
into the GREEN labeled handset port [B] on the Headset Base.
A
Handset |
Handset |
Coil Cord |
|
Headset Base (bottom view)
A B
2. Plug the short BLACK Phone Cable that
is pre-installed on the Headset Base into the now-open handset port [A] on the desk phone.
4Plantronics CS55 Setup Guide
Use Configuration B if:
You will NOT use the Automatic Handset Lifter and…
Your phone has built-in headset functionality (a Headset button).
Configuration B
Confirm there is
a “HEADSET” button on your phone
Headset Base (bottom view)
C
1. Plug the short BLACK Phone Cable that is pre-installed on the Headset Base into the Headset port [C] on
the desk phone.
HANDSET port or HEADSET port?
You should only use the headset port if you will NOT be using the Automatic Handset Lifter AND you have a pre-programmed Headset button on your phone.
In this configuration you MUST press both the Headset button on your phone and the Call Control Button on the headset to answer/end calls.
Questions? For fast, efficient Technical Support call: 800-544-4660 Ext. 5538 5