Plantronics 50-0230B-002, 50-0230B-004, 50-0230B-003 User Manual

0 (0)

KEMCO

INSTALLATION INSTRUCTIONS

FOR

50-0230B-002

50-0230B-003

50-0230B-004

SUBURBAN

Overhead console with flip down TV

These instructions are intended for use only by experienced professionals in the automotive customizing business. Special tools and equipment, as well as specialized handling and care

of product during installation, may be required. Before beginning this installation, carefully read through the following instructions. Use extreme care when cutting headliner material.

Check for wiring or other componentry above headliner material. Cut only where indicated.

Materials/ Tools required for this installation:

 

 

1.

#2 Phillips screwdriver

2.

Powered screwdriver or drill with adapter

3.

T-15 TORX bit driver

4.

Razor knife or similar

5.

T-45 TORX bit driver

6.

1/4” hex socket bit

7. Awl or similar tool

8.

3/32” Drill bit

9. Audiovox Series 645/655 Video Module

 

 

 

May 26, 1999

INSTALLATION INSTRUCTION # 44-0022B

 

Printed in the U.S.A.

MATERIALS PROVIDED FOR INSTALLATION:

ITEM

Description

QTY

1

SCREW, # 8 X 3/4" HWH

4

2

SCREW, # 6 X 1/2" PPH

4

3

SCREW, # 6 X 3/8" PPH

4

4

SCREW, # 8 X 2 1/2" PFH

3

5

SCREW, #8 X 1 1/4" PWH

2

6

MOUNTING BRACKET

1

7

CONSOLE

1

8

LIGHT

2

9

LIGHT TRIM

2

10

PLYWOOD, 3/8" X 6" X 14"

1

11

SCREW, 6-32 X 3/4" PPH

6

12

WASHER, 3.5 mm

4

INSTALLATION INSTRUCTION # 44-0022B

2

May 26, 1999

Printed in the U.S.A

Plantronics 50-0230B-002, 50-0230B-004, 50-0230B-003 User Manual

I.PREPARATION OF VEHICLE INTERIOR

1.Remove the O.E.M. console mounted to inner roof of vehicle. Remove and discard (1) one screw from recess in front of console near rear view mirror. Disconnect wire harness and

remove console from vehicle. Use care not to damage A/C control head. See Figure 1.

FIGURE 1

2. Remove A/C control head from cloth covered trim ring on O.E M. console by depressing (4) four tabs on back of control assembly.

See Figure 2. Discard cloth covered trim ring.

FIGURE 3

3

FIGURE 2

3.Remove and discard O.E.M. dome light by removing center cover and (2) two screws. Disconnect wire harness. See Figure 3.

4.Carefully remove and retain bezel from rear A/C control head and lay it in a safe place. See Fig. 3.

5.Remove and retain rear A/C control head and lay it in a safe place. See Figure 3.

Loading...
+ 5 hidden pages