®
3500 Pelco Way
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel +1 (559) 292-1981
FAX +1 (559) 348-1120
www.pelco.com
C2413M (11/99)
E700 Series
Sun Visor/Shroud
DESCRIPTION
The E700 Series Sun Shroud provides air space between the shroud and enclosure to protect from the direct rays of the sun. The sun shroud reduces internal air temperature approximately 10° to 15°F (6° to 10°C).
The E700 Series Sun Visor shields the viewing window from direct sunlight.
Models
E706S |
Sun shroud for E706-24 Enclosure |
E706SS |
Sun shroud for E706-24S Enclosure, stainless steel |
E706V |
Sun visor for E706-16/E706-24 Enclosure |
E706VS |
Sun visor for E706-16/E706-24S Enclosure, stainless steel |
E708S |
Sun shroud for E708-24 Enclosure |
E708SS |
Sun shroud for E708-24S Enclosure, stainless steel |
E708V |
Sun visor for E708-24 Enclosure |
E708VS |
Sun visor for E708-24S/24PS Enclosure, stainless steel |
E716S |
Sun shroud for E706-16 Enclosure |
E716SS |
Sun shroud for E706-16S Enclosure, stainless steel |
INSTALLATION
Sun Visor
To install the sun visor, perform the following steps:
1.Remove the end cap from the front of the enclosure and detach the safety wire from the end cap (see Figure 1).
2.Attach the sun visor to the end cap with the three 4-40 x .250 machine screws and lock washers provided, making certain that the safety wire is reattached to the end cap.
3.Replace the end cap.
4.Insert the spring clip fasteners in the holes provided on each side of the sun visor and lock securely.
Sun Shroud
To install the sun shroud, perform the following steps:
1.Insert the mounting straps through the holes inside the roof of the sun shroud (see Figure 1).
2.Align the sun shroud so that the cutouts allow access to the enclosure’s latches.
3.Fasten the mounting straps securely around enclosure.