Installation and Assembly - Articulating Swivel Arm for |
Models: PLA 60, PLA 60-S, |
37" - 60" Plasma Screens |
PLAV 60, PLAV 60-S |
|
|
R
This product is UL Listed. It must be installed by a qualified professional installer.
Maximum UL Load Capacity: 175 lb (79 kg)
3215 W. North Ave. • Melrose Park, IL 60160 • (800) 729-0307 or (708) 865-8870 • Fax: (708) 865-2941 • www.peerlessmoun ts.com
ISSUED: 05-02-06 SHEET #: 202-9112-3 12-05-06
Read instruction sheet before you start installation and assembly.
WARNING
•Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless customer care at 1-800-729-0307.
•This product should only be installed by a qualified professional.
•Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
•Never exceed the Maximum UL Load Capacity of 175 lb (79 kg).
•Do not attach directly to a metal stud wall. Use of a triple stud WSP wall plate is required for attachment to metal studs (contact customer care). Metal stud installation is not UL evaluated.
•If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an "edge to edge" stud finder is highly recommended.
•Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•Tighten screws and nuts firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power.
|
|
|
|
|
|
IMPORTANT! |
Certain types of walls require additional mounting hardware... |
|
|
|
|
|
|
|
|
WALL CONSTRUCTION |
ADDITIONAL HARDWARE REQUIRED |
|
|
|
Wood Stud, Wood Beam |
none |
|
|
|
Concrete |
none |
|
|
|
Metal stud |
WSP716, WSP716-S, WSP724, or WSP724-S |
|
|
|
Other or unsure? |
Contact Customer Care |
|
|
|
|
|
|
|
|
|
|
|
|
IMPORTANT! Turn to the appropriate page for your wall installation.
Installations: |
|
To Wood Stud Walls ...................................................................................................... |
page 4 |
To Concrete Walls .......................................................................................................... |
page 5 |
Tools Needed for Assembly
•stud finder ("edge to edge" stud finder is recommended)
•drill
•7/32" drill bit for wood studs
•5/16" masonry drill bit for concrete
•7/16" socket wrench with extension (recommended)
•level
•phillips screwdriver
Accessories
•External Wall Plate (WSP716, WSP716-S, WSP724, WSP724-S) (Metal Stud not evaluated by UL)
2 of 9 |
ISSUED: 05-02-06 SHEET #: 202-9112-2 06-21-06 |
Parts List |
Before you start make sure all parts |
|
|
|
|||
listed are included with your product. |
|
|
|
||||
|
|
|
|
PLA 60 |
PLA 60-S |
PLAV 60 |
PLAV 60-S |
DESCRIPTION |
|
QTY. PART # |
PART # |
PART # |
PART # |
||
A wall plate |
|
1 |
201-1040 |
201-4040 |
201-1040 |
201-4040 |
|
B tilt-roll assembly |
|
1 |
201-1093 |
201-4093 |
201-1048 |
201-4048 |
|
C arm assembly |
|
1 |
201-1072 |
201-4072 |
201-1049 |
201-4049 |
|
D wall support arm axle |
1 |
201-1041 |
201-1041 |
201-1041 |
201-1041 |
||
E vinyl trim |
|
3 |
600-1012 |
600-1012 |
600-1012 |
600-1012 |
|
F |
M10 x 1.5 x 15 mm screw bolt |
8 |
520-9262 |
520-9262 |
520-9262 |
520-9262 |
|
G |
.505 x .75 x .062" nylon washer |
1 |
540-1074 |
540-1074 |
540-1074 |
540-1074 |
|
H tilt adjustment knob |
1 |
560-0108 |
560-0108 |
560-0108 |
560-0108 |
||
I |
carriage bolt 3/8"-16 x 3.25" |
1 |
520-1315 |
520-1315 |
520-1315 |
520-1315 |
|
J |
1.525 x 2 x .062" delrin washer |
2 |
540-1070 |
540-1070 |
540-1070 |
540-1070 |
|
K |
#8-32 x .375" socket head cap screw |
1 |
520-1210 |
520-1210 |
520-1210 |
520-1210 |
|
L |
plastic finishing cap |
8 |
590-1123 |
590-1123 |
590-1123 |
590-1123 |
|
M holding pin |
|
1 |
580-1166 |
580-1166 |
580-1166 |
580-1166 |
|
N retainer plug |
|
1 |
590-1007 |
590-1007 |
590-1007 |
590-1007 |
|
O 5/16 x 3" wood screw |
8 |
520-1243 |
520-1243 |
520-1243 |
520-1243 |
||
P |
.250 x 1 x .068" washer |
8 |
540-1063 |
540-1063 |
540-1063 |
540-1063 |
|
Q 9/64" allen wrench |
|
1 |
560-9728 |
560-9728 |
560-9728 |
560-9728 |
|
R cable management clips |
4 |
590-1166 |
590-1166 |
590-1166 |
590-1166 |
||
S cable tie |
|
4 |
590-1168 |
590-1168 |
590-1168 |
590-1168 |
|
T |
36" polyester mesh sleeve |
1 |
600-1015 |
600-1015 |
600-1015 |
600-1015 |
|
U |
6 mm allen wrench |
|
1 |
560-9716 |
560-9716 |
560-9716 |
560-9716 |
V |
10 mm allen wrench |
1 |
n/a |
n/a |
560-9727 |
560-9727 |
|
W anchor |
|
8 |
590-1025 |
590-1025 |
590-1025 |
590-1025 |
DM
E
F
G
H
K
N
L
A C J P R
B T
W I V U
O Q
S
Some parts may appear slightly different than illustrated.
3 of 9 |
ISSUED: 05-02-06 SHEET #: 202-9112-3 12-05-06 |